English dropdown-ico

Manual Troy-Bilt 128T

20 pages 1.5 mb
Download

Go to site of 20

Summary
  • Troy-Bilt 128T - page 1

    Operator ’ s Manual T iller/Edger Model 128T W arning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-cov- ered or grass-covered land unless the engine ’ s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark ...

  • Troy-Bilt 128T - page 2

    2 For more details about your unit, visit our website at www .troybilt.com T ABLE OF CONTENTS Content Page Calling Customer Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Troy-Bilt 128T - page 3

    TRAINING • Read this Owner’ s Manual and the sep- arate Engine Owner’ s Manual ver y care- fully before operating this equipment. Be completely familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly . A replacement Manual is available by contacting your authorized dealer or ...

  • Troy-Bilt 128T - page 4

    • Exercise extreme caution when on or crossing gravel drives, walks or roads. Stay alert for hidden hazards or traffic. Do not carry passengers. • After striking a foreign object, stop the engine, let all moving parts come to a complete stop, disconnect the spark plug wire and prevent it from touching the spark plug, then carefully inspect the ...

  • Troy-Bilt 128T - page 5

    INTRODUCTION Read these instructions in their entirety before you attempt to assemble or op- erate your new equipment. The Border/Edger Attachment (H, Figure 5) does not need to be installed until you are ready to do edging projects (refer to instructions in this Section). IMPORT ANT : The correct mixture of un- leaded automotive gasoline and two-c ...

  • Troy-Bilt 128T - page 6

    6 4. Do not mix fuel directly in engine fuel tank. Always use a clean, safety-ap- proved fuel container . • T o Mix: A. Fill a clean, approved container one quarter full with recommended gasoline. B. Add recommended amount of oil per Chart 1: FUEL MIXTURE. C. Screw cap on container and shake vigorously . Then unscrew cap and fill container with g ...

  • Troy-Bilt 128T - page 7

    Features and Controls 3 Section KNOW YOUR EQUIPMENT READ THIS OWNER ’ S MANUAL AND ALL SAFETY RULES BEFORE OPERA TING YOUR EQUIPMENT . Know the location and function of all features and controls on the equipment. Save this manual for future reference. 7 Handlebar Height Adjustment Knob (B, Figure 5) T wo height settings, plus a storage position a ...

  • Troy-Bilt 128T - page 8

    PRE-ST AR T PREP ARA TION Before starting the engine, perform the following checks and services: 1. Disconnect the spark plug wire from the spark plug. 2. Move the engine On/Off switch to the OFF position. 3. Check the three plastic cable ties (J, Figure 5). Be sure that cables and ties are positioned as shown. Do not kink or pinch the control cabl ...

  • Troy-Bilt 128T - page 9

    Allow the engine to warm up for several seconds. If engine either fails to start or to continue running, push in primer bulb two (2) times. Grasp starter rope and pull with a rapid, full stroke, up to ten (10) times. TROUBLESHOOTING: Push the primer bulb in two (2) more times. Using a rapid full stroke, pull out the starting rope up to ten (10) tim ...

  • Troy-Bilt 128T - page 10

    10 USING THE EDGER A TT ACHMENT The Edger Attachment makes clean, sharp edges next to walkways, driveways, paths, planted areas, patios, etc. See Assembly Steps, STEP 4: in Section 2 for instructions on attaching this attachment. T ake your time when edging. Decide how far away the edge is to be from the walk or drive, then slowly proceed using the ...

  • Troy-Bilt 128T - page 11

    EQUIPMENT MAINTENANCE T ransmission Maintenance The transmission was lubricated at the factory and should not require any further lubrication. However , you should check the lubricant level after the first five (5) hours of opera- tion and every twenty-five (25) operating hours thereafter . If needed, use a high- quality , automotive-grade petroleu ...

  • Troy-Bilt 128T - page 12

    If the engine is running poorly or has low power while tilling, an adjustment to the carburetor may solve the problem. How- ever , first inspect and service the spark plug and the air filter before making a carburetor adjustment. If the engine con- tinues to run poorly (and the fuel mixture is fresh), proceed to the following carbu- retor adjustmen ...

  • Troy-Bilt 128T - page 13

    Arranging Tines for Stony Soil Conditions 1. Prop the machine forward so it rests on the front of the tubular carrying handle. The work surface should be flat and firm. 2. Remove the hitch pin (A, Figure 16) from both sides of the unit. Remove both outer tine sections. Mark each section as a left or right side tine and whether it is an inner or out ...

  • Troy-Bilt 128T - page 14

    14 TROUBLESHOOTING Before performing any of the corrections in this T roubleshooting Chart, refer to the appropriate information contained in this Manual and the Engine Owner ’ s Manual for the correct safety precautions and ser vicing procedures. Contact your local authorized Engine Service Dealer for engine ser vice. Contact your local authoriz ...

  • Troy-Bilt 128T - page 15

    15 1 1915039 T ransmission Case - left-side. (Incl. pressed-in bushing) . . . . . . . . . . . . 1 2 1915040 T ransmission Case - right-side. (Incl. pressed-in bushing) . . . . . . . . . . . . 1 3 1983632 Oil Seal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 4 1918307 Worm Input Shaft Assembly . . . . . . . . . . . . . 1 5 1983731 Inp ...

  • Troy-Bilt 128T - page 16

    16 1 5 13 13 13 17 18 46 42 42 SEE PREVIOUS P AGE 49 48 47 21 31 32 34 33 26 28 29 30 25 24 23 22 27 43 42 42 18 19 19 38 39 41 40 40 36 37 35 45 16 15 14 45 4 6 9 3 8 44 44 7 Parts List Model 128T ...

  • Troy-Bilt 128T - page 17

    17 1 1918303 Handlebar Assembly . . . . . . . . . . . . . . . . . . 1 3 777I00007 Decal - Starting Stabilization . . . . . . . . . . . . 1 4 777I00009 Decal - Throttle/T ines Lever Operation . . . . . 1 5 1917451 Handlebar Grip, PVC . . . . . . . . . . . . . . . . . . 2 6 1918123 Throttle/Tines Lever and Cable . . . . . . . . . . . 1 7 1750608 Pan ...

  • Troy-Bilt 128T - page 18

    18 Notes ...

  • Troy-Bilt 128T - page 19

    19 A ccessories and Attachments . . . . . . . . . . . . . . . . . . . . . . .14 Aerator Attachment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14 Air Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11 Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 B orders ...

  • Troy-Bilt 128T - page 20

    MANUF ACTURER’S LIMITED W ARRANTY FOR: The limited warranty set forth below is given by T roy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. T roy-Bilt LLC warrants this product against defects for a period of two (2) years commencing on the date of original purchase and will, at ...

Manufacturer Troy-Bilt Category Edger

Documents that we receive from a manufacturer of a Troy-Bilt 128T can be divided into several groups. They are, among others:
- Troy-Bilt technical drawings
- 128T manuals
- Troy-Bilt product data sheets
- information booklets
- or energy labels Troy-Bilt 128T
All of them are important, but the most important information from the point of view of use of the device are in the user manual Troy-Bilt 128T.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Troy-Bilt 128T, service manual, brief instructions and user manuals Troy-Bilt 128T. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Troy-Bilt 128T.

Similar manuals

A complete manual for the device Troy-Bilt 128T, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Troy-Bilt 128T by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Troy-Bilt 128T.

A complete Troy-Bilt manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Troy-Bilt 128T - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Troy-Bilt 128T, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Troy-Bilt 128T, that we can find in the current document
3. Tips how to use the basic functions of the device Troy-Bilt 128T - which should help us in our first steps of using Troy-Bilt 128T
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Troy-Bilt 128T
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Troy-Bilt 128T in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Troy-Bilt 128T?

Use the form below

If you did not solve your problem by using a manual Troy-Bilt 128T, ask a question using the form below. If a user had a similar problem with Troy-Bilt 128T it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)