English dropdown-ico

Manual RedMax AG4300

24 pages 0.57 mb
Download

Go to site of 24

Summary
  • RedMax AG4300 - page 1

    The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. WARNING OWNER / OPERA T OR MANUAL POWER AUGER T4507-93110 (603) AG4300 Thank you for purchasing a RedMax product. Before using our power auger, please read this manual carefully to understand the proper ...

  • RedMax AG4300 - page 2

    Read this manual carefully to understand all safety precautions, controls, proper operation and maintenance of your RedMax power auger . Failure to do so could result in serious injury . Instructions labeled as shown at left concern critical steps or procedures which must be followed in order to prevent accidents which could lead to serious bodily ...

  • RedMax AG4300 - page 3

    CONTENTS 1. SAFETY PRECAUTIONS .............................................................................. 4 IN ORDER TO ENSURE PROPER AND SAFE OPERATION OF YOUR POWER AUGER WORK GEAR AND CLOTHING WARNINGS CONSIDERING HANDLING OF FUEL THINGS TO CHECK BEFORE USING YOUR POWER AUGER THINGS TO CHECK BEFORE STARTING UP THE ENGINE AVOID NOISE PROBLEM ...

  • RedMax AG4300 - page 4

     4  ■ In order to ensure proper and safe operation of your power auger • Read this Owner/Operator Manual carefully. Be sure you understand how to operate this unit properly before you use it. Failure to do so could result in serious injury. • Be sure to keep this manual handy so that you may refer to it later whenever any questions aris ...

  • RedMax AG4300 - page 5

    ■ Work gear and clothing • When using your power auger, always be sure to wear strong, durable, work clothing; shirts should be long-sleeved shirts and pants should be full-length pants reaching down to the ankles. • Always be sure to wear and helmet and face protector when using your power auger. • When using your power auger, always be su ...

  • RedMax AG4300 - page 6

     6  ■ Things to check before using your power auger • Before beginning work, look around carefully to get a feel for the shape of the land, and whether or not there are any obstacles which might get in the way while working, and remove any obstacles which can be cleared away before beginning work. • The area within a perimeter of 45 fee ...

  • RedMax AG4300 - page 7

    ■ Things to be careful about when using your power auger • When using your power auger, grip the handles of the power auger firmly with both hands, place your feet slightly apart (slightly further apart than the width of your shoulders) so that your weight is distributed evenly across both legs, and always be sure to maintain a steady, even pos ...

  • RedMax AG4300 - page 8

     8  ■ Notes on care and maintenance of your power auger • In order to maintain your power auger in proper working order, perform the maintenance and checking operations described in this manual at regular intervals. In the event that any parts must be replaced or any maintenance or repair work not described in this manual must be performe ...

  • RedMax AG4300 - page 9

    2. Fuel  9  ■ RECOMMENDED MIXING RATIO GASOLINE 50:OIL 1 (when using ZENOAH genuine oil) • Exhaust emission are controlled by the fundamental engine parameters and components(eq., carburation, ignition timing and port timing) without addition of any major hardware or the introduction of an inert material during combustion. • These engin ...

  • RedMax AG4300 - page 10

    5. In the case of storing the product for a long period of time, clean the fuel tank after rendering it empty. Next, activate the engine and empty the carburetor of the composite fuel. 6. In the case of scrapping the used mixed oil container, scrap it only at an authorized repository site. As lot details of quality assurance, read the description i ...

  • RedMax AG4300 - page 11

    3. Operation ■ INSTALLING LEFT GRIP (F1) • Screw in the left grip to the bracket provided on the frame and tighten the lock nut securely. (1) Left grip (2) Bracket (3) Lock nut ■ INSTALLING DRILL (F2) 1. Slide the ring clip and remove the lock pin from the drill. 2. Put the drill onto the auger output shaft and insert the lock pin. Cover it w ...

  • RedMax AG4300 - page 12

    3. Operation aspect while holding the throttle lever, and set the throttle lever in the start position. (F6) (1) Engine switch (2) Start (3) Stop (4) Choke lever (5) Open (6) Close (7) Primer pump (8) Throttle lever (9) Lock button 6. While supporting the auger with your left waist and left hand as shown in the figure, pull the starter rope, first ...

  • RedMax AG4300 - page 13

    3. Operation hands. •A reacting motion may occur on the auger when spinning drill has hit on stones or tree roots under the ground. Always hold the auger securely to control such motion. • Start drilling with half-throttle, and gradually increase the engine speed so that the drill may get into the ground smoothly. • When the drill has been ca ...

  • RedMax AG4300 - page 14

    4. Maintenance Before cleaning, inspecting or repairing the auger, make sure that the engine has stopped and cooled down. Disconnect the spark plug terminal to avoid accidental engine starts. ■ DAILY INSPECTION • Check all nuts and screws are securely tightened and no parts are missing. • Check for leakage of fuel. ■ PERIODICAL INSPECTION A ...

  • RedMax AG4300 - page 15

    4. Maintenance CYLINDER FINS (F16) Dust clogging between the cylinder fins will cause overheating of the engine. Periodically check and clean the cylinder fins. (1) Intake air cooling vent SPARK ARRESTER (F17) This engine is equipped with a spark arresting screen at the exhaust port. Check periodically to see if it is good condition, especially whe ...

  • RedMax AG4300 - page 16

     16  5. Storage ■ Before Long-term Storage • Drain fuel tank and run engine out until all fuel in the carburetor is used up. • Remove the spark plug and drop a spoonful 2 cycle oil into the cylinder. Crank the engine several times and replace the plug. Pull starter until compression is felt. • Brush off dirt from the drill surface and ...

  • RedMax AG4300 - page 17

    7. Parts list NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. KOMATSU ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company. 3. When placing parts orders for repair and/or replacement, check if the model name and the ...

  • RedMax AG4300 - page 18

    Fig.1 ENGINE UNIT AG4300 (S/N 100101 and up)  18  7. Parts list ...

  • RedMax AG4300 - page 19

     19  Fig.1 ENGINE UNIT AG4300 (S/N 100101 and up) Key# Description Part Number Q'ty 1 CYLINDER 848-G6D-12A0 1 2 BOLT 1850-12130 4 3 GASKET,base 4500-13120 1 4 CRANKCASE COMP. 4500-21101 1 5• PIN 2629-21130 3 6 GASKET,case 4500-21140 1 7 BEARING 06030-06201 2 8O IL SEAL 4810-21210 1 9O IL SEAL 1650-21220 1 10 BOLT 01252-30530 4 11 SNAP ...

  • RedMax AG4300 - page 20

    7. Parts list  20  Fig.2 DRILL and ACCESSOR Y GROUP AG4300 (S/N 100101 and up) ...

  • RedMax AG4300 - page 21

    Fig.2 DRILL and ACCESSOR Y GROUP AG4300 (S/N 100101 and up) Key# Part Number Description Q'ty 1 3209-11103 Gear Case Comp 1 2 3209-11203 Cover Comp 1 3 1800-21281 Oil Seal 1 4 3202-11260 Gasket 1 5 0260-30620 Screw 6 6 06000-06304 Bearing 1 7 3202-11311 Retainer 1 8 3202-11320 Oil Seal 1 9 3200-11330 O-Ring 1 10 07000-02012 O-Ring 1 11 04065-0 ...

  • RedMax AG4300 - page 22

    EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY OF THE UNIT, RedMax / KOMATSU ZENOAH AMERICA, INC., THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OF CHARGE, FOR THE ORIGINAL AND EACH SUBSEQUENT PURCHASER, ANY PART OR PARTS FOUND TO BE DEFECTIVE IN MATERIAL AND/OR WORKMANSHIP. EMISSION-RELATED PARTS ARE: THE CA ...

  • RedMax AG4300 - page 23

    Pièces en rapport avec les émissions de gaz d'échappement : RedMax / KOMATSU ZENOAH AMERICA, INC., par l'intermédiaire de n'importe quel revendeur RedMax, réparera gratuitement ou remplacera gratuitement pour l'acheteur initial et chaque acheteur successif toute(s) pièce(s) se révélant de constitution et/ou de montage d? ...

  • RedMax AG4300 - page 24

    KOMATSU ZENOAH AMERICA INC. 4344 Shackleford Road Suite 500 Norcross, Georgia 30093 ©P rinted in Japan ...

Manufacturer RedMax Category Drill

Documents that we receive from a manufacturer of a RedMax AG4300 can be divided into several groups. They are, among others:
- RedMax technical drawings
- AG4300 manuals
- RedMax product data sheets
- information booklets
- or energy labels RedMax AG4300
All of them are important, but the most important information from the point of view of use of the device are in the user manual RedMax AG4300.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals RedMax AG4300, service manual, brief instructions and user manuals RedMax AG4300. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product RedMax AG4300.

Similar manuals

A complete manual for the device RedMax AG4300, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use RedMax AG4300 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of RedMax AG4300.

A complete RedMax manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual RedMax AG4300 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the RedMax AG4300, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the RedMax AG4300, that we can find in the current document
3. Tips how to use the basic functions of the device RedMax AG4300 - which should help us in our first steps of using RedMax AG4300
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with RedMax AG4300
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of RedMax AG4300 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning RedMax AG4300?

Use the form below

If you did not solve your problem by using a manual RedMax AG4300, ask a question using the form below. If a user had a similar problem with RedMax AG4300 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)