Manual NEC NP03CM

16 pages Not applicable
Download

Go to site of 16

Summary
  • NEC NP03CM - page 1

    Portable Projector NP03CM Ceiling Mount Unit Installation and Adjustment Manual Thank you for your purchase of the NEC portable projector ceiling mount unit. Please read this installation and adjustment manual carefully to ensure proper use. Special skills are required for the installation of the portable projector. This work should never be perfor ...

  • NEC NP03CM - page 2

    2 Heed the Follo wing • When installing the projector, be sure to do so as explained in this manual. The projector may fall and cause injury if it is installed improperly. • To prevent the projector from falling, install it in a place and fasten it in a way with sufficient strength to support the combined weight (4.9 kg) of the projector (2.9 k ...

  • NEC NP03CM - page 3

    3 CA UTION • Do not obstruct the projector's ventilation holes. Doing so will prevent the dissipation of heat and may result in fires. In particular, do not use the projector in the following ways: Do not install the projector in a wall or in a tight place where ventilation is poor, place a cover it, etc. • Do not install the projector in ...

  • NEC NP03CM - page 4

    4 • Distance to lens end Center line of fixed ceiling part Lens center 70 105.2 162.5 90 90 60 60 80.4 10 4 - Preparation List of P acka ged Parts Fixed ceiling part ...1 Projector mounting adapter ...1 Projector mounting screws (M 4)...3 Up-down angle adjustment screws (M5 ) ...4 Installation and adjustment manual ..........1 Required T ools Phi ...

  • NEC NP03CM - page 5

    5 Zoom adjustment range 25 0123456789 1 0 12(m) 40 60 80 100 120 150 180 200 240 300 11 Wide angle (Maximum) Telephoto (Maximum) Guide to Screen Size and Projector Mounting Position Screen Size and Projection Distance ··· (VT580/VT480/VT58/VT57/VT595/VT590/VT491/VT490/VT59) Use this guide when considering the distance to the screen and the scree ...

  • NEC NP03CM - page 6

    6 Guide to Screen Size and Projector Mounting Position 25 01234567 8 9 1 0 11(m) 40 60 80 100 120 150 180 200 240 300 ( 型 ) Screen Size and Projection Distance···VT48/VT49 Use this guide when considering the distance to the screen and the screen size. • The ceiling mount unit can be adjusted up and down a maximum of +/-10 ˚ , but if too ...

  • NEC NP03CM - page 7

    7 Guide to Screen Size and Projector Mounting Position Zoom adjustment range 25 0123456789 1 0 12(m) 40 60 80 100 120 150 180 200 240 300 11 Telephoto (Maximum) Wide angle (Maximum) Screen Size and Projection Distance···VT695 Use this guide when considering the distance to the screen and the screen size. • The ceiling mount unit can be adjuste ...

  • NEC NP03CM - page 8

    Guide to Screen Size and Projector Mounting Position 8 (m) 25 0 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0m 40 60 80 100 120 150 180 200 240 270 300 (Inches) Screen Size Con version T able Using the Table The dimensions of a 100 inch screen size according to the table will be approximately 2 m horizontally ...

  • NEC NP03CM - page 9

    9 1 Mounting the Pr ojector Attach the Fixed Ceiling P ar t to the Ceiling First, partially tighten the four screws, then tighten the screws firmly after positioning. Use M8 bolts for the fixed ceiling part. Use of types other than M8 could cause the projector to fall. W ARNING! Fixed ceiling part 2 Attach the Pr ojector Mounting Adapter to the Pro ...

  • NEC NP03CM - page 10

    10 3 4 Mounting the Projector Suspend the Projector fr om the Fixed Ceiling P ar t Slide the slotted part of the projector mounting adapter over the pin of the fixed ceiling part and push all the way to the back. The projector is temporarily suspended in this condition and attention must be paid so that the unit does not fall since it is not fixed ...

  • NEC NP03CM - page 11

    Mounting the Projector 11 NOTE : Mounting boards, M8-type anchor nuts, bolts, nuts and washers are commercially available. Mounting board (Strong enough to support the weight of the whole unit.) Nut and washer Beam Nut and washer Bolt (M8) Anchor nut (Purchase commercially-available M8-type anchor nuts that are strong enough to endure the weight of ...

  • NEC NP03CM - page 12

    12 1 2 3 Replacing the Lamp To replace the lamp, first switch off the power, wait for the cooling fans to stop and disconnect the power plug from the outlet. Now, wait about 60 minutes before replacing the lamp. Attempts to replace the lamp during operation or immediately after operation has stopped will cause burns because of the high temperature. ...

  • NEC NP03CM - page 13

    13 1 10 ˚  10 ˚  上下端 Upper and lower  edges Adjustment of the Pr ojection Angle Before the Adjustment • Refer to the instruction manual of the projector, switch on the power and project an image. • Refer to the section "Orientation " of Setup and select the projection orientation. Select "Ceiling/Front" when ...

  • NEC NP03CM - page 14

    10 ˚ 1 0 ˚  14 Left and right edges 10 ˚  10 ˚  2 3 Adjustment of the Projection Angle Adjust the Up-Down Angle Turn the projector up and down so that the left and right edges of the screen are parallel, then firmly tighten the four up-down angle adjustment screws. It is acceptable if the image extends beyond the screen. Maximum adj ...

  • NEC NP03CM - page 15

    15 Adjustment of the Projection Angle Fine Adjustment After the adjustments, chec k that the par ts are fixed securel y . Loosen the same screws that were used in the distortion adjustment and finely adjust the angle so that the projected image fits the screen, then tighten all the screws (i.e., a total of 14 including the inclination axis screws). ...

  • NEC NP03CM - page 16

    MEMO NP03CM_E 07.3.12 2:15 PM ページ 16 ...

Manufacturer NEC Category Projector accessory

Documents that we receive from a manufacturer of a NEC NP03CM can be divided into several groups. They are, among others:
- NEC technical drawings
- NP03CM manuals
- NEC product data sheets
- information booklets
- or energy labels NEC NP03CM
All of them are important, but the most important information from the point of view of use of the device are in the user manual NEC NP03CM.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals NEC NP03CM, service manual, brief instructions and user manuals NEC NP03CM. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product NEC NP03CM.

Similar manuals

A complete manual for the device NEC NP03CM, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use NEC NP03CM by users. Manuals are usually written by a technical writer, but in a language understandable to all users of NEC NP03CM.

A complete NEC manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual NEC NP03CM - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the NEC NP03CM, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the NEC NP03CM, that we can find in the current document
3. Tips how to use the basic functions of the device NEC NP03CM - which should help us in our first steps of using NEC NP03CM
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with NEC NP03CM
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of NEC NP03CM in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning NEC NP03CM?

Use the form below

If you did not solve your problem by using a manual NEC NP03CM, ask a question using the form below. If a user had a similar problem with NEC NP03CM it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)