Manual Siemens TPS3 15

16 pages 1.27 mb
Download

Go to site of 16

Summary
  • Siemens TPS3 15 - page 1

    User Manual - USA TPS3 12 & TPS3 15 Surge Prot ective De vice ...

  • Siemens TPS3 15 - page 2

    • Only qualified licensed electricians should install or ser vice SPDs • Hazardous voltages e xist within SPDs • SPDs should never be installed or serviced when energized • Use appropriat e safe ty precautions including Personal Pro tection Eq uipment • F ailure t o follo w these instructions can result in death, serious injury , and/or ...

  • Siemens TPS3 15 - page 3

    T able of Contents F AILURE T O FOLLO W THESE INSTRUCTIONS COULD RESUL T IN DEA TH OR SERIOUS INJURY .............................. 2 Do Not Hi-Po t T est SPDs ............................................................................................................................................................................ 2 INTRODUCTION .. ...

  • Siemens TPS3 15 - page 4

    Introduction Thank you for choosing Siemens TPS3 Surge Pro tective Device (SPD). This is a high quality , high energy surge suppres sor designed to prot ect sensitive equipment fr om damaging transient overvoltages. Proper installation is important to maximize per formance. Please follo w the steps outlined herein. This entire User Manual should be ...

  • Siemens TPS3 15 - page 5

    2008 NEC Ar t 285 & UL 1449-3 SPD T ypes: T ypes 1, 2, 3, & 4 Based on Location within electrical distribution system (also coincides with ANSI/IEEE C62.41.2 - 2002 Categories C, B &A) Figure 1: SPD T ypes General Information Product F amily Outline TPS3 12 – Single Module in enclosure TPS3 15 – T wo Modules in enclosure Each is ava ...

  • Siemens TPS3 15 - page 6

    TPS SERIES DESCRIPTION TPS3 12 Externally mount ed SPD, single module in enclosure, standard modes of pr ot ection TPS3 L12 Externally mount ed SPD, single module in enclosure, 10 modes of pr otection TPS3 15 Externally mount ed SPD, dual replaceable modules in enclosure, standard modes of pr ot ection TPS3 L15 Externally mount ed SPD, dual replace ...

  • Siemens TPS3 15 - page 7

    Parallel Connection This is a Parallel connected SPD – not series connected. As outlined previousl y , an SPD ‘drains of f ’ excessiv e voltage fr om an electrical system. Because of parallel connection, installation of the SPD reasonably near the eq uipment to be pro tect ed is satisfactory. Tip: It is ver y important that wiring leads be co ...

  • Siemens TPS3 15 - page 8

    T able 2: Weight & Dimensions TPS3 12 H/W/D (in./mm.) Weight Standar d Enclosure 12" x12" x 7.5" (305x305x191) 22 lbs (10 kg) Standar d Enclosure, 400 – 500kA with Opt. Disc. Switch 16" x 14" x 6" (496x356x152) 32 lbs (14.5 kg) 4X Non-Metallic 14" x 12" x 7" (356x305x178) 14 lbs (6.4 kg) 4X Non-Met ...

  • Siemens TPS3 15 - page 9

    T erminals T erminals will accept 14 - 2 A WG conductor and are provided for line (phase), neutral (if used), and equipment safety ground connections. 8 A WG is the minimum recommended wire size because UL testing and evaluation was performed using 8 A WG. Wire Size and Installation T orque This is a parallel-connected SPD; it is not series-connect ...

  • Siemens TPS3 15 - page 10

    Optional Flush Mount Installation Considerations The TPS3 12 and TPS3 15 are appro ximately 6” deep. The unit will not mount flush unless there is at least 6” of depth clearance. The TPS3 12 and TPS3 15 are not designed to mount flush on a typical 2 x 4 stud wall. Back Flange Mounting: Mount as close as possible to protect ed panel. Creat e a ...

  • Siemens TPS3 15 - page 11

    PRE-PL AN INST ALL A TION TO ACC OMPLISH THE FOLLO WING: • Meet all National and Local codes (NEC® Ar ticle 285 addresses SPDs) • Mount SPD as close to panel or equipment as possible to keep leads short • Ensure leads are as shor t and straight as possible, including neutral and ground. Consider a break er position that is closest to the SPD ...

  • Siemens TPS3 15 - page 12

    Figure 4: Electrical Dra wings Figur e 1 SPLIT 2 Hots, 1 Neu, 1 Grnd Hot (BLK) Hot (BLK) Neutral (WHT ) V V } } Ground (GRN ) Figur e 2 WYE 3 Hots, 1 Neu, 1 Grnd } Phase A (BLK) Phase B (BLK) Neutral (WHT ) Phase C (BLK) Ground (GRN ) A C N V B Figur e 3 HI-LEG DEL T A (B High) 3 Hots, (B HIGH), 1 Neu, 1 Grnd Phase A (BLK) Phase B (ORNG) Neutral (W ...

  • Siemens TPS3 15 - page 13

    Phase A, B & C: Green LED indicators—one per phase. Green is good. Extinguished green LED indicates loss of prot ection. Every suppres sion element in this SPD is monitor ed. N-G suppres sion element monitoring is logic-connected t o Phase A. Ser vice LED (red): LED illuminates in the event of problems. This indicator is logic-connected to th ...

  • Siemens TPS3 15 - page 14

    Dr y Contact Option T wo sets of Form C dr y contacts are included with the Dr y Cont act option. Dry Contacts change state during inoper ative conditions, including loss of power . Any status change can be monitored elsewhere via Dr y Contacts. A T erminal Block includes two sets of Normally Open (N.O.) and Normally Closed (N.C) cont acts. Both se ...

  • Siemens TPS3 15 - page 15

    Display Replacement The display is field replaceable. Deenergize SPD, confirm with appropriat e measurement equipment and dischar ge internal capacitance to ground. Mark locations and carefully disconnect diagnostic cables, contacts, connecting conduct ors, etc. Unbolt display and r eplace. Reinstall in reverse. Not e that a sealing gask et betw ...

  • Siemens TPS3 15 - page 16

    Siemens Industr y , Inc. Building T echnologies Division 5400 T riangle Parkway Norcr oss, GA 30092 888-333-3545 info.us@siemens.com 6.17.11.jb #8172 ...

Manufacturer Siemens Category Surge Protector

Documents that we receive from a manufacturer of a Siemens TPS3 15 can be divided into several groups. They are, among others:
- Siemens technical drawings
- TPS3 15 manuals
- Siemens product data sheets
- information booklets
- or energy labels Siemens TPS3 15
All of them are important, but the most important information from the point of view of use of the device are in the user manual Siemens TPS3 15.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Siemens TPS3 15, service manual, brief instructions and user manuals Siemens TPS3 15. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Siemens TPS3 15.

Similar manuals

A complete manual for the device Siemens TPS3 15, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Siemens TPS3 15 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Siemens TPS3 15.

A complete Siemens manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Siemens TPS3 15 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Siemens TPS3 15, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Siemens TPS3 15, that we can find in the current document
3. Tips how to use the basic functions of the device Siemens TPS3 15 - which should help us in our first steps of using Siemens TPS3 15
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Siemens TPS3 15
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Siemens TPS3 15 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Siemens TPS3 15?

Use the form below

If you did not solve your problem by using a manual Siemens TPS3 15, ask a question using the form below. If a user had a similar problem with Siemens TPS3 15 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)