Manual GE 131-10595-2 1-07 JR

16 pages 0.34 mb
Download

Go to site of 16

Summary
  • GE 131-10595-2 1-07 JR - page 1

    1 31-10595-2 1-07 JR BEFORE YOU BEGIN Read these instructions carefully and completely . • IMPOR T ANT — Save these instructions for local inspector’ s use. • IMPOR T ANT — Observe all governing codes and ordinances. • Note to Installer – Be sure to leave these instructions with the consumer . • Note to Consumer – Keep these instr ...

  • GE 131-10595-2 1-07 JR - page 2

    FOR YOUR SAFETY W ARNING: For personal safety , remove house fuse or open circuit breaker before beginning installation. Failure to do so could result in serious injury or death. • All rough-in and spacing dimensions must be met for safe use of your range. • T o reduce the risk of burns or fire when reaching over hot surface elements, cabinet s ...

  • GE 131-10595-2 1-07 JR - page 3

    • Place hands on both sides of the door , and close the oven door to the removal position. This is half way between the broil stop and fully closed. • Lift door up and out until the hinge arms clear the slots. NOTE: The oven door is very heavy . Be sure you have a firm grip before lifting the oven door off the hinges. Use caution once the door ...

  • GE 131-10595-2 1-07 JR - page 4

    PRE-INST ALLA TION CUTOUT AND REQUIRED CLEARANCES If cabinets are placed less than 30” min. above the range, see alternate construction. 30” ranges conform to U.L. requirements for 0” spacing from vertical walls below countertops. Allow 1/4” minimum clearance at the back wall above the countertop. W all coverings, counters and cabinets arou ...

  • GE 131-10595-2 1-07 JR - page 5

    The Standard Installation of this Drop-In Range is to hang by the countertop on the side metal flanges under cooktop. This Range must not be installed on a base or sub structure (2”x 4” support). If the construction of your cabinet cannot provide a 1/4” flat area at the back of the countertop opening, consider changing the countertop to accom ...

  • GE 131-10595-2 1-07 JR - page 6

    Remove house fuse or open circuit breaker . Loosen screws for the junction box cover and rotate out of place or remove the cover . Examine the junction box location to determine the best routing of the conduit, and select the best available 7/8” diameter knockout. A void using holes in the top of the junction box to prevent the conduit from inter ...

  • GE 131-10595-2 1-07 JR - page 7

    THREE-CONDUCTOR BRANCH CIRCUIT CONNECTION When connecting to a 3-conductor branch circuit, if local codes permit: Connect the bare oven ground conductor with the crimped neutral (white) lead to the branch circuit neutral (white or gray in color), using wire nuts. Connect the oven red lead to the branch circuit red lead, and the oven black lead to t ...

  • GE 131-10595-2 1-07 JR - page 8

    Do not shorten the flexible conduit. The conduit strain relief clamp must be securely attached to the junction box and the flexible conduit must be securely attached to the clamp. If the flexible conduit will not fit within the junction box, do not install the oven until a clamp of the proper size is obtained. NOTE TO ELECTRICIAN: The 3 power leads ...

  • GE 131-10595-2 1-07 JR - page 9

    Select the proper position for the countertop thickness and move bracket to proper position. (Unit is supplied with bracket in position 1.) INST ALL THE RANGE INST ALLING THE ANTI-TIP BRACKET The anti-tip bracket is attached to the back of the Drop-In Range. It is designed to fit under the bottom of the countertop opening at the rear . Measure coun ...

  • GE 131-10595-2 1-07 JR - page 10

    INST ALL THE RANGE (CONT .) Carefully mark the cabinet for the location of the stop screws. Drill 1/8” pilot holes into the cabinet, each side of the range. (Make sure not to drill entirely through the cabinet wall.) Carefully turn the shoulder screws into the pilot holes until they are tight. INST ALL STOP SCREW These screws prevent the range fr ...

  • GE 131-10595-2 1-07 JR - page 11

    A TT ACH THE LOWER TRIM Attach the lower trim (supplied separately with the range) to the bottom of the vertical side trim with the 2 screws supplied. 5 CHECK FOR PROPER INST ALLA TION OF THE STOP SCREW Look at both sides of the range under the door . The stop screws must be located in the notch on the sides of the range, and not touch the top of t ...

  • GE 131-10595-2 1-07 JR - page 12

    Lift the oven door by placing one hand on each side. The door is heavy , so you may need help. Do not lift the door by the handle. With the door at the same angle as the removal position (halfway between the closed and broil stop position, seat the notch of the hinge arm into the bottom edge of the hinge slot. The notch of the hinge arm must be ful ...

  • GE 131-10595-2 1-07 JR - page 13

    FINAL CHECKLIST • Check to make sure the circuit breaker is closed (Reset) or the circuit fuses are replaced. • Be sure power is in service to the building. • Check to be sure that all packing materials and tape on metal panel (if applicable) under control knobs and drawer have been removed. 12 OPERA TION CHECKLIST • Check to make sure the ...

  • GE 131-10595-2 1-07 JR - page 14

    W all Must be flat Must be flat Must be level Must be level 30” smooth cut 9/16” 9/16” 25” AL TERNA TE CONSTRUCTION PREP ARA TION Refer to the Filler or Backguard Kit instructions for Installation details. OPTIONAL MAINTOP FILLER OR BACKGUARD KIT If counter opening extends to the wall, it will require Maintop Filler Kit (JXS66XX) or Backgua ...

  • GE 131-10595-2 1-07 JR - page 15

    15 Notes ...

  • GE 131-10595-2 1-07 JR - page 16

    Printed in the United States 16 Notes ...

Manufacturer GE Category Music Mixer

Documents that we receive from a manufacturer of a GE 131-10595-2 1-07 JR can be divided into several groups. They are, among others:
- GE technical drawings
- 131-10595-2 1-07 JR manuals
- GE product data sheets
- information booklets
- or energy labels GE 131-10595-2 1-07 JR
All of them are important, but the most important information from the point of view of use of the device are in the user manual GE 131-10595-2 1-07 JR.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals GE 131-10595-2 1-07 JR, service manual, brief instructions and user manuals GE 131-10595-2 1-07 JR. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product GE 131-10595-2 1-07 JR.

Similar manuals

A complete manual for the device GE 131-10595-2 1-07 JR, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use GE 131-10595-2 1-07 JR by users. Manuals are usually written by a technical writer, but in a language understandable to all users of GE 131-10595-2 1-07 JR.

A complete GE manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual GE 131-10595-2 1-07 JR - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the GE 131-10595-2 1-07 JR, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the GE 131-10595-2 1-07 JR, that we can find in the current document
3. Tips how to use the basic functions of the device GE 131-10595-2 1-07 JR - which should help us in our first steps of using GE 131-10595-2 1-07 JR
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with GE 131-10595-2 1-07 JR
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of GE 131-10595-2 1-07 JR in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning GE 131-10595-2 1-07 JR?

Use the form below

If you did not solve your problem by using a manual GE 131-10595-2 1-07 JR, ask a question using the form below. If a user had a similar problem with GE 131-10595-2 1-07 JR it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)