Manual Bosch ATM/POS Bridge

22 pages 1.46 mb
Download

Go to site of 22

Summary
  • Bosch ATM/POS Bridge - page 1

    A TM / P O S bridge Installation Manual EN ...

  • Bosch ATM/POS Bridge - page 2

    Bosch Security Systems A TM / P OS brid ge | Installation Manual ii ...

  • Bosch ATM/POS Bridge - page 3

    Bosch Security Systems AT M / P O S b r i d g e | Installation Manual iii ATM/POS Bridge Installation manual ...

  • Bosch ATM/POS Bridge - page 4

    Bosch Security Systems A TM / P OS bridge | Inst allation Manual iv I M P O RT ANT SAFE TY I NSTR U CTI O N S 1 . Read these instr uctions. 2. Keep these instr uctions. 3. Heed all warning s. 4. F ollo w all instructions. 5. Do not use this apparatus near water . 6. Clean only w ith a dry cloth. 7 . Do not block any v entilation open in gs. Install ...

  • Bosch ATM/POS Bridge - page 5

    Bosch Security Systems AT M / P O S b r i d g e | Installation Manual v 1 3. Unplug this unit du ring lightning st orms or when unused for long pe riods of time. 1 4. Refer all servicin g to qualified service personn e l. Ser vicing is required when the apparatus has been damaged in an y wa y , such as pow er -supply cord or plug is damaged, liquid ...

  • Bosch ATM/POS Bridge - page 6

    Bosch Security Systems A TM / P OS bridge | Inst allation Manual vi ...

  • Bosch ATM/POS Bridge - page 7

    Bosch S ecurity Systems AT M / P O S b r i d g e | Inst allation Manual EN | 1 English A TM / P O S bridge T able of Cont ent s 1. ATM/POS bridge ........................ .................................. ......................................... 3 1.1 Package contents ........... ......................................... ......................... ...

  • Bosch ATM/POS Bridge - page 8

    Bosch Security Systems AT M / P O S b r i d g e | Inst allation Manual EN | 2 English SAFETY PRECAUTIONS This label may appear on the bottom of the unit due to space limitations. Attention: Installation should be performed by qualified service personnel only in accordance with the National Electrical Code or applicable local codes. CAUTION: TO REDU ...

  • Bosch ATM/POS Bridge - page 9

    Bosch S ecurity Systems AT M / P O S b r i d g e | Inst allation Manual EN | 3 English 1 . A TM / P O S bridge The ATM/POS bridge connects a Point-of-Sal e (POS) or an Automatic Teller M achine (ATM) to a Bosch digital video rec order so th at transactional data from these units can be stored and displayed with associated video recordings. 1 . 1 Pa ...

  • Bosch ATM/POS Bridge - page 10

    Bosch Security Systems AT M / P O S b r i d g e | Inst allation Manual EN | 4 English 1 .4 Applications The following illustr ation shows an example of how a bridge is used in a network of digital video recoders and P OS terminals. The following illustr ation shows an example of how a bridge is used in a network of digital video recoders and ATM te ...

  • Bosch ATM/POS Bridge - page 11

    Bosch S ecurity Systems AT M / P O S b r i d g e | Inst allation Manual EN | 5 English 1 .5 C onnections Using the supplied cables, connect the bridge as follows: 1 . Connect the supplied DC po wer adapter unit to the DC po wer input connector of the bridge. 2. Connect the RJ45 connector of the bridge via a straight Ethernet C A T5 network cable to ...

  • Bosch ATM/POS Bridge - page 12

    Bosch Security Systems AT M / P O S b r i d g e | Inst allation Manual EN | 6 English 4. Connect y our terminal to CO M port 1, 2, 3 or 4 of the bridge using the supplied cable. Choose the COM 4 port on the bridge if your connection protocol is RS485. Normally , you w ould use the supplied splitt er cable to make this connection. F or example, y ou ...

  • Bosch ATM/POS Bridge - page 13

    Bosch S ecurity Systems AT M / P O S b r i d g e | Inst allation Manual EN | 7 English 2. Configurat ion The ATM/POS bridge is configured via a PC Hyp erTerminal session. The PC is connected via a COM serial port to the COM 3 (console) port of the bridge. Start a HyperTerminal session on the PC to get access to the configuration menu of the bridge. ...

  • Bosch ATM/POS Bridge - page 14

    Bosch Security Systems AT M / P O S b r i d g e | Inst allation Manual EN | 8 English 5. If the bridge is sw itched on, a w elcome message is sho w n on the screen. This message prompts y ou to press the F1 ke y (a function k ey on y our k e yboard ) . 6. Press the F1 k ey; the screen di spla ys the Syst em Options M enu. 7 . T o conf igure the bri ...

  • Bosch ATM/POS Bridge - page 15

    Bosch S ecurity Systems AT M / P O S b r i d g e | Inst allation Manual EN | 9 English Communication Ch annels In the Communication Channels su bmenu you ca n select one of the four C OM ports to configure. The submenu that appears depen ds on the setting of the Compor t Mode . Enter the parameters that are required for your terminal. Terminal Setu ...

  • Bosch ATM/POS Bridge - page 16

    Bosch Security Systems AT M / P O S b r i d g e | Inst allation Manual EN | 10 English Recording Langua ge Select the same language that is set on the connected digital recorder. This ensures that characters are displayed corre ctly. The conf iguration menu language continues to be English. Service Menu The Service Menu is used to restore the bridg ...

  • Bosch ATM/POS Bridge - page 17

    Bosch S ecurity Systems AT M / P O S b r i d g e | Inst allation Manual EN | 11 English 3. Connect ors The four COM connectors are all 9- pin SubD-type male connectors. The following table lists the signal s and pin numbers for the four po rts. Pin CO M 1 R S 232 COM 2 RS 23 2 CO M 3 (con sol e) R S 232 COM 4 RS 48 5 1 2 R xR xR xD 2 + 3 T xT xT xD ...

  • Bosch ATM/POS Bridge - page 18

    Bosch Security Systems AT M / P O S b r i d g e | Inst allation Manual EN | 12 English 4. T roubleshoot ing If you are unable to capture t ransact ion data, perform the following steps: 1 . Recheck y our cables. 2. Check y our TCP /IP netw ork connection w ith the A TM/P OS bridge. Check y our gate wa y and subnet mask settings , they m ust match t ...

  • Bosch ATM/POS Bridge - page 19

    Bosch S ecurity Systems AT M / P O S b r i d g e | Inst allation Manual EN | 13 English 5. T echnic al specific at ions Electrical Power supply: External D C power supply (supplied ) Input : 1 00-240 V AC; 1 50m A, 50 /60Hz Output: 1 2 VDC ; 450mA C onnector: DC jack , positive center pin; 1 0-30 VD C; 2W Mechanical Dimensions: 1 52 x 1 1 0 x 35 mm ...

  • Bosch ATM/POS Bridge - page 20

    Bosch Security Systems AT M / P O S b r i d g e | Inst allation Manual EN | 14 English Electromagnetic Co mpatibility E M C requirements: USA : FC C Part 1 5, Class B E U : E MC directive 8 9/33 6/ E EC Immunity : E N50 1 3 0-4 Emission : E N55022 Class B Harmonics: E N6 1 00 0-3- 2 V oltage fluctuations : E N6 1 000-3-3 Safety : USA : U L60950 EU ...

  • Bosch ATM/POS Bridge - page 21

    Bosch Security Systems A TM /P OS bridge | Installation Manua l ...

  • Bosch ATM/POS Bridge - page 22

    Bosch Security Systems A TM /P OS bridge | Installation Manua l Bosch Sicherheitssysteme GmbH Ludwig-Bölkow-Allee 85521 Ottobrunn Germany www.bosch-sicherheitssysteme.de Bosch Security Systems B.V. P.O. Box 80002 5600 JB Eindho ven The Netherlands www.boschsecuritysystems .com 3122 165 22 72.2 © 2004 Bosch Security Systems B.V. Subject to change. ...

Manufacturer Bosch Category Network Router

Documents that we receive from a manufacturer of a Bosch ATM/POS Bridge can be divided into several groups. They are, among others:
- Bosch technical drawings
- ATM/POS Bridge manuals
- Bosch product data sheets
- information booklets
- or energy labels Bosch ATM/POS Bridge
All of them are important, but the most important information from the point of view of use of the device are in the user manual Bosch ATM/POS Bridge.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Bosch ATM/POS Bridge, service manual, brief instructions and user manuals Bosch ATM/POS Bridge. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Bosch ATM/POS Bridge.

Similar manuals

A complete manual for the device Bosch ATM/POS Bridge, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Bosch ATM/POS Bridge by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Bosch ATM/POS Bridge.

A complete Bosch manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Bosch ATM/POS Bridge - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Bosch ATM/POS Bridge, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Bosch ATM/POS Bridge, that we can find in the current document
3. Tips how to use the basic functions of the device Bosch ATM/POS Bridge - which should help us in our first steps of using Bosch ATM/POS Bridge
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Bosch ATM/POS Bridge
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Bosch ATM/POS Bridge in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Bosch ATM/POS Bridge?

Use the form below

If you did not solve your problem by using a manual Bosch ATM/POS Bridge, ask a question using the form below. If a user had a similar problem with Bosch ATM/POS Bridge it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)