English dropdown-ico

Manual Polaroid 45I

18 pages 0.48 mb
Download

Go to site of 18

Summary
  • Polaroid 45I - page 1

    Installation Quickstart ...

  • Polaroid 45I - page 2

    SprintScan 45i System Requirement s . . . . . . . . . . . . . . 3 Unpac k the Box . . . . . . . . . . . . . . . . . . . 4 Positi on the Scanner . . . . . . . . . . . . . . . 5 Insta ll the S oftwa re . . . . . . . . . . . . . . . . . 5 Connect the Scann er to the Co mpute r . . . . . . . . . . . . . . . . . . . . . 6 Connect the Scann er to AC Powe ...

  • Polaroid 45I - page 3

    English 3 Syst em Requi remen ts Macintosh Systems • A Power Macintosh fam ily computer or compatible, with a PowerPC p roce ssor a nd 3 2 megabytes (MB ) of RA M. • Appl e system softw are v ersi on 7.6 o r lat er . • ColorSy nc color man agement so ftwar e v ersion 2. 5 or lat er (requir ed for colo r prof ile emb edding). • A video adapt ...

  • Polaroid 45I - page 4

    English 4 1 Unpack the Bo x Make sure you h av e all the f ollo wing components. Contact you r dealer if an y is missing or damag ed. a Scanner b Power cable c This manual d Pas s-through terminator e SCSI c able (2 5-pin t o 50- pin) f Film carrier for 4x5 film g Adapter fo r 120 f ilm, 2¼ x 2¼ i n. h Adapter fo r single 3 5mm slide i Adapter fo ...

  • Polaroid 45I - page 5

    English 5 2 P osition the Scanner Place the scanner on a flat, st able surface, f ree of vibration. Lea ve at least 2 inches (50 mm) of space aroun d all sides and the top of the scanner for adequate ventilation, and leav e room at the back to reach the po wer switch on the rear panel. Caution: As with any highly sensiti ve optical equipment, vibra ...

  • Polaroid 45I - page 6

    English 6 4 Connect the Sc anner to the Computer The SprintS can 45i r equires a SCSI host adap ter in your com- puter . If your computer do es not ha ve an adapter , you must install one (see page 1 7). If your computer is a PC-compatible with a SCSI adapter , but the adapter is connected to a hard dri ve or CD-R OM driv e, installing a second ada ...

  • Polaroid 45I - page 7

    English 7 Note: The address is preset to 4. Do not ch ange it unless another de vice is using 4. Other ad dresses typi cally available are 2, 5, and 6 . Connect the SCSI cab les Place the scanner at the end of the SCSI chain or between the computer and other SCSI de vices as sho wn in the follo wing diagrams. Use the s h‘ortest possib le cables. ...

  • Polaroid 45I - page 8

    English 8 Y ou may need additional cables or adapter s to connect the scan- ner . Y our cable must ha ve a 50-pin C entroni cs M or DB -25 M connector at o ne end for attachment to the s canner , and the cable should be as short as possible. T o determine the connector you need for at tachment to y our SCSI adap ter , refer to instruct ions with th ...

  • Polaroid 45I - page 9

    English 9 5 Connect the Sc anner to A C P o wer and T urn On 1 Connect the p ower co rd as sho wn. 2 T urn on the scanner b y pressing the po wer switch. 3 Check the lights. Th e green light indicates po wer on. The yellow light blinks while the scanner initiali zes, remaining steady when the scanner is ready . (The green light also blinks w hile s ...

  • Polaroid 45I - page 10

    English 10 6 Loading the Film Carri ers The Four -Slide Film Carrier 1 W ith the text facing up and the hinge at the top, open the carrier flat as sho wn. 2 Place up to four mounted 35mm slides in th e spaces pro- vided. Be sure the slide mounts f i t properly in the r ecessed areas. The imag es should be right-sid e up and righ t-reading as you d ...

  • Polaroid 45I - page 11

    English 11 2 Open the carrier flat. Insert a 4x5 chrom e or ne gativ e so that the left edge is against the positioning pins . Position the film so the image is right-readi ng and right-side up (emulsion- side down). Note: The emulsion side is the du ll side. 3 Close the car rier . Squeeze the carrier at the bo ttom edge and turn the knob to lock i ...

  • Polaroid 45I - page 12

    English 12 4 Secure the film with the two magnets pro vided, on the top and bottom edges. Be sure the magne ts are also within the raised ridges . 5 Place the adapter in the 4x5 car rier , sliding the notches into the pins on the left edge. The f ilm and magnets should be face up, as sho wn. 6 Close the car rier . Squeeze the carrier at the bo ttom ...

  • Polaroid 45I - page 13

    English 13 4 If the film is unmounted or the mount is thin, use the slide spacer pro vided. Position the slide space r underneath the slide. The f ilm should fit snugly into the adapter . (The spacer also ensures that the image will be at the co rrect distance from the sc anning mechanism.) 5 Place the adapter in the 4x5 car rier , sliding the notc ...

  • Polaroid 45I - page 14

    English 14 7 Inserti ng the Carrier into the Scanner 1 Open the carrier acces s door . 2 Insert the carr ier gently and f irmly into the carrier slot as shown, until you feel it stop. 3 Close the carrier access d oor . The scann er will not scan if the door is open. Note: Do not open the carrier acces s door while a scan is in process; the scan wil ...

  • Polaroid 45I - page 15

    English 15 8 Previe w -Scan an Image 1 Load the f ilm or slide in to the film car rier (as described previously). 2 Insert the carrier into the scanner (as described pre viously). 3 Start the PolaCo lor Insight program: 4 Select the type of slide or ne gati ve yo u are scanning from the Input lis t on the P rev ie w panel. 5 Select your monitor typ ...

  • Polaroid 45I - page 16

    English 16 9 Enhance and Fin al-Scan the Image Fo llow the online user’ s guide ins tructions to enh ance the image and perfor m a f inal scan. T o view the online P o laColor Insi ght User’ s Guide : 10 Remove the Carrier 1 When the scan is comp lete, open the door and remo ve the carrier . Remo ve the f ilm and store it properly to pro tect i ...

  • Polaroid 45I - page 17

    English 17 Installing a SCSI Hos t Adapter The SprintScan 45i co nnects to a SCSI ho st adapter in you r com- puter . Most Macintosh computers have a SCSI adapter b uilt in, bu t most IBM PC com patible computers d o not. If you mu st install a SCSI adapter , turn the computer of f and fol- lo w instructions pr ovided b y the adapter manufacturer . ...

  • Polaroid 45I - page 18

    English 18 Radio and T elevision In terference FCC Notic e (U.S.A.) Note: This equipment has been tested and found to com ply with the lim its for a Cl ass B di gital de vice, pursua nt to P art 15 of the FCC Rules. These limits are des igned to pro vide reasonable p ro- tection against harmful inter ference in a residential in stallation. This equ ...

Manufacturer Polaroid Category Scanner

Documents that we receive from a manufacturer of a Polaroid 45I can be divided into several groups. They are, among others:
- Polaroid technical drawings
- 45I manuals
- Polaroid product data sheets
- information booklets
- or energy labels Polaroid 45I
All of them are important, but the most important information from the point of view of use of the device are in the user manual Polaroid 45I.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Polaroid 45I, service manual, brief instructions and user manuals Polaroid 45I. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Polaroid 45I.

Similar manuals

A complete manual for the device Polaroid 45I, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Polaroid 45I by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Polaroid 45I.

A complete Polaroid manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Polaroid 45I - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Polaroid 45I, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Polaroid 45I, that we can find in the current document
3. Tips how to use the basic functions of the device Polaroid 45I - which should help us in our first steps of using Polaroid 45I
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Polaroid 45I
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Polaroid 45I in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Polaroid 45I?

Use the form below

If you did not solve your problem by using a manual Polaroid 45I, ask a question using the form below. If a user had a similar problem with Polaroid 45I it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)