Manual Hobart ML-136500

24 pages 1.43 mb
Download

Go to site of 24

Summary
  • Hobart ML-136500 - page 1

    INSTALLATION & OPERATIONAL MANUAL 1HFD & HFC SERIES ELECTRIC FRYERS With KleenScreen PLUS ® Filtration Systems MODELS: 1HF50D ML-136500 1HF85CF ML-136819 1HF85CF Shown - Computer Control ENERGY STAR® Qualified For additional information on Hobart or to locate an authorized parts and service provider in your area, visit our website at www. ...

  • Hobart ML-136500 - page 2

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -2- IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRIC EQUIPMENT, WHO SHOULD PER FORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABL ...

  • Hobart ML-136500 - page 3

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -3- TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY……………………………… ………. 2 INTRODUCTION…………………… …………………………………… … 4 GENERAL…………………………… ……………………………… 4 ORDERING PARTS…? ...

  • Hobart ML-136500 - page 4

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -4- INTRODUCTION GENERAL Hobart Fryers are produced wit h quality workmanship and mate rial. Proper installation, usage and maintenance will result in year s of satisfactory performance. Before installing the fryer, thoroughly read th is manual and carefully fo llow all instructio ...

  • Hobart ML-136500 - page 5

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -5- Do not use the door or its handle to lift the fryer. MODEL - GMO Kw per Fry Tank Width Inch (cm) Total System Shortening lbs. (kg) Each Fry Tank 1HF50D 17 15.5" (39) 50 (23) 1HF85CF 24 21.0" (53) 85 (39) Voltage ranges are: 208, 3 Phase - 50 – 60 Hz 240, 3 Phase - ...

  • Hobart ML-136500 - page 6

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -6- CODES AND STANDARDS The fryer must be instal led in accordance with: In the United States:  State and local codes, or in the absence of local codes, with:  National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The National Fire Protection A ...

  • Hobart ML-136500 - page 7

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -7-  Australia, use only the caster suppl ied by the manufactu rer for the fryer device. The fryer must be installed usi ng a hose assembly restraining device to limit the movement of the appli ance in accordance with AS1869.  The fryer must be installed with a connector (no ...

  • Hobart ML-136500 - page 8

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -8- LEVELING THE FRYER Check the level of the fryer by placing a level on top of the fr yer after electrical connections have been made. Ensure that the fryer is level front-to-back and side-to-side in the final installed position. If using casters, lock the wheels after unit is l ...

  • Hobart ML-136500 - page 9

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -9-  Wipe tank completely dry with a soft, clean cloth. FILLING TANK WITH SHORTENING  Close the drain valve.  Fill the fryer tank with shortening. Hobart recommends using liquid shortening.  Shortening level should be between the MIN and MAX lines in the fryer tank. ? ...

  • Hobart ML-136500 - page 10

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -10-  Batter covered foods should be dropped carefully , one by one, into shortening or basket. If you use the basket, first dip the basket into the shortening to reduce batter-build up on basket surfaces.  When frying is completed, remove ba sket or product. Hang basket on ...

  • Hobart ML-136500 - page 11

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -11- Programming the Solid State Control ...

  • Hobart ML-136500 - page 12

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -12- Programming the Computer Control ...

  • Hobart ML-136500 - page 13

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -13- TURNING OFF THE FRYER  Open the door to the fryer. Press t he power switch to the OFF position. EXTENDED SHUTDOWN 1. Open the door to the fryer. Press the power switch to the OFF position. 2. Thoroughly drain the fryer. Refer to DRAINING THE FRYER. 3. Clean the fryer accor ...

  • Hobart ML-136500 - page 14

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -14- DRAINING THE TANK 1. Open the door to the fryer. The power must remain ON for the fryer to filter correctly. 2. Insert the drain extension into t he drain valve. Tighten only hand tight. 3. Direct the drain spout into the container that you want to drain the shortening into. ...

  • Hobart ML-136500 - page 15

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -15- 9. Drain the tank according to DRAINING TH E TANK. Rinse thoroughly with clear, hot water. All traces of cleaner must be removed. Dry the tank thoroughly. 10. Close the drain valve and add shorteni ng. Follow the FILLING TANK WITH SHORTENING procedure in this manual. The frye ...

  • Hobart ML-136500 - page 16

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -16- KleenScreen Plus ® Filtration System Installation and Operational Manual for “HFF” Models 1HF85CF Shown Electric KleenScreen PLUS® Models 8 1HF85CF ML-136819 ...

  • Hobart ML-136500 - page 17

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -17- Filtering Instructions for KleenScreen PLUS ® Fryers General The KleenScreen PLUS ® filtration system filters the oil as it is pumped back into its’ respective tank(s). Only one tank can be drained and filter ed at a time. Under no circumstances should both tanks be drain ...

  • Hobart ML-136500 - page 18

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -18- Fully assembled filter screen assembly: F i g . 2 Secure Tube with Suction Tube Clip Filter Screen Lays Flat On Bottom of Filter Pan Fig. 3 Micro-Filtration Fabric Envelope Assembly: Same Suction Tube F a b r i c E n v e l o p e I n s e r t (Different from Screen Assembly) Fa ...

  • Hobart ML-136500 - page 19

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -19- INSTRUCTIONS TO REMOVE & REPLACE KLEENSCREE N PLUS ® FILTER ENVELOPE FOR ABSOLUTE FILTRATION & MAXIMUM FLOW RATE WE RECOMME ND YOU CHANGE YOUR FI LTER ENVELOPES AT EVERY OIL CHANGE (10-14 DAYS DEPENDING ON OIL USAGE). Step 1 Discard all oil from the filter vessel, (s ...

  • Hobart ML-136500 - page 20

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -20- Operation Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer. Spilling hot frying compound can cause severe burns. Do not move fryer wi thout draining all frying compound from the tank. Never run water or boil out solution thr ough fi ...

  • Hobart ML-136500 - page 21

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -21- Filtering Instructions for KleenScreen PLUS ® Fryers with Computer Controls ...

  • Hobart ML-136500 - page 22

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -22- FILTERING TIP: Open the filtering drawer approximately 1” to allow any oil in the re turn line to run back into the filter pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter components. REMOVING EXCESS DEBRIS FROM THE SCREEN FI ...

  • Hobart ML-136500 - page 23

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -23- BOIL OUT PROCEDURE: Use the Boil Out By-Pass™ drai n extension allowing the boil out solution to exit the fry t ank without using the filtering system. Do not allow water to run through the motor / pump. Drain the boil out solution into a bucket or place a hose on the end o ...

  • Hobart ML-136500 - page 24

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -24- MAINTENANCE Hot oil and hot parts can cause burns. Use care when operating, cleani ng, and servicing the fry er. Spilling hot fryer com pound can cause severe burns. Do not move fryer without draining all frying com pound from the tank. Service in the US and Canada Contact yo ...

Manufacturer Hobart Category Clothes Dryer

Documents that we receive from a manufacturer of a Hobart ML-136500 can be divided into several groups. They are, among others:
- Hobart technical drawings
- ML-136500 manuals
- Hobart product data sheets
- information booklets
- or energy labels Hobart ML-136500
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hobart ML-136500.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hobart ML-136500, service manual, brief instructions and user manuals Hobart ML-136500. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hobart ML-136500.

Similar manuals

A complete manual for the device Hobart ML-136500, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hobart ML-136500 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hobart ML-136500.

A complete Hobart manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hobart ML-136500 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hobart ML-136500, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hobart ML-136500, that we can find in the current document
3. Tips how to use the basic functions of the device Hobart ML-136500 - which should help us in our first steps of using Hobart ML-136500
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hobart ML-136500
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hobart ML-136500 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hobart ML-136500?

Use the form below

If you did not solve your problem by using a manual Hobart ML-136500, ask a question using the form below. If a user had a similar problem with Hobart ML-136500 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)