English dropdown-ico

Manual Stiga 8211-0007-70

17 pages 2.13 mb
Download

Go to site of 17

Summary
  • Stiga 8211-0007-70 - page 1

    STIGA PARK DIESEL DIESEL 4WD 8211-000 7-70 BRUKSANVISNING KÄYTTÖOHJEET BRUGSANVISNING BRUKSANVISNING GEBRAUCHSANWEISUNG INSTRUCTIONS FOR USE MODE D’EMPLOI GEBRUIKSAANWIJZING SV .... 7 FI ... 1 7 DA .. 27 NO . 37 DE ... 47 EN ... 5 8 FR .... 68 NL ... 79 ...

  • Stiga 8211-0007-70 - page 2

    2 S T A B C F D E G HI J K 2WD P Q 4WD G HI J K L N O M 2WD R 1 3 5 2 4 6 ...

  • Stiga 8211-0007-70 - page 3

    3 4WD BA Max Max C V U Y W E 7 9 11 8 10 12 ...

  • Stiga 8211-0007-70 - page 4

    4 A B C C P D 0 1 F V 13 15 17 14 16 18 ...

  • Stiga 8211-0007-70 - page 5

    5 G H I J 19 21 23 20 22 24 ...

  • Stiga 8211-0007-70 - page 6

    6 4WD 2WD 25 27 29 26 28 30 ...

  • Stiga 8211-0007-70 - page 7

    58 ENGLISH EN 1 GENERAL This symbol indicates W ARNING . Seri- ous personal injury and/or damage to property may result if the instructions are not followed car efully . Y ou must r ead these instructions for use and the accompanying pamphlet “SAFETY INSTR UCTIONS” car eful- ly , before starting up the machine. 1.1 SYMBOLS The following symbols ...

  • Stiga 8211-0007-70 - page 8

    59 ENGLISH EN 2.4.2 Implement lifter, hydraulic (4:M) (4WD) The hydraulic implement lifter only works when the engine is running and the clutch pedal and parking brake pedal are not depressed. The imple- ment lifter is controlled using the lever (4:M). The lever has the following four positions: Floating position . Move the lever to it s front posi ...

  • Stiga 8211-0007-70 - page 9

    60 ENGLISH EN 2.4.9 Ignition lock (4,5:I) Ignition lock used for starting/stopping the engine. There are 3 positions: 1. Stop position – the engine is short-cir- cuited. The key can be removed. 2. Operating position 3. Start position – the electric start motor is activated when the key is turned to the spring-loaded start position. Once the en- ...

  • Stiga 8211-0007-70 - page 10

    61 ENGLISH EN 2.4.18 Seat (1:T) The seat can be folded and adjusted front- rear . The seat can be adjusted as follows: 1. Move the control lever (1:S) upwards. 2. Set the seat to the desired position. 3. Release the control lever (1:S) to lock the seat. The seat is equipped with a safety switch that is connected to the machine’ s safety system. T ...

  • Stiga 8211-0007-70 - page 11

    62 ENGLISH EN Only fill or top up with fuel outdoors, and never smoke when filling or top- ping up. Fill with fuel before starting the engine. Never remove the fuel cap or fill with fuel while the engine is running or still warm. 4.2 Bleeding The engine’ s fuel system must be bled in the fol- lowing instances: • If the fuel tank has been run dr ...

  • Stiga 8211-0007-70 - page 12

    63 ENGLISH EN 4.6 Start 1. Do not keep your foot on the drive pedal. 2. Put the throttle control at full throttle. 3. Depress the brake pedal fully . 4. Turn the ignition key and start the engine. The engine does not need to be preheated. 5. When starting from cold, do not make the ma- chine work under load immediately , but let the engine run for ...

  • Stiga 8211-0007-70 - page 13

    64 ENGLISH EN 5.2 Preparation All service and all maintenance must be carried out on a stationary machine with the engine switched off. Prevent the machine from r olling by al- ways applying the parking brake. S top the engine. Prevent unintentional starting of the motor by always stopping the motor and disconnecting the negative cable from the bat ...

  • Stiga 8211-0007-70 - page 14

    65 ENGLISH EN The engine must be cold when the con- densation id drained, otherwise there is a risk of fire. Smoking, fires, sparks and other heat sources ar e prohibited in the proximity when the condensation is drained. There is a fire risk. Drain the condensation as follows: 1. Detach the drain hose from the its mounting un- der the rear bumper ...

  • Stiga 8211-0007-70 - page 15

    66 ENGLISH EN 5.10 Steering The steering must be checked/adjusted after 5 hours of operation and thereafter after 100 hours of operation. 5.10.1 Checks Briefly turn the steering wheel back and forth. There must be no mechanical clearance in the steering chains. 5.10.2 Adjustment Adjust the steering chains if required as follows: 1. Put the machine ...

  • Stiga 8211-0007-70 - page 16

    67 ENGLISH EN 3. Disconnect the air filter housing by slacken ing off th e wing nut (23:H). 4. Remove the filter (24: I) by slackening off the ridged nut (24:J). Never direct the flow of compressed air towards the body . The penetration of air into the blood stream can be fatal. 5. Clean of f any dry dirt on the filter by blowing compressed air in ...

  • Stiga 8211-0007-70 - page 17

    www .stiga.com GGP Sweden AB · Box 1006 · SE-573 28 TRANÅS ...

Manufacturer Stiga Category Automobile

Documents that we receive from a manufacturer of a Stiga 8211-0007-70 can be divided into several groups. They are, among others:
- Stiga technical drawings
- 8211-0007-70 manuals
- Stiga product data sheets
- information booklets
- or energy labels Stiga 8211-0007-70
All of them are important, but the most important information from the point of view of use of the device are in the user manual Stiga 8211-0007-70.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Stiga 8211-0007-70, service manual, brief instructions and user manuals Stiga 8211-0007-70. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Stiga 8211-0007-70.

Similar manuals

A complete manual for the device Stiga 8211-0007-70, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Stiga 8211-0007-70 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Stiga 8211-0007-70.

A complete Stiga manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Stiga 8211-0007-70 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Stiga 8211-0007-70, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Stiga 8211-0007-70, that we can find in the current document
3. Tips how to use the basic functions of the device Stiga 8211-0007-70 - which should help us in our first steps of using Stiga 8211-0007-70
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Stiga 8211-0007-70
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Stiga 8211-0007-70 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Stiga 8211-0007-70?

Use the form below

If you did not solve your problem by using a manual Stiga 8211-0007-70, ask a question using the form below. If a user had a similar problem with Stiga 8211-0007-70 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

Claudia

our cameras are offline and we are unable to restart with the installation as impossible to cancel them from the program