English dropdown-ico

Manual Vermont Casting 2477CE

28 pages 5.81 mb
Download

Go to site of 28

Summary
  • Vermont Casting 2477CE - page 1

    DO NOT DISCARD THIS MANUAL: Retain for future use 30003849 8/08 Rev . 2 2278 Dutchwest noncat cover 5/04 Homeowner ’ s Installation and Operating Manual If this heater is not properly installed, operated, and maintained, a house fire may result. For safety , follow all installation, operation and maintenance directions. Contact local building of ...

  • Vermont Casting 2477CE - page 2

    2 Dutchwest Non-Catal ytic Con vection Heater 30003849 The Dutchwest Model 2477CE covered in this Owner ’ s Guide has been tested and listed to current standards. The test standards utilized were UL 1482 for the United States and EN13240:2001 + A2:2004 for Europe. Dutchwest Model 2477CE has been tested and is listed for mobile home installations ...

  • Vermont Casting 2477CE - page 3

    3 Dutchwest Non-Catal ytic Con vection Heater 30003849 Specifications Fig. 1 Dutchwest Convection Heater specifications. Model 2477CE A 610 mm (24”) B 622 mm (24 ¹⁄₂ ”) C 756 mm (29 ³⁄₄ ”) D 438 mm (17 ¹⁄₄ ”) E 445 mm (17 ¹⁄₂ ”) F 686 mm (27”) Center of Flue Collar , Rear Exit G 775 mm (30 ¹⁄₂ ”) G F E D C B ...

  • Vermont Casting 2477CE - page 4

    4 Dutchwest Non-Catal ytic Con vection Heater 30003849 Installation SAFETY NOTICE: IF YOUR DUTCHWEST CON- VECTION HEA TER IS NOT PROPERL Y INST ALLED, OPERA TED AND MAINT AINED, A HOUSE FIRE MA Y RESUL T . FOR SAFETY , FOLLOW ALL INST ALLA- TION, OPERA TION AND MAINTENANCE DIREC- TIONS. CONT ACT LOCAL BUILDING OFFICIALS ABOUT RESTRICTIONS AND INST ...

  • Vermont Casting 2477CE - page 5

    5 Dutchwest Non-Catal ytic Con vection Heater 30003849 ST241 chimney types 12/13/99 djt Prefabricated Double-W all Insulated Chimney T ile Lined Masonry Chimney ST241 Fig. 2 If in sound condition and approved for use, either a masonry or a prefabricated chimney may be used. Prefabricated Chimneys These should be an internal diameter of 150 mm (6” ...

  • Vermont Casting 2477CE - page 6

    6 Dutchwest Non-Catal ytic Con vection Heater 30003849 Single-W all Connector The single-wall chimney connector should be made of 24 gauge or heavier steel, and must have a minimum internal diameter of 152 mm (6”) for model 2477CE. Install single-wall chimney connector not less than 457 mm (18”) from the ceiling. In cathedral ceiling installati ...

  • Vermont Casting 2477CE - page 7

    7 Dutchwest Non-Catal ytic Con vection Heater 30003849 Securing the Connector to a Masonry Chimney The Dutchwest Convection heater may be connected to either a freestanding masonry chimney or a masonry fireplace chimney . Freestanding Installations If the chimney connector must pass through a combus- tible wall to reach the chimney , follow the re ...

  • Vermont Casting 2477CE - page 8

    8 Dutchwest Non-Catal ytic Con vection Heater 30003849 ST797 thru fireplace 5/04 Flue Liner Extend Chimney Con- nector to the First T ile of the Flue Liner Observe Miniumum Clearances Damper Plate is Removed or Locked in Open Position Close Off the Damper Opening with Sheet Metal and Sealant ST797 Fig. 8 The connector passes through the fireplace ...

  • Vermont Casting 2477CE - page 9

    9 Dutchwest Non-Catal ytic Con vection Heater 30003849 Fireplace Installations The Dutchwest Model 2477CE has a reversible flue col- lar to allow for either top exit or rear exit installations. Y ou may install your Dutchwest Model 2477CE in an existing fireplace as a fireplace insert with no legs, or with the standard legs attached. T o install ...

  • Vermont Casting 2477CE - page 10

    10 Dutchwest Non-Catal ytic Con vection Heater 30003849 Clearances As with any solid fuel heating stove, extremely high surface temperatures can occur , particularly in the event of uncontrolled operation, e.g. if the doors are inadvertently left open. It is crucial that suf- ficient clearances are allowed to any combustible surfaces, e.g. wooden ...

  • Vermont Casting 2477CE - page 11

    1 1 Dutchwest Non-Catal ytic Con vection Heater 30003849 Y our convection heater requires some assembly . Follow the directions carefully and refer to the parts diagram at the back of this manual. Unpack the Parts Remove the bottom heat shield strapped to the top of the stove and all loose parts from the firebox and the ash pan. Check to make sure ...

  • Vermont Casting 2477CE - page 12

    12 Dutchwest Non-Catal ytic Con vection Heater 30003849 6. Reposition the stove so the other front corner over- hangs the pallet and remove the leg bolt from the bottom of the stove. Align the leg with the bolt hole in the bottom of the stove, and attach it with the bolt and washer . T ighten securely . 7. Reposition the stove so the first rear le ...

  • Vermont Casting 2477CE - page 13

    13 Dutchwest Non-Catal ytic Con vection Heater 30003849 Heater Controls and Features Air Control The Dutchwest Convection Heater Model 2477CE has a control that regulates the amount of air drawn into the stove. Generally , more air entering the stove allows the fire to burn hotter and faster , while less air decreases heat output and prolongs the ...

  • Vermont Casting 2477CE - page 14

    14 Dutchwest Non-Catal ytic Con vection Heater 30003849 Successful Wood Burning Woodburning is often said to be more of an art than a science. Y ou’ll easily master the art if you start by using good, dry fuel and by understanding how the stove’s air supply system operates. Burn Only High-Quality Fuel Y our heater is designed to burn natural wo ...

  • Vermont Casting 2477CE - page 15

    15 Dutchwest Non-Catal ytic Con vection Heater 30003849 Use the Air Control Settings that Work Best for Y ou No single control setting will fit every situation. Each installation will differ depending on the quality of the fuel, the amount of heat desired, and how long you wish the fire to burn. Control settings also depend on your particular ins ...

  • Vermont Casting 2477CE - page 16

    16 Dutchwest Non-Catal ytic Con vection Heater 30003849 Y ou’ll soon find that this stove is HOT WHILE IN OPER- A TION! KEEP CHILDREN, CLOTHING, AND FURNI- TURE A W A Y . CONT ACT MA Y CAUSE SKIN BURNS. DO NOT OVERFIRE THIS HEA TER. Overfiring may cause a house fire, or can result in permanent damage to the stove. If a part of the stove or the ...

  • Vermont Casting 2477CE - page 17

    17 Dutchwest Non-Catal ytic Con vection Heater 30003849 Remove Ashes Frequently Wear heavy stove gloves when removing ashes. Check the ash compartment before reloading the stove. If the ash pan is nearly full, empty the pan. Before replacing the ash pan, clear away any ash that may have spilled over the sides and back of the pan. Empty the ash draw ...

  • Vermont Casting 2477CE - page 18

    18 Dutchwest Non-Catal ytic Con vection Heater 30003849 Below you will find important information on general care, inspection and maintenance of your Dutchwest stove. Should it become necessary , use only replace- ment parts recommended by your authorized dealer . Keep Y our Stove Looking New And Working Its Best Care of the Cast Iron Surface An o ...

  • Vermont Casting 2477CE - page 19

    19 Dutchwest Non-Catal ytic Con vection Heater 30003849 3. Apply a thin bead of stove cement in the newly- cleaned groove. 4. Lay the gasket into the groove. Wait until you are a couple inches from the end before you cut it. 5. T est the gasket by closing the door on a slip of paper as described above. Adjust the gasket in any areas where an inadeq ...

  • Vermont Casting 2477CE - page 20

    20 Dutchwest Non-Catal ytic Con vection Heater 30003849 Cleaning the Chimney System The chimney system is composed of the chimney and the pipe that connects the stove to the chimney . Inspect the chimney and chimney connector at least twice monthly , and clean if necessary . When you first begin using the stove, check daily for creosote — a subs ...

  • Vermont Casting 2477CE - page 21

    21 Dutchwest Non-Catal ytic Con vection Heater 30003849 • Inspect for and remove ash build-up behind the com- bustion package. This should be done in conjunction with annual cleaning of the chimney connector since this inspection is most conveniently done through the flue collar opening. Inspect the passages to either side of the combustion pack ...

  • Vermont Casting 2477CE - page 22

    22 Dutchwest Non-Catal ytic Con vection Heater 30003849 if the chimney flue has a cross-sectional volume much larger than the stove outlet. Steel Chimney Most factory-made ‘Class A ’ steel chimneys have a layer of insulation around the inner flue. This insulation keeps the smoke warm and protects the surrounding structure from the high flue ...

  • Vermont Casting 2477CE - page 23

    23 Dutchwest Non-Catal ytic Con vection Heater 30003849 Creosote Creosote is a by-product of low-temperature stove operation, weak draft, or both. It is a tar that results when unburned gases condense inside the flue sys- tem at temperatures below 143° C (290˚ F). Creosote is volatile and can generate a chimney fire. All of the installation cha ...

  • Vermont Casting 2477CE - page 24

    24 Dutchwest Non-Catal ytic Con vection Heater 30003849 MHSC reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. Dutchwest Convection Heater Model 2477CE 29 26 27 32 37 21 19 12b 38 41 24 25 16 30 37 23 42 39 35 1 14 13 4 43 2 6 9 10 17 1 1 7 3 34 20 22 18 ...

  • Vermont Casting 2477CE - page 25

    25 Dutchwest Non-Catal ytic Con vection Heater 30003849 Dutchwest Convection Heater (continued) Model 2477CE Ref. Description 2477CE 6. Outside Air Bracket 30002205 7. Fountain Assembly 30002100 8. Brick Support Bracket 30000986 9. Shoe Refractory 30002101 Shoe Gasket 30002286 10. Lower Fireback Refractory 30002307 1 1. Upper Fireback Refractory 30 ...

  • Vermont Casting 2477CE - page 26

    26 Dutchwest Non-Catal ytic Con vection Heater 30003849 ...

  • Vermont Casting 2477CE - page 27

    27 Dutchwest Non-Catal ytic Con vection Heater 30003849 L I M I T E D L I F E T I M E W arranty For Dutchwest Non-Catalytic W ood Stove Limited Lifetime W arranty MHSC warrants that all refractory brick and material used in this product will be warranted against deterioration not resulting from physical damage or overloading of the woodstove for th ...

  • Vermont Casting 2477CE - page 28

    MHSC 149 Cleveland Drive • Paris, Kentucky 40361 www .mhsc.com ...

Manufacturer Vermont Casting Category Electric Heater

Documents that we receive from a manufacturer of a Vermont Casting 2477CE can be divided into several groups. They are, among others:
- Vermont Casting technical drawings
- 2477CE manuals
- Vermont Casting product data sheets
- information booklets
- or energy labels Vermont Casting 2477CE
All of them are important, but the most important information from the point of view of use of the device are in the user manual Vermont Casting 2477CE.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Vermont Casting 2477CE, service manual, brief instructions and user manuals Vermont Casting 2477CE. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Vermont Casting 2477CE.

Similar manuals

A complete manual for the device Vermont Casting 2477CE, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Vermont Casting 2477CE by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Vermont Casting 2477CE.

A complete Vermont Casting manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Vermont Casting 2477CE - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Vermont Casting 2477CE, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Vermont Casting 2477CE, that we can find in the current document
3. Tips how to use the basic functions of the device Vermont Casting 2477CE - which should help us in our first steps of using Vermont Casting 2477CE
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Vermont Casting 2477CE
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Vermont Casting 2477CE in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Vermont Casting 2477CE?

Use the form below

If you did not solve your problem by using a manual Vermont Casting 2477CE, ask a question using the form below. If a user had a similar problem with Vermont Casting 2477CE it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)