Manual Velodyne Acoustics SC-600

24 pages 0.39 mb
Download

Go to site of 24

Summary
  • Velodyne Acoustics SC-600 - page 1

    SC-600 Amplifier SubContr actor ™ Series USER’S MANUAL SC-600 Amplifier , SC-600 IW , SC-600 IF/IC Subwoofers ...

  • Velodyne Acoustics SC-600 - page 2

    i . www .velodyne.com SC-600 Amplifier User’s Manual Caution! IMPORTANT SAFETY INSTRUCTIONS Caution To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel. The lightning flash with arrowhead symbol is intended to alert the user to the presence of uninsu ...

  • Velodyne Acoustics SC-600 - page 3

    ii . www .velodyne.com SC-600 Amplifier User’s Manual C ongratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Product Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 – SC-600 Subwoofer Amplifier . . . . . . . . . . . ...

  • Velodyne Acoustics SC-600 - page 4

    Congratulations 1 . www .velodyne.com SC-600 Amplifier User’s Manual C ongratulations on your purchase of a V elodyne SubContractor Series (SC) 600 amplifier and subwoofer . This system represents the state-of-the-ar t in low frequency reproduction. Read and follow the instructions below to ensure safe and proper system operation. Warning! T o pr ...

  • Velodyne Acoustics SC-600 - page 5

    2 . www .velodyne.com SC-600 Amplifier User’s Manual SC-600 IW , SC-600 IF/IC SUBWOOFERS SC-600 IW (In-Wall): - T wo high excursion 6.5” active drivers, two 12.5” x 3” oval passive radiators with ribbed rubber surround - High-excursion rubber surround - 2” dual layer inside/outside voice coil - Frequency Response: 30 - 120Hz (+/- 3 dB) -4 ...

  • Velodyne Acoustics SC-600 - page 6

    FRONT P ANEL CONTROLS AND DISPLA YS FRONT P ANEL CONTROLS AND DISPLA YS Figure 1: Front Panel Connections of the SC-600 amplifier . Following are brief descriptions of the controls described in Figure 1. More detail on these controls can be found in the next section. (1) Power Switch This button forces your SC-600 amplifier into standby mode. The p ...

  • Velodyne Acoustics SC-600 - page 7

    4 . www .velodyne.com SC-600 Amplifier User’s Manual ( 6) LED Numeric Indicator This LED supplies information on volume, crossover , woofer type, and other information. The l ight button on the remote deactivates this display . Upon star tup, the display shows the model of subwoofer the SC-600 amp is controlling, then rever ts to the volume indic ...

  • Velodyne Acoustics SC-600 - page 8

    5 . www .velodyne.com SC-600 Amplifier User’s Manual O ption 1 Figure 2A: Mono (LFE) Line-Level Connection. Option 2 Figur e 2B: Stereo Line-Level Connection. L ine-Level S ubwoofer Signal f rom Sour ce (LFE) Note: A “Y” Connector can be used as an option. Stereo Line-Level Input from Sour ce Stereo Line-Level Output to Another system, e.g. S ...

  • Velodyne Acoustics SC-600 - page 9

    6 . www .velodyne.com SC-600 Amplifier User’s Manual ( 11) IR Input An IR repeater can be connected to this mini-jack. (12) 12V T rigger When this mini-jack is connected, the unit remains in power-of f mode until 12 volts is supplied across the two leads. Polarity is irrelevant. (13) RS-232 In Use this por t to communicate with an RS-232 controll ...

  • Velodyne Acoustics SC-600 - page 10

    7 . www .velodyne.com SC-600 Amplifier User’s Manual Figure 3: Speaker-Level Connection. (17) Subwoofer Connection T er minals Connect the output terminals to the subwoofer being controlled by the SC-600 amplifier . Only connect ONE subwoofer to the red/black pair of subwoofer output terminals - DO NOT connect multiple subwoofers to the ter minal ...

  • Velodyne Acoustics SC-600 - page 11

    8 . www .velodyne.com SC-600 Amplifier User’s Manual T he SC-600 amplifier is equipped with both speaker-level and line-level inputs. Use the RCA/Phono type “INPUT” jacks when connecting from a pre-amp, signal processor , or line-level crossover . The “SPEAKER LEVEL INPUT” jacks connect directly to the speaker outputs of an integrated amp ...

  • Velodyne Acoustics SC-600 - page 12

    9 . www .velodyne.com SC-600 Amplifier User’s Manual I n these installations, you may want to bypass the crossover in either the processor or the V elodyne SC-600 amplifier as described above. However , in some cases you may want to use B OTH crossovers. If you choose to do this you should stagger the frequencies, (i.e., 120 Hz subwoofer , 80 Hz ...

  • Velodyne Acoustics SC-600 - page 13

    10 . www .velodyne.com SC-600 Amplifier User’s Manual Y our SC-600 amplifier can control the V elodyne SC-600 Series subwoofers as well as generic passive subwoofers. Special internal software settings are designed to maximize performance and reliability depending on the model of subwoofer being controlled, so it is impor tant to match the SC-600 ...

  • Velodyne Acoustics SC-600 - page 14

    T his section addresses day-to-day usage of your SC-600 amplifier . Remote Control The features of the SC-600 remote control are listed below . • POWER — This button forces your SC-600 amplifier unit into standby mode. The power LED turns amber , the numeric LED shuts off, and the amplifier puts out no power . The unit will remain in this mode ...

  • Velodyne Acoustics SC-600 - page 15

    12 . www .velodyne.com SC-600 Amplifier User’s Manual WARNING: Some manufacturers preset their receivers with the Sub-Out channel signal at a minimum level. It is ver y impor tant to verify that your receiver Sub-Out channel is set to the same output level as your front right and left channels. Refer to your receiver manual for the i ndividual ch ...

  • Velodyne Acoustics SC-600 - page 16

    13 . www .velodyne.com SC-600 Amplifier User’s Manual T he following table indicates musical style and which preset is recommended for it. MUSICAL STYLE SUGGESTED PRESET Action Adventure Movies Movies Countr y – Rock R&B – Rock Countr y – Soft Jazz – Classical Folk Jazz – Classical Indie Music R&B – Rock Pop R&B – Rock R ...

  • Velodyne Acoustics SC-600 - page 17

    14 . www .velodyne.com SC-600 Amplifier User’s Manual Restoring Def aults Care of y our Amplifier and Subw oofer T here is a feature that allows you to restore default settings for your SC-600 amplifier . By pressing presets in EXACTL Y the following order on the remote, the unit’ s power light will blink indicating that you have restored defau ...

  • Velodyne Acoustics SC-600 - page 18

    15 . www .velodyne.com SC-600 Amplifier User’s Manual B efore seeking ser vice for your amplifier or subwoofer , please re-check all systems. Following is a simple troubleshooting guide to assist you. 1. V erify that the unit is plugged in and power outlet used is active. 2. Is the power switch on? 3. Is the unit receiving an input signal from yo ...

  • Velodyne Acoustics SC-600 - page 19

    16 www .velodyne.com SC-600 Amplifier User’s Manual Specifications SC- 600 I W (In- W all) SC-600 IF/IC (In-Floor/In-Ceiling) Woofer: Two 6.5" active drivers Two 12.5" x 3" passive radiators 12" (9.7" piston diameter) subwoofer Frequency Response: (+/-3 dB) 37-120Hz 25-120Hz Har moni c Dis tort ion: <5% (typical) <5 ...

  • Velodyne Acoustics SC-600 - page 20

    17 . www .velodyne.com SC-600 Amplifier User’s Manual Appendix A: RS-232 Serial Overview and Commands Introduction This document outlines V elodyne’ s SubContractor (SC) RS - 232 protocol specification. This protocol indicates how SC products receive run - time commands from devices such as Creston Universal Remote Controls. Com Port Setup Use ...

  • Velodyne Acoustics SC-600 - page 21

    18 . www .velodyne.com SC-600 Amplifier User’s Manual R S232 Commands Activity Command Acceptable Example(s) Comments Format n V alues V olume Control #VOnn$, 00 – 80 #VO25$, Sets volume to a value, #VO+$, #VO+$, increments volume up #VO-$, #VO-$, or down, or requests #VO?$ #VO?$ current volume setting Preset Control #PSn$, 1, 2, 3, 4 #PS1$, #P ...

  • Velodyne Acoustics SC-600 - page 22

    19 . www .velodyne.com SC-600 Amplifier User’s Manual Velodyne Pr oducts MiniV ee ® MiniV ee ® 10 Optimum Series Optimum-8 Optimum-10 Optimum-12 SMS™-1 SubContractor™ Series SC -1250 SC -10 SC -12 SC -15 SC -IW SC -IF/IC SC-600 Amp SC-600 IW SC-600 IF/IC VX Series VX - 10 ® DD Series DD -10 DD -12 DD -15 DD -18 Digital Drive 18 12 Signatur ...

  • Velodyne Acoustics SC-600 - page 23

    20 . www .velodyne.com SC-600 Amplifier User’s Manual LIMITED W ARRANTY - U.S. AND CANADA ONL Y VELODYNE ACOUSTICS, Inc. (“VELODYNE”) war rants all electronics for a period of three years, drivers for a period of five years, and full range speakers for a period of five years. All VELODYNE products have a warranty from the date of purchase aga ...

  • Velodyne Acoustics SC-600 - page 24

    . www .velodyne.com V elodyne Acoustics, Inc. 345 Digital Drive Mor gan Hill, CA 95037 408.465.2800 voice 408.779.9227 fax 408.779.9208 ser vice fax www .velodyne.com Ser vice E - mail: ser vice@velodyne.com Product E - mail: help@velodyne.com T echnical E - mail: techhelp@velodyne.com 63-SC600 RevB DEC 2008 ...

Manufacturer Velodyne Acoustics Category Stereo Amplifier

Documents that we receive from a manufacturer of a Velodyne Acoustics SC-600 can be divided into several groups. They are, among others:
- Velodyne Acoustics technical drawings
- SC-600 manuals
- Velodyne Acoustics product data sheets
- information booklets
- or energy labels Velodyne Acoustics SC-600
All of them are important, but the most important information from the point of view of use of the device are in the user manual Velodyne Acoustics SC-600.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Velodyne Acoustics SC-600, service manual, brief instructions and user manuals Velodyne Acoustics SC-600. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Velodyne Acoustics SC-600.

A complete manual for the device Velodyne Acoustics SC-600, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Velodyne Acoustics SC-600 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Velodyne Acoustics SC-600.

A complete Velodyne Acoustics manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Velodyne Acoustics SC-600 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Velodyne Acoustics SC-600, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Velodyne Acoustics SC-600, that we can find in the current document
3. Tips how to use the basic functions of the device Velodyne Acoustics SC-600 - which should help us in our first steps of using Velodyne Acoustics SC-600
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Velodyne Acoustics SC-600
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Velodyne Acoustics SC-600 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Velodyne Acoustics SC-600?

Use the form below

If you did not solve your problem by using a manual Velodyne Acoustics SC-600, ask a question using the form below. If a user had a similar problem with Velodyne Acoustics SC-600 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)