Manual Fisher & Paykel 60

32 pages 0.76 mb
Download

Go to site of 32

Summary
  • Fisher & Paykel 60 - page 1

    F reestanding cook er Installation instructions and User guide NZ A U OR60 models ...

  • Fisher & Paykel 60 - page 2

    ...

  • Fisher & Paykel 60 - page 3

    1 Safety and warnings 2 Installation instructions 6 Using y our oven f or the first time 14 Using y our oven 15 Cooking functions 16 Using y our gas cooktop 17 Cooktop tr oubleshooting 21 Care and cleaning 22 W arr anty and ser vice 28 Impor tant! SA VE THESE INSTRUCTIONS The models shown in this User Guide may not be available in all markets and a ...

  • Fisher & Paykel 60 - page 4

    2 Safety and warnings W ARNING! Electrical Shock Hazard Alway s disconnect the cooker from the mains electricity supply before carrying out any maintenance operations or r epairs. F ailure to do so may result in death or electrical shock. Impor tant safety precautions General T o avoid hazard , follow these instructions carefully before installing ...

  • Fisher & Paykel 60 - page 5

    3 The switch must always be ac cessible. The power supply c able must not touch any hot parts and must be positioned so that it does not exc eed 75 O C at any point. T o connect the cook er to the mains, do not use adapters, reduc ers or branching devices as they can cause o verheating and burning. This cooker m ust be connected to a suitable doubl ...

  • Fisher & Paykel 60 - page 6

    4 Operation Y our freestanding cooker has been carefully designed to operate saf ely during normal cook ing procedures . Please keep the following guidelines in mind when you are using it: Safety and warnings W ARNING! Hot Sur face Hazard Acc essible par ts may become hot when this cooker is in use . T o avoid burns and scalds keep children a way . ...

  • Fisher & Paykel 60 - page 7

    5 Safety and warnings Impor tant safety precautions Isolating switch: make sure this c ooker is connected to a circuit which inc orporates an isolating switch providing full disconnection from the power supply . Household appliances are not intended to be played with by children. Children, or persons with a disability which limits their ability to ...

  • Fisher & Paykel 60 - page 8

    6 750 mm 500 mm 105 mm 450 mm Clearances Installation clearances and protection of combustible surfaces shall comply with the current local regulations eg. A G 601 (AS 5601) Gas I nstallations code. Installation shall comply with the dimension in Fig . 1 bearing in mind that: Overhead Clearances In no case shall the clearance above the highest part ...

  • Fisher & Paykel 60 - page 9

    7 Installation instructions Lev elling the cooker T o fit the adjustable feet: Place the cooker on its back as shown. Screw the four f eet to the cooker . Stand the cooker and level it by screwing or unscrewing the f eet with a spanner . Fig . 2a Fitting the adjustable feet (supplied with the cooker in a separ ate kit) 0 + 8 mm + 8 mm + 15 mm Fig . ...

  • Fisher & Paykel 60 - page 10

    8 Installation instructions Anti-tilt bracket Impor tant! T o restrain the applianc e and prevent it tipping accidentally , fit a brack et to its rear to fix it securely to the wal l. T o fit the anti-tilt bracket: After you hav e located where the cooker is t o be positioned mark, on the wall, the place where the two screws of the anti-tilt bracke ...

  • Fisher & Paykel 60 - page 11

    9 Installation instructions Gas supply The gas connection must be carried out by an authorised person accor ding to the relevant standards. Before c onnecting the appliance to the gas main, mount the brass conical adaptor onto the gas inlet pipe, upon which the gasket has been placed (see F ig.s following). Conical adaptor and gasket are supplied w ...

  • Fisher & Paykel 60 - page 12

    10 Installation instructions After installing the freestanding cooker and connecting the gas supply: 1 Using a suitable leak detection fluid solution (e.g. Roc ol) check each gas connection one at a time by brushing the solution over the c onnection. The presence of bubbles will indicat e a leak. If there is a leak , tighten the fitting and then re ...

  • Fisher & Paykel 60 - page 13

    11 Installation instructions Con ver ting to a differ ent gas type This appliance is suitable for use with Natural gas or LPG gas (check the “ gas t ype” sticker attached to the appliance). T o conv er t from one gas type to another , you need to replace the injectors, and then adjust the minimum burning setting. T o replace the injectors Remov ...

  • Fisher & Paykel 60 - page 14

    12 Installation instructions Adjusting the minimum burner setting Check whether the flame spreads to all burner ports when the burner is lit with the gas tap set to the minimum position. If some por ts do not light, increase the minimum gas rate setting . Check whether the burner remains lit even when the gas tap is turned quickly from the maximum ...

  • Fisher & Paykel 60 - page 15

    13 Cod. 1131682 Installation instructions Lubrication of the gas taps A qualified technician must lubricate the gas taps. Wiring diagr am ...

  • Fisher & Paykel 60 - page 16

    14 Using y our oven f or the  rst time Fig . 11 Control panel Before using y our new oven, please: 1 Read this user guide, taking special note of the ‘Safety and warnings’ section. 2 Remove all acc essories and packaging. 3 Condition the oven: Slide in the shelves and grill pan as shown. Fit them between the metal runners of the shelf suppor ...

  • Fisher & Paykel 60 - page 17

    15 Using y our oven 1 Select the func tion using the function knob. The oven light will come on. 2 Select the temperature using the temperature control knob. The ov en temperature indicator light, above the temperatur e knob on the control panel, will glow until the ov en has reached the set temperature, and then it will go out. 3 When you hav e fi ...

  • Fisher & Paykel 60 - page 18

    16 Cooking functions OVEN LAMP Only the oven light comes on. It remains on in all the cooking functions. BAKE The upper and lower heating elements c ome on. BAKE is the traditional method of cooking. It is best to cook on only one shelf at a time in this function. FA N B A K E The upper and lower heating elements and the fan c ome on. F AN GRILL Bo ...

  • Fisher & Paykel 60 - page 19

    17 Using y our gas cooktop Gas burners The knob controls the flow of gas through the saf et y tap. = closed valve = maximum aperture or flow = minimum aper ture or flow Y ou can choose to cook at any heat between and , but nev er between and 0 . 1 Auxiliary burner 2 Semi-rapid burner 3 T riple -ring wok burner 0 Fig . 15 Cooktop layout Fig . 16 Bur ...

  • Fisher & Paykel 60 - page 20

    18 Using y our gas cooktop Before using y our cooktop Before using y our new cooktop, please: Read this user guide, taking special note of the ‘Safety and warnings’ section. T urn the cooker on. Make sure all controls ar e turned off . Lighting the cooktop 1 Choose the control knob for the burner you want to use . 2 Press the knob down gently a ...

  • Fisher & Paykel 60 - page 21

    19 If the cooktop does not light If the cooktop does not light, check that: The cooktop is plugged in and the electricity is switched on. The gas is turned on. The ignitors ar e sparking. If the ignitors are not sparking, they may be dirty or wet. Clean them with a toothbrush and methylated spirits , as shown. If the flame is irregular If the flame ...

  • Fisher & Paykel 60 - page 22

    20 Using y our gas cooktop Burners Minimum Maximum Auxiliary 12 cm (6 cm with grate) 14 cm Semi-rapid 16 cm 24 cm T riple -ring wok 26 cm 28 cm Maximum diameter for woks 36 cm Choosing a burner Use flat-bottomed pans, and make sur e that they match your burner , as shown in the f ollowing table. A small pot on a large burner is not efficient. Diame ...

  • Fisher & Paykel 60 - page 23

    21 Cookt op troubleshooting Problem Possible solutions My cooktop burners do not light. Check the cooker is switched on. Check the gas supply valve is turned on and the supply to the house is working. Y ou should hear the gas when you turn a burner on. The ignitors may be dirty . Clean them with a toothbrush and methylated spirits . The burner part ...

  • Fisher & Paykel 60 - page 24

    22 Car e and cleaning Impor tant! Before you start cleaning your cooker , please: Read these cleaning instructions and the ‘Safet y and warnings ’ sec tion at the start of this user guide. T urn the cooker off at the w all. Make sure the c ooker is a safe temperature to touch. Do not use a steam cleaner . Do not keep flammable substances in the ...

  • Fisher & Paykel 60 - page 25

    23 Car e and cleaning Cap Ignitor Flame spreader Burner parts and pan suppor ts Y ou can remove and clean these parts with hot soapy water or non-abrasive detergents. Clean spills regularly befor e they become burnt on. Do not wash these par ts in a dishwasher . After cleaning, check that the burners and their flame spreaders ar e dr y before repla ...

  • Fisher & Paykel 60 - page 26

    24 Car e and cleaning Replacing the wok burner T o replace the wok burner , fit the burner ring to the housing as shown by the arro w in the Fig. following . M ake sure the burner is not able to r otate. Gas taps If you have pr oblems with the gas taps, call your A uthorised Ser vice Centr e. Fig . 22 T riple-ring wok burner par ts Ignitor Fig . 23 ...

  • Fisher & Paykel 60 - page 27

    25 Car e and cleaning Cleaning the enamel cavity Clean the enamel on the inside of the oven when it has cooled do wn, using household detergents or an ammonia-based cleaner . Y ou may use ‘ off the shelf ’ oven cleaners , if you carefully follo w the manufacturers’ instructions. T o make cleaning easier, y ou can remove the side racks, the ov ...

  • Fisher & Paykel 60 - page 28

    26 Car e and cleaning Removing the ov en door The oven door can easily be r emoved as foll ows: Open the door completely . Hook the swivel retainers of the right-hand and left-hand hinges (Fig . 28a) onto the metal bar above them (F ig. 28b). Lift the oven door slightly . T he notch on the bottom of the hinge will disengage (Fig . 28c). Now pull th ...

  • Fisher & Paykel 60 - page 29

    27 Car e and cleaning Replacing the oven lamp Let the ov en cavity and the heating elements cool down. Remove the prot ec tive cov er “B” . Unscrew and replace the bulb “ A ” with a new one suitable for high temperatures (300°C) with the specifications: 230-240V 50 Hz, 15W , E14 Refit the protective cov er “B” . Note: oven bulb r eplac ...

  • Fisher & Paykel 60 - page 30

    28 W arranty and ser vice Before y ou call for ser vice or assistance ... Check the things you can do yourself . Refer to the installation instructions and your user guide and check that: 1 Y our product is correctly installed. 2 Y ou are familiar with its normal operation. If after check ing these points you still need assistance , please refer to ...

  • Fisher & Paykel 60 - page 31

    ...

  • Fisher & Paykel 60 - page 32

    Copyright © F isher & Paykel 2007. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at an y time. Y ou should therefore check with your Dealer to ensure this booklet correc ...

Manufacturer Fisher & Paykel Category Cooktop

Documents that we receive from a manufacturer of a Fisher & Paykel 60 can be divided into several groups. They are, among others:
- Fisher & Paykel technical drawings
- 60 manuals
- Fisher & Paykel product data sheets
- information booklets
- or energy labels Fisher & Paykel 60
All of them are important, but the most important information from the point of view of use of the device are in the user manual Fisher & Paykel 60.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Fisher & Paykel 60, service manual, brief instructions and user manuals Fisher & Paykel 60. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Fisher & Paykel 60.

A complete manual for the device Fisher & Paykel 60, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Fisher & Paykel 60 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Fisher & Paykel 60.

A complete Fisher & Paykel manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Fisher & Paykel 60 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Fisher & Paykel 60, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Fisher & Paykel 60, that we can find in the current document
3. Tips how to use the basic functions of the device Fisher & Paykel 60 - which should help us in our first steps of using Fisher & Paykel 60
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Fisher & Paykel 60
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Fisher & Paykel 60 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Fisher & Paykel 60?

Use the form below

If you did not solve your problem by using a manual Fisher & Paykel 60, ask a question using the form below. If a user had a similar problem with Fisher & Paykel 60 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)