Manual Festool C12

20 pages 0.31 mb
Download

Go to site of 20

Summary
  • Festool C12 - page 1

    1 469 038_002 Manual de instrucciones Página 14 - 19 IMPORTANTE: Lea y comprende todas las instrucciones antes de usar. Guide d’utilisation P age 8 - 13 IMPORTANT: Lire et comprendre toutes les instructions avant de démarrer les travaux. Instruction manual P age 2 - 7 IMPORTANT: Read and understand all instructions before using. Cordless Drill ...

  • Festool C12 - page 2

    2 GENERAL SAFETY RULES Read and understand all instruc- tions. F ailure to follow all instructions listed below may result in electric shock, fi re and/or serious personal injury . SAVE THESE INSTRUCTIONS 1) Work area safety a) Keep work area clean and well lit. Cluttered and dark areas invite accidents. b) Do not operate power tools in explosive ...

  • Festool C12 - page 3

    3 Technical data Cordless drill/screwdriver C 12 Motor voltage 12 V Idle-running speed: 1. speed / 2. speed 0 – 450 rpm / 0 – 1500 rpm Max torque: soft case / hard case 18 Nm / 30 Nm Adjustable torque: 1. speed / 2. speed 2 – 7 Nm / 0.5 – 2.5 Nm Chuck capacity 1.5 – 13 mm Max. drill diameter for metal / wood 14 mm / 25 mm T ool fi tting ...

  • Festool C12 - page 4

    4 Symbols V volts A amperes Hz hertz W watt ~ alternating current n 0 no load speed Class II Construction rpm revolutions per minute Intended use Cordless drills are suitable for drilling metal, wood, plastics and similar materials, as well as tighten- ing and screwing in screws (into wood, up to a diameter of 6 mm). The LC 45 battery charger is de ...

  • Festool C12 - page 5

    5 Chuck BF-FX The chuck is used to clamp drills and bits. Fitting: - Place the chuck on the drill spindle (2.5) and twist until the hexagon key (2.4) of the chuck latches into the hexagon socket of the drill spindle. - Pull the unlocking ring (2.3) forwards, press the chuck onto the drill spindle up to the stop and release the unlocking ring. Rem o ...

  • Festool C12 - page 6

    6 The LED (3.2) indicates the respective charg- ing state of the charger. LED yellow – steady: charger is ready for use. LED green – fl ashing: battery pack being charged. LED green – steady: battery pack fully charged, conservation charge on. LED red – fl ashing: general malfunction, e. g. full contact not being made, short-circuit, batt ...

  • Festool C12 - page 7

    7 Accessories, tools F or safety reasons, only use original F estool accessories and tools! The accessory and tool order number can be found in your F estool catalog or on the Internet at www. festool-usa.com . Warranty Conditions of 1+2 Warranty Y ou are entitled to a free extended warranty (1 year + 2 years = 3 y ears) for your F estool power too ...

  • Festool C12 - page 8

    8 RÈGLES DE SÉCURITÉ GÉNÉRALES Assurez-vous de lire et de bien com prendre toutes les instructions. Le non-respect, même partiel, des instructions ci- dessous peut entraîner un risque de choc électri- que, d’incendie et/ou de blessures gra ves. CONSERVEZ CES INSTRUCTIONS 1) Sécurité de aire de travail a) Maintenez l’endroit de travail ...

  • Festool C12 - page 9

    9 Caractéristiques techniques Perceuse-visseuse C 12 T ension du moteur 12 V Vitesse à vide: 1 ère vitesse / 2 ème vitess 0 – 450 tr/min / 0 – 1500 tr/min Couple max.: vissage faciles / vissage diffi ciles 18 Nm / 30 Nm Réglage de couple: 1 ère vitesse / 2 ème vites 2 – 7 Nm / 0.5 – 2.5 Nm Capacité mandrin 1.5 – 13 mm Maxi capaci ...

  • Festool C12 - page 10

    10 Symbole V V olt A Ampère Hz Hertz W W att ~ T ension alternative n 0 Vitesse de rotation à vide Classe II conception tr/min tours par minute Utilisation prévue La perceuse-visseuse sans fi l est adaptée au per- çage du métal, du bois, des plastiques et maté- riaux similaires, ainsi qu’au vissage (vis jusqu’à un diamètre de 6 mm dan ...

  • Festool C12 - page 11

    11 Réglage du couple de rotation Il est possible de faire varier le couple de rotation en tournant la bague de réglage (1.4). La fl èche apposée (1.5) indiquera l’état réglé. P erçage Couple de rotation maximal - la fl èche est pointée sur le symbole de perçage Vissage Couple de rotation en fonction du réglage: • P osition sur 1 = ...

  • Festool C12 - page 12

    12 Porte-outil CENTROTEC-WH-CE Le porte-outil CENTRO TEC permet un change- ment rapide d’outils a vec arbre CENTRO TEC. Risque de blessure ! Mani pulez très prudemment l’outil aux arêtes tranchan tes lorsque vous procédez à un échange d’outil, portez éventuelle-ment des gants de protection. Ne serrez pas les outils CEN- TRO TEC au nivea ...

  • Festool C12 - page 13

    13 de dommages résultant d’une violation de cette prescription. • V eiller à ce que les contacts de raccordement sur l’outil électrique, sur le chargeur et sur l’accu-mulateur soient toujours propres. • En laissant l’accumulateur dans le chargeur prêt à fonctionner , l’accumulateur est conservé en état chargé grâce à un char ...

  • Festool C12 - page 14

    14 NORMAS GENERALES DE SEGURI- DAD Lea y entienda todas las ins- trucciones. El incumplimiento con las instruccio- nes aquí referidas puede resultar en una descarga eléctrica, fuego y/o lesiones personales serias. CONSERVE ESTAS INSTRUCCIONES 1) Seguridad del espacio de trabajo a) Mantenga limpio y bien iluminado su pues - to de trabajo. El desor ...

  • Festool C12 - page 15

    15 do, ni tampoco después de haber consumido alcohol, drogas o medicamentos. El no estar atento durante el uso de una herr amienta eléctrica puede provocarle serias lesiones. b) Utilice un equipo de protección y en todo caso unas gafas de protección. El riesgo a le- sionarse se reduce considerablemente si, depen- diendo del tipo y la aplicació ...

  • Festool C12 - page 16

    16 Datos técnicos Taladro atornillador C 12 P otencia del motor 12 V V elocidad en vacío: 1ª marcha / 2ª marcha 0 - 450 rpm / 0 - 1500 rpm P ar de apriete máximo: en lugares blandos / duros 18 Nm / 30 Nm P ar de apriete regulable: 1ª marcha / 2ª marcha 2 - 7 Nm / 0.5 - 2.5 Nm Alcance del portabrocas 1.5 - 13 mm Diámetro máx. perforación e ...

  • Festool C12 - page 17

    17 Ta l a d r a r La fl echa de marca mira hacia el símbolo de tala- drar = par de apriete máximo . Atornillar P ar de apriete según el ajuste: • P osición en 1 = par de apriete bajo • P osición en 20 = par de apriete alto Funcionamiento P onerlo en funcionamiento con el pulsador (1.1). Según la presión que se ejerza sobre el pulsador v ...

  • Festool C12 - page 18

    18 (2.4) del portabrocas se enclave en la toma hexagonal interior del husillo portabrocas. - Estire la anilla de desbloqueo (2.3) hacia ade- lante, apriete el portabrocas sobre el husillo portabrocas hasta el tope y suelte la anilla de desbloqueo. Desmontaje: - Estire la anilla de desbloqueo hacia adelante y quite el portabrocas. Cambiar la herrami ...

  • Festool C12 - page 19

    19 El cargador está listo para ser usado . LED verde – intermitente: El juego de acu-muladores está cargado. LED verde – permanente: Juego de acumuladores cargado; cargador con carga de matenimiento. LED rojo – intermitente: Indicación general de error , por ej. mal puesto, defectuoso, o cortocircuito . LED rojo – permanente: T emperatur ...

  • Festool C12 - page 20

    20 Garantiá Condiciones de la Garantía 1 + 2 Usted tiene derecho a una garantía extendida gratuita (1 año + 2 años = 3 años) par a su he- rramienta mecánica F estool. Festool se hará res- ponsable por los gastos de envío dur ante el primer año de garantía. Dur ante el segundo y tercer año de garantía el cliente es responsable por el co ...

Manufacturer Festool Category Drill

Documents that we receive from a manufacturer of a Festool C12 can be divided into several groups. They are, among others:
- Festool technical drawings
- C12 manuals
- Festool product data sheets
- information booklets
- or energy labels Festool C12
All of them are important, but the most important information from the point of view of use of the device are in the user manual Festool C12.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Festool C12, service manual, brief instructions and user manuals Festool C12. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Festool C12.

Similar manuals

A complete manual for the device Festool C12, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Festool C12 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Festool C12.

A complete Festool manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Festool C12 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Festool C12, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Festool C12, that we can find in the current document
3. Tips how to use the basic functions of the device Festool C12 - which should help us in our first steps of using Festool C12
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Festool C12
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Festool C12 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Festool C12?

Use the form below

If you did not solve your problem by using a manual Festool C12, ask a question using the form below. If a user had a similar problem with Festool C12 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)