Manual Weil-McLain 105

12 pages 0.49 mb
Download

Go to site of 12

Summary
  • Weil-McLain 105 - page 1

    V ent Supplement This document must only be used by a qualified heating installer/service technician. Read all instructions, including this Supplement and the Boiler Manual, before installing. P erform st eps in the order given. Failure to c omply could r esult in se ver e pe rsonal inju r y , d eath or substantial property damag e. Installation mu ...

  • Weil-McLain 105 - page 2

    Part number 550-101-235/0903 2 GAS - FIRED WA TER BOILER — V ent Supplement Please read before proceeding Installer Read all instructions before installing. Follow all instructions in proper order to prevent personal injury or death. • This document is intended only as a supplement to the Ultra Boiler Manual. It’ s purpose is fo r the install ...

  • Weil-McLain 105 - page 3

    Part number 550-101-235/0903 3 GAS - FIRED WA TER BOILER — V ent Supplement V ent and air piping materials Use only the materials listed in the table below for vent and air pipe and fittings. Failure to comply could result in sever e personal injur y , death or substantial pr opert y damage. 1 Installation must comply with local requirements and ...

  • Weil-McLain 105 - page 4

    Part number 550-101-235/0903 4 GAS - FIRED WA TER BOILER — V ent Supplement Pr epare boiler location V ent and air piping Vent and air system Installation must comply with local requir ements and with the National F uel Gas Code, ANSI Z223.1 fo r U.S. installations or CSA B149.1 or B149.2 for Canadian installations. The Ultra boiler requires a sp ...

  • Weil-McLain 105 - page 5

    Part number 550-101-235/0903 5 GAS - FIRED WA TER BOILER — V ent Supplement Pr epare boiler location (continued) Table 1 Corrosive contaminants 2 T o preve nt the p otential of severe personal injury or death, check for areas and pr oducts listed in T able 1 before installing the boiler or air inlet piping. If contaminants are found, you MUST : ? ...

  • Weil-McLain 105 - page 6

    Part number 550-101-235/0903 6 GAS - FIRED WA TER BOILER — V ent Supplement V ent/air ter mination — thr ough r oof 3 Figure 1 V er tical termination of air & vent Determine location Locate the vent/air terminations using the following guidelines: 1. The total length of piping for vent or air must not ex ceed the limits given in T able 2, p ...

  • Weil-McLain 105 - page 7

    Part number 550-101-235/0903 7 GAS - FIRED WA TER BOILER — V ent Supplement V ent/air ter mination — thr ough r oof (continued) 3 Prepare roof penetrations 1 . Air pipe penetration: a. Cut a hole for the air pipe. Size the air pipe hole as close as desired to the air pipe outside diamet er . 2 . V ent pipe p enetrat ion: a . Cut a hole for the ...

  • Weil-McLain 105 - page 8

    Part number 550-101-235/0903 8 GAS - FIRED WA TER BOILER — V ent Supplement V ent/air ter mination — sidewall 4 Determine location Locate the vent/air terminations using the following guidelines: 1. The total length of piping for vent or air must not ex ceed the limits given in T able 2, page 12. 2 . The air piping must terminate in a down-turn ...

  • Weil-McLain 105 - page 9

    Part number 550-101-235/0903 9 GAS - FIRED WA TER BOILER — V ent Supplement Prepare wall penetrations 1. Air pipe penetration: a. Cut a hole for the air pipe. Size the air pipe hole as close as desired to the air pipe outside diameter . 2. V ent pipe pene trat ion: a . Cut a hole for the vent pipe. For either combustible or noncombustible constru ...

  • Weil-McLain 105 - page 10

    Part number 550-101-235/0903 10 GAS - FIRED WA TER BOILER — V ent Supplement Figure 7 Multiple vent/air terminations (must also comply with Figure 4) Figure 8 Multiple vent/air terminations (must also comply with Figure 4) (Apply this method only where exit openings are too low to provide minimum 12 inch clearance above grade/snow line.) V ent/ai ...

  • Weil-McLain 105 - page 11

    Part number 550-101-235/0903 11 GAS - FIRED WA TER BOILER — V ent Supplement Installing vent & air piping 5 Inserting/securing vent or air pipe into boiler adapters 1 . Clean and chamfer insertion end of pipe. Deburr inside of insertion end. Clean and deburr inside and outside of other end of pipe. The pipe end must be smooth and chamfered to ...

  • Weil-McLain 105 - page 12

    Part number 550-101-235/0903 12 GAS - FIRED WA TER BOILER — V ent Supplement Installing vent & air piping (continued) 5 Figure 10 Piping to through-roof terminations Figure 9 Piping to sidewall terminations Ta b l e 2 Min/max lengths of either air piping or vent piping When a large number of elbows is needed with 3-inch piping, use long radiu ...

Manufacturer Weil-McLain Category Boiler

Documents that we receive from a manufacturer of a Weil-McLain 105 can be divided into several groups. They are, among others:
- Weil-McLain technical drawings
- 105 manuals
- Weil-McLain product data sheets
- information booklets
- or energy labels Weil-McLain 105
All of them are important, but the most important information from the point of view of use of the device are in the user manual Weil-McLain 105.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Weil-McLain 105, service manual, brief instructions and user manuals Weil-McLain 105. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Weil-McLain 105.

A complete manual for the device Weil-McLain 105, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Weil-McLain 105 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Weil-McLain 105.

A complete Weil-McLain manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Weil-McLain 105 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Weil-McLain 105, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Weil-McLain 105, that we can find in the current document
3. Tips how to use the basic functions of the device Weil-McLain 105 - which should help us in our first steps of using Weil-McLain 105
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Weil-McLain 105
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Weil-McLain 105 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Weil-McLain 105?

Use the form below

If you did not solve your problem by using a manual Weil-McLain 105, ask a question using the form below. If a user had a similar problem with Weil-McLain 105 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)