English dropdown-ico

Manual Casio EC-BAND

23 pages 1.05 mb
Download

Go to site of 23

Summary
  • Casio EC-BAND - page 1

    A NA C OM, I NC. AnaSat ® SSPA Series Operating Manual Ku-Band SEKu-Band EC-Band SEC-Band ...

  • Casio EC-BAND - page 2

    You have just received an AnaSat ® SSPA (Solid-State Power Amplifier), a cost-effective product with no compromise on quality and reliability . This product should provide tireless performance in any reasonable operating environment. Note that this product is transmit only, and does not include a Block Down-Converter, which will have to be obtaine ...

  • Casio EC-BAND - page 3

    3000 Tasman Drive, Santa Clara, CA 95054 Tel: (408) 748 7800 Fax: (408) 748 7801 3133501 Operating Manual for the AnaSat ® -Series SSPA Table of Contents Table of Contents .................................................................................................................3 Introduction ................................................. ...

  • Casio EC-BAND - page 4

    3133501 Maintenance ....................................................................................................................... 18 Fan Replacement .................................................................................................................... 18 Alarm Relay Closure ................................................... ...

  • Casio EC-BAND - page 5

    3133501 AnaAat ® SSPA Quick Start Guide 1. Mount the SSPA on the antenna. 2. Connect the cables for RF input, and RF output (waveguide). 3. If needed, connect the M&C or PA MONI TOR to the driver or Protection Switch. 4. Connect AC power, nominal 120 or 240 VAC. There are no settings that need adjustment. The SSPA is factory set for a gain equ ...

  • Casio EC-BAND - page 6

    3133501 Introduction The AnaSat ® VSAT series of SSPAs are designed for continuous outdoor duty in all types of environments. Ideally suited for SCPC, MCPC, DAMA, and VoIP applications. Designed to interface with a 0 dBm driver, the AnaSat ® VSAT SSPA may be used in a wide variety of communication networks. The C-band members of the AnaSat ® SSP ...

  • Casio EC-BAND - page 7

    3133501 Typical Operating Parameters – AnaSat SSPAs EC/SEC-Band Ku/SEKu-Band 1 dB Compression Point 10W : 40 dBm 20W : 43 dBm 30W : 44.8 dBm 40W : 46 dBm 50W : 47 dBm 60W : 47.8 dBm 70W : 48.5 dBm 80W : 49 dBm 100W : 50 dBm 125W : 51 dBm 150W : 51.8 dBm 180W : 52.6 dBm 200W : 53 dBm 40 dB 43 dB 44.8 dB 46 dB 47 dB 47.8 dB 48.5 dB 49 dB 50 dB 51 d ...

  • Casio EC-BAND - page 8

    3133501 Installation R emoval of any cover may jeopardize the we ather seal, which may cause problems later. ! Unpacking Check to make sure that the SSPA has not suffere d any damage in shipm ent. Compare contents of the crate to ensure items received match those listed on the packing slip. Retain all shipping containers for future use. Tools and T ...

  • Casio EC-BAND - page 9

    3133501 Power Amplifier Be sure the SSPA TX OUT port is properly terminat ed prior to operation. Ensure all the correct waveguide gaskets are used to prevent water damage. TO ENSURE PROTECTION OF PERSONNEL AND EQUIPMENT, USE CARE DURING ANTENNA INSTALLATION AND WHENEVER WORKING ON OR AROUND THE SYSTEM. Site Considerations The installation requireme ...

  • Casio EC-BAND - page 10

    3133501 SSPA Mounting Considerations The AnaSat ® SSPA must be mounted such that: 1. Sufficient support is afforded the Block Up-Conve rter to minimize the effects of antenna sway in strong winds. 2. Air movement is possible across the heat sink fins. Ideally, the fins should be aligned vertically, but this is not required. NOTE: The length (and a ...

  • Casio EC-BAND - page 11

    3133501 Figure 3a - Front and Side Views of Boom Mount ed SSPA ANA COM INC. Document Title 150 Knowles Dr. Los Size Date Sheet 1 of Rev ASSEMBLY DRAWING, SINGLE MO UNTING KI T 31626 3 FEB 2003 B 1 3 BOOM ARM ASSEMBLY 2 A NACOM SSPA 1 1 4 5 6 4 NOTE: UPPER CHANNEL CAN BE INVERTED T O ACCOMADATE LARGER BOOM SIZE IF NEEDED NOTE: THIS MOUNT ING KIT IS ...

  • Casio EC-BAND - page 12

    3133501 Figure 3b – Single Mount for a Ki ngpost A NA C OM AnaSat ® SSPA 12 ...

  • Casio EC-BAND - page 13

    3133501 Figure 3c – 1+1 Mount for a Kingpost A NA C OM AnaSat ® SSPA 13 ...

  • Casio EC-BAND - page 14

    3133501 Cable and Waveguide Connections Cabling Requirements Local regulations may require that cables in occupi ed buildings be installed in steel conduit. Local government agencies may waive this requireme nt for the use of Plenum cables, which are standard cables entirely encased in solid Teflon. Check the codes in your area. NOTE: E QUIPMENT OU ...

  • Casio EC-BAND - page 15

    3133501 Figure 5 - Diagram of AC power cable Transmitter Feed If using an SSPA with an N-type connector output, connect a section of coax between the OMT transmit port and the SSPA’s transmit port. If using a SSPA with a waveguide flange output por t, connect a section of waveguide between the OMT transmit port and the SSPA’s transmit output, T ...

  • Casio EC-BAND - page 16

    3133501 Final Check Recheck all bolts and cabling. After all other connections have been made (T X RF input, TX RF output, and grounding), connect the AC power cord to an active outlet. Water Resistance Wrap The application of moisture-resistant wrap (mastic tape) to all connectors is recomm ended to prevent water entry and resultant water damage. ...

  • Casio EC-BAND - page 17

    3133501 Operation After the AnaSat ® hardware is mounted and verified, the antenna must be aimed toward the desired satellite. Follow the antenna/mount manufacturer ’s instructions, using coordinates provided by the satellite operator. Do not transmit until you have received authorization from the satellite network operation center, and a transm ...

  • Casio EC-BAND - page 18

    3133501 Maintenance AnaSat ® SSPAs are designed for a minimum of m ainte nance. Periodic scheduled maintenance is not required. Replacement of the weatherized fan after 7 years is recommended however. Fan Replacement The ducted fan shroud should NEVER be removed from the ODU while AC power is connected to the SSPA. Disconnect AC power bef o re rep ...

  • Casio EC-BAND - page 19

    3133501 Alarm Relay Closure A mechanical relay is used in the AnaSat ® SSPA for alarm indication. The red LED mounted on the SSPA is illuminated whenever a probl em exists and the relay has closed. The alarm relay has normally closed contacts, so it defaults to the alarm state when power is off. The alarm relay is accessible through the 18-pin con ...

  • Casio EC-BAND - page 20

    3133501 “ON” indicates the SSPA will transmit when all alarms are cleared. This is the norm al setting. “OFF” indicates the SSPA will not turn on even if all alarms are clear. This can be saved across a reboot using the SAVE comma n d. • SSPA status is either “TX ON AIR” or TX OFF AIR”. • The third line gives a summ ary alarm indi ...

  • Casio EC-BAND - page 21

    3133501 18-Pin Circular Weathertight Connector An 18-pin circular connector is used for monito ring the alarm C-Form relay . Only some of the pins are used, but the same connector is used to main tain consistency with the protection switch used in the AnaSat ® product line. 1 2 3 4 5 6 7 9 10 11 12 13 14 15 16 17 18 8 18 17 16 15 14 13 12 11 10 9 ...

  • Casio EC-BAND - page 22

    3133501 Emissions and Immunity Regulation Conformance AnaCom SSPA products conform to the following CE standards listed below: Standards Met: Emissions Regulations 1. Power Line Conducted Emissions per EN55022: 2003 Class A 2. Open Field Radiated Emissions per EN55022: 2003 Class A 3. EN 61000-3-2: 2001, Limits for harmonic current em issions 4. EN ...

  • Casio EC-BAND - page 23

    3133501 LIMITED WARRANTY If this product should fail due to defects in m ateri als or workmanship, AnaCom, Inc., will, at its sole option, repair or replace it with new or rebuilt parts free of charge for a period of two (2) years from the date of shipment from the AnaCom factory. This warranty covers only failures due to defects in materials and w ...

Manufacturer Casio Category Stereo Amplifier

Documents that we receive from a manufacturer of a Casio EC-BAND can be divided into several groups. They are, among others:
- Casio technical drawings
- EC-BAND manuals
- Casio product data sheets
- information booklets
- or energy labels Casio EC-BAND
All of them are important, but the most important information from the point of view of use of the device are in the user manual Casio EC-BAND.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Casio EC-BAND, service manual, brief instructions and user manuals Casio EC-BAND. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Casio EC-BAND.

Similar manuals

A complete manual for the device Casio EC-BAND, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Casio EC-BAND by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Casio EC-BAND.

A complete Casio manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Casio EC-BAND - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Casio EC-BAND, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Casio EC-BAND, that we can find in the current document
3. Tips how to use the basic functions of the device Casio EC-BAND - which should help us in our first steps of using Casio EC-BAND
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Casio EC-BAND
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Casio EC-BAND in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Casio EC-BAND?

Use the form below

If you did not solve your problem by using a manual Casio EC-BAND, ask a question using the form below. If a user had a similar problem with Casio EC-BAND it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)