English dropdown-ico

Manual ProForm 831.210051

24 pages 2.58 mb
Download

Go to site of 24

Summary
  • ProForm 831.210051 - page 1

    Patent Pending USERÕS MANUAL A pH testing kit (not included) is required for proper use and maintenance of this product. A pH testing kit can be pur- chased at any spa or pool supply store. CAUTION Read all precautions and instruc- tions in this manual before using this equipment. Save this manual for future reference. SEARS, ROEBUCK AND CO., HOFF ...

  • ProForm 831.210051 - page 2

    T ABLE OF CONTENTS IMPORT ANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CHOOSING A LOCA TION FOR THE HYDROTHE ...

  • ProForm 831.210051 - page 3

    3 IMPORT ANT SAFETY INSTRUCTIONS W ARNING: TO REDUCE THE RISK OF DROWNING, ELECTRIC SHOCK, OR SERIOUS INJUR Y , READ THE FOLLOWING IMPORT ANT PRECAUTIONS BEFORE USING THE RESTORA TION 5.1. READ AND FOLLOW ALL INSTRUCTIONS 1. It is the responsibility of the owner to ensure that all users of the hydrotherapy spa are adequately informed of all precaut ...

  • ProForm 831.210051 - page 4

    4 20. DANGERÑIf you will be using the hydrother- apy spa outside, do not bury the power cord; you should also keep the power cord away from lawn mowers, hedge trimmers, and other similar equipment. 21. W ARNINGÑThe hydrotherapy spa must be wired directly into a 240 volt power source equipped with a Ground Fault Circuit Interrupter (GFCI). The GFC ...

  • ProForm 831.210051 - page 5

    5 34. W ARNINGÑT o reduce the risk of injury or drowning: Consult your physician about pos- sible side-effects of any medications you may be taking before using the hydrotherapy spa. Heat from the water , in conjunction with some medications may cause drowsiness and increase the risk of drowning. Others can effect blood pressure, heart rate, and c ...

  • ProForm 831.210051 - page 6

    6 BEFORE YOU BEGIN Thank you for selecting the innovative PROFORM ¨ RESTORA TION 5.1 hydrotherapy spa. The RESTORA TION 5.1 hydrotherapy spa of fers the fea- tures and quality of a traditional hot tub at an afford- able price. Best of all, the RESTORA TION 5.1 hydrotherapy spa provides the benefits of hydrothera- py in the comfort and privacy of y ...

  • ProForm 831.210051 - page 7

    7 CHOOSING A LOCA TION FOR THE HYDROTHERAPY SP A There are many factors to consider when choosing a location to set up the hydrotherapy spa. These factors vary depending on whether you use the hydrotherapy spa inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the hydrotherapy spa. If you ...

  • ProForm 831.210051 - page 8

    8 SET -UP AND ASSEMBL Y Before beginning assembly , carefully read the following information and instructions: ¥ Place all parts in a cleared area and remove the packing materials from the spa shell; do not dis- pose of the packing materials until assembly is completed and the spa is in operation. ¥ Assembly requires two people. ¥ During assembl ...

  • ProForm 831.210051 - page 9

    4. The RESTORA TION 5.1 is designed to operate with a 240 volt power source and must be wired directly to a 240 volt ground fault circuit interrupter (GFCI) installed in your home. This procedure must be performed by a qualified electrician. Before you have the spa wired, be sure that it is in the position you want, and that it can be easily servic ...

  • ProForm 831.210051 - page 10

    1. Remove the two indicated Control Unit Screws (19) and the two Small Star W ashers (8) from the cover on the Control Unit (14). Fold the cover down. Route the 240 volt AC power cord through the indi- cated opening on the right side of the Control Unit (14). 2. Attach the 240 volt AC power cord to the indicated wires inside the Control Unit (14) a ...

  • ProForm 831.210051 - page 11

    11 5. For a 40 amp 240 volt AC power supply , set the jumper J1 to pins 1 and 2 on the power board and leave the other jumpers at the factory settings, as shown at the right. This will allow the heater and the pump to operate at high speed simultaneously . 6. Secure the power cord by tightening the screws in the wire clamp on the Control Unit (14). ...

  • ProForm 831.210051 - page 12

    12 USING THE HYDROTHERAPY SP A The hydrotherapy spa is designed to seat five adults. The fifteen thera-jets can be regulated to provide a relaxing massage to sooth away stress, and the strength of the water massage can be adjusted by the air control. The hydrotherapy spa holds 200 gallons of water and offers an automatic, programmable heating (41¡ ...

  • ProForm 831.210051 - page 13

    13 A A B B D C A E A D A B SP A SHELL DIAGRAM SP A OPERA TION Refer to the diagram above. The function of each component is explained below: The eight uni-directional thera-jets (A) are located on both sides of the spa. Five jets focus the water massage on your upper or lower back. The remaining three jets provide a foot hydro-massage for three of ...

  • ProForm 831.210051 - page 14

    14 USING THE CONSOLE Refer to the console diagram above. The function of each console control is explained below: T emperature Display: During normal use this display shows the actual water temperature. When the Set T emp indicator is lit, the display shows the set temperature. Light: This button turns the light on and off. When the light is on, th ...

  • ProForm 831.210051 - page 15

    15 POSTING THE W ARNING SIGN The warning sign, shown below , must be posted on a wall or fence, where all users of the RESTORA TION 5.1 will be able to see it. Whenever the spa is moved, the sign must also be moved and reposted near the spa. ADJUSTING THE FIL TER CYCLE The spa filter cycle runs automatically to clean the water in the spa. However , ...

  • ProForm 831.210051 - page 16

    16 The hydrotherapy spa is designed to provide you with years of enjoyment. Please follow the guidelines below to properly maintain your hydrotherapy spa. MAINTENANCE SCHEDULE DAIL Y ¥ Check the water level and refill the spa to the level shown on page 9, step 5. ¥ Check the pH balance and sanitizer level. Adjust if necessary (see W A TER CHEMIST ...

  • ProForm 831.210051 - page 17

    17 W A TER CHEMISTRY The hydrotherapy spa comes with a starter chemical pack for maintaining the water in the spa. (See TEST- ING AND TREA TING THE W A TER on page 12.) Additional chemicals can be purchased at a pool and spa supply store. CAUTION: The chemicals used to maintain the pH balance of the water and to sanitize the water can be dangerous. ...

  • ProForm 831.210051 - page 18

    18 T o drain the hydrotherapy spa, follow these steps: 1. Set the temperature control on the console to the lowest setting. 2. Shut off the circuit breaker or GFCI. 3. Remove the access cover from the back of the spa unit. 4. Remove the drainage hose from the clip and attach a garden hose to the valve on the drainage hose. 5. Open the valve by turn ...

  • ProForm 831.210051 - page 19

    19 CHECKING AND CLEANING THE FIL TER The filter should be checked periodically for build-up of dirt and oil. T o check or clean the filter , it is neces- sary to remove the basket and the two filter car- tridges from the filter housing. Removing and Cleaning the Basket: 1. T urn off the power . 2. Pull the weir door towards you until it is fully op ...

  • ProForm 831.210051 - page 20

    20 1. SYMPTOM: THE SP A WILL NOT OPERA TE a. Check to see if the GFCI breaker is tripped, or was not turned on. Reset the GFCI breaker . b. Make sure the Heater Switch (7), located on the Control Unit (14) inside the pump compart- ment, is in the ÒONÓ position. Note: The spa will not operate if the Heater Switch is in the ÒOFFÓ position. 2. SYM ...

  • ProForm 831.210051 - page 21

    21 9. SYMPTOM: THE W A TER LEVEL DROPS a. Some water loss due to evaporation is normal. If rapid water loss occurs, or if you notice wet- ness on the floor around the hydrotherapy spa, then the spa shell may have a leak. Contact your local spa and pool service provider for repairs. b. A clamp or seal inside the pump compartment may be loose. Check ...

  • ProForm 831.210051 - page 22

    22 P ART LISTÑModel No. 831.210051 R0698A Note: Ò#Ó indicates a non-illustrated part. Specifications are subject to change without notice. Key No. Qty . Description 1 8 Buckle Screw 2 4 Buckle 3 6 Motor Screw 4 4 Motor W asher 5 4 Rubber Insulator 6 1 Blue Lens 7 1 Heater Switch 8 4 Small Star W asher 9 1 Heat Sensor 10 2 Filter Cartridge 1 1 1 ...

  • ProForm 831.210051 - page 23

    1 2 2 3 4 5 6 9 12 13 14 15 16 17 18 32 31 29 30 25 26 11 8 19 19 8 8 7 28 21 27 33 3 23 23 22 20 25 34 37 36 35 24 19 EXPLODED DRA WINGÑModel No. 831.210051 R0698A 23 ...

  • ProForm 831.210051 - page 24

    Part No. 147145 J00594-C R0698A Printed in USA © 1998 Sears, Roebuck and Co. Model No. 831.210051 QUESTIONS? As a manufacturer , we are commit- ted to providing complete customer satisfaction. If you have questions, or find that there are missing or damaged parts, we will guarantee complete satisfaction through direct assistance from our factory . ...

Manufacturer ProForm Category Hot Tub

Documents that we receive from a manufacturer of a ProForm 831.210051 can be divided into several groups. They are, among others:
- ProForm technical drawings
- 831.210051 manuals
- ProForm product data sheets
- information booklets
- or energy labels ProForm 831.210051
All of them are important, but the most important information from the point of view of use of the device are in the user manual ProForm 831.210051.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals ProForm 831.210051, service manual, brief instructions and user manuals ProForm 831.210051. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product ProForm 831.210051.

Similar manuals

A complete manual for the device ProForm 831.210051, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use ProForm 831.210051 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of ProForm 831.210051.

A complete ProForm manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual ProForm 831.210051 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the ProForm 831.210051, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the ProForm 831.210051, that we can find in the current document
3. Tips how to use the basic functions of the device ProForm 831.210051 - which should help us in our first steps of using ProForm 831.210051
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with ProForm 831.210051
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of ProForm 831.210051 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning ProForm 831.210051?

Use the form below

If you did not solve your problem by using a manual ProForm 831.210051, ask a question using the form below. If a user had a similar problem with ProForm 831.210051 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)