English dropdown-ico

Manual RedMax G3100T

28 pages 0.69 mb
Download

Go to site of 28

Summary
  • RedMax G3100T - page 1

    OWNER / OPERA T OR MANUAL CHAINSA WS T2054-93110 (606) The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. W ARNING Before using our products, please read this manual carefully to understand the proper use of your unit. W ARNING APPLICABLE SERIAL NUMBERS ...

  • RedMax G3100T - page 2

    SAFETY FIRST Instructions contained in warnings within this manual marked with a symbol concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. ■ WARNINGS IN THE MANUAL This mark indicates i ...

  • RedMax G3100T - page 3

    2. Specifications ■ G3100T Power unit : Displacement ···················································································· 1.9 (30.1) cu-in (cm 3 ) Fuel ················································ ...

  • RedMax G3100T - page 4

     4  3. Symbols on the machine MADE IN IT AL Y IMPORT ANT ENGINE INFORMA TION THIS ENGINE CONFORMS TO US EP A PH1 FOR SMALL OFF-RO AD ENGINES. ENGINE F AMIL Y : 3E8XS.0304TH ENGINE DISPLACEMENT : 30.1cm 3 MANUF ACTURED: REFER TO O WNER'S MANUMAL FOR MAINTE- NANCE SPECIFICA TIONS AND ADJUSTMENTS. W ARNING! THIS SAW IS FOR TRAINED TREE SERV ...

  • RedMax G3100T - page 5

    4. For safe operation 1. Never operate a chain saw when you are fatigued, ill, or upset, or under the influence of medication that may make you drowsy, or if you are under the influence of alcohol or drugs. 2. Use safety footwear, snug fitting clothing and eye, hearing and head protection devices. 3. Always use caution when handling fuel. Wipe up a ...

  • RedMax G3100T - page 6

     6  4. For safe operation 16. Operate the chain saw only in well ventilated areas. Never start or run the engine inside a closed room or building. Exhaust fumes contain dangerous carbon monoxide. 17. Do not operate a chain saw in a tree unless specially trained to do so. 18. Guard against kickback. Kickback is the upward motion of the guide b ...

  • RedMax G3100T - page 7

    A standard saw unit package contains the items as shown. (SE1) Open the box and install the guide bar and the saw chain to the power unit as follows. The saw chain has very sharp edges. Use thick, protective gloves to avoid injury. 1. Loosen a nut and remove the chain cover. 2. Mount the guide bar and fit the saw chain around the bar and the drive ...

  • RedMax G3100T - page 8

     8  6. Fuel and chain oil • Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3m (10ft) away from the fueling point before starting the engine. • The RedMax engines are lubri ...

  • RedMax G3100T - page 9

    6. Fuel and Chain oil again for at least one minute. As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary for the engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger of early piston seizing due to abnormally lean mixture. 5. Put a clear indication o ...

  • RedMax G3100T - page 10

     10  ■ FUELING THE UNIT (OP1) 1. Remove the fuel tank cap and pour fuel into the tank up to 80% of full capacity. 2. Fasten the fuel cap securely and wipe up any fuel spillage around the unit. 3. Remove the oil tank cap and pour chain oil into the tank. Fasten the cap securely. 1. Select bare ground for fueling. 2. Move at least 10 feet (3 ...

  • RedMax G3100T - page 11

    7. Operation 5. While holding the saw unit securely on the ground, pull the starter rope vigorously. (OP5) Do not start the engine while hanging the chain saw with a hand. The saw chain may touch your body. It's very dangerous. 6. When engine has ignited first, push in the choke knob and pull the rope again to start the engine. 7. Allow the en ...

  • RedMax G3100T - page 12

    ■ ADJUSTING CARBURETOR (OP8) The carburetor on your unit has been factory adjusted, but may require fine tuning due to change in operating conditions. Before adjusting the carburetor, make sure that provided are clean air/fuel filters and fresh, properly mixed fuel. When adjusting, take the following steps: Be sure to adjust the carburetor with t ...

  • RedMax G3100T - page 13

    7. Operation •W hen the brake worked, immediately release the throttle lever and slow down the engine speed. Running the engine at high speed while braking the saw chain can cause clutch failures. • Before starting the day's job, check the condition of the brake system as follows: 1) Start the engine and grasp the handles securely with bot ...

  • RedMax G3100T - page 14

    • Before proceeding to your job, read “For Safe Operation” section. It is recommended to first practice sawing easy logs. This also helps you get accustomed to your unit. • It is not necessary to force the saw into the cut. Apply only light pressure while running the engine at full throttle. • Racing the engine with the chain seized in a ...

  • RedMax G3100T - page 15

    should stop immediately with the engine at full speed. If the chain is slow to stop or does not stop then replace the brake band and clutch drum before use. • It is extremely important that the chain brake be checked for proper operation before each use and that the chain be sharp in order to maintain the kickback safety level of this saw. Remova ...

  • RedMax G3100T - page 16

    of bending direction to prevent the guide bar from being caught in the cutaway. ● Cutting an unpillowed log Saw down halfway, then roll the log over and cut from the opposite side. (SA3) ● Cutting a pillowed log In the area A in the picture right above, saw up from the bottom one-third and finish by sawing down from the top. In the area B, saw ...

  • RedMax G3100T - page 17

     17  9. Maintenance Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-road engine repair establishment or individual. Make sure to stop the engine before inspecting and/or servicing the unit. ■ DAILY MAINTENANCE SAW CHAIN It is one of the essential factors for smooth and safe operatio ...

  • RedMax G3100T - page 18

     18  9. Maintenance GUIDE BAR 1. Remove sawdust in the bar groove and the oiling port. (MA5) 2. Grease the nose sprocket from the feeding port on the tip of the guide bar. (MA6) 3. Periodically turn over the guide bar when mounting it to the unit, in order to prevent partial wear. This saw is equipped with one of the following low kickback ba ...

  • RedMax G3100T - page 19

    anything wrong be found, make sure to have it repaired before next usage. ■ MONTHLY MAINTENANCE FUEL FILTER When the engine runs short of fuel supply, check the fuel filter for blockage. (MA9) OIL STRAINER Drain the oil tank and remove the oil strainer located near the spark plug. Check the condition and clean if necessary. (MA10) SPARK PLUG Star ...

  • RedMax G3100T - page 20

     20  SPARK ARRESTER RedMax engines are equipped with a spark arresting screen at the exhaust port. Periodically check and keep it in good condition. In the State of California it is required by law (Section 4442 of the California Public Resources Code) to have a spark arrester when a gas powered tool is used in any forest covered, brush cover ...

  • RedMax G3100T - page 21

     21  1 1. Parts list NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. KOMATSU ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company. 3. When placing parts orders for repair and/or replacement, check if the model ...

  • RedMax G3100T - page 22

     22  1 1. Parts list Fig.1 POWER UNIT G3100T (S/N 0723010001 and up) G3100T ...

  • RedMax G3100T - page 23

     23  Fig.1 POWER UNIT (S/N 0723010001 and up) G3100T 1 T2050-12110 CYLINDER 1 2 T2050-21110 CRANKCASE 1 3 01252-30530 BOLT 4 4 2870-41111 PISTON 1 5 3319-41210 RING 1 6 3304-41310 PIN 1 7 3310-41320 SNAP RING 2 8 3310-41410 BEARING 1 9 1650-41510 WASHER 2 10 2870-42002 CRANKSHAFT COMP 1 11 06030-06201 BEARING 2 12 2630-43150 OIL SEAL 1 13 040 ...

  • RedMax G3100T - page 24

     24  1 1. Parts list Fig.2 CARBBURETOR COMPONENTS & ACCESSORIES (S/N 0723010001 and up) G3100T ...

  • RedMax G3100T - page 25

     25  Fig.2 CARBBURETOR COMPONENTS & ACCESSORIES (S/N 0723010001 and up) G3100T Key# PART NUMBER DESCRIPTION Q'TY /UNIT NOTE Key# PART NUMBER DESCRIPTION Q'TY /UNIT NOTE 1 T2054-81000 CARBURETOR ASS'Y 2 T2052-81120 • PUMP COVER 1 3 3310-81130 • SCREW 1 4 3310-81280 • COVER 1 5 1480-81420 • PLUG 1 6 3350-81380 • SPR ...

  • RedMax G3100T - page 26

    THE CALIFORNIA AIR RESOURCES BOARD AND KOMATSU ZENOAH Co. ARE PLEASED TO EXPLAIN THE EMISSION CONTROL SYSTEM WARRANTY ON YOUR 1995 AND LATER LAWN AND GARDEN EQUIPMENT ENGINE. IN CALIFORNIA, NEW UTILITY AND LAWN AND GARDEN EQUIPMENT ENGINES MUST BE DESIGNED, BUILT AND EQUIPPED TO MEET THE STATE'S STRINGENT ANTI-SMOG STANDARDS. KOMATSU ZENOAH Co ...

  • RedMax G3100T - page 27

    EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY, RedMax / KOMATSU ZENOAH AMERICA, INC., THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OF CHARGE, FOR THE ORIGINAL AND EACH SUBSEQUENT PURCHASER, ANY PART OR PARTS FOUND TO BE DEFECTIVE IN MATERIAL AND/OR WORKMANSHIP. EMISSION-RELATED PARTS ARE: THE CARBURETOR ASS ...

  • RedMax G3100T - page 28

    Pièces en rapport avec les émissions de gaz d'échappement : RedMax / KOMATSU ZENOAH AMERICA INC., par l'intermédiaire de n'importe quel revendeur RedMax, réparera gratuitement ou remplacera gratuitement pour l'acheteur initial et chaque acheteur successif toute(s) pièce(s) se révélant de constitution et/ou de montage dé ...

Manufacturer RedMax Category Chainsaw

Documents that we receive from a manufacturer of a RedMax G3100T can be divided into several groups. They are, among others:
- RedMax technical drawings
- G3100T manuals
- RedMax product data sheets
- information booklets
- or energy labels RedMax G3100T
All of them are important, but the most important information from the point of view of use of the device are in the user manual RedMax G3100T.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals RedMax G3100T, service manual, brief instructions and user manuals RedMax G3100T. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product RedMax G3100T.

Similar manuals

A complete manual for the device RedMax G3100T, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use RedMax G3100T by users. Manuals are usually written by a technical writer, but in a language understandable to all users of RedMax G3100T.

A complete RedMax manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual RedMax G3100T - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the RedMax G3100T, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the RedMax G3100T, that we can find in the current document
3. Tips how to use the basic functions of the device RedMax G3100T - which should help us in our first steps of using RedMax G3100T
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with RedMax G3100T
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of RedMax G3100T in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning RedMax G3100T?

Use the form below

If you did not solve your problem by using a manual RedMax G3100T, ask a question using the form below. If a user had a similar problem with RedMax G3100T it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)