Manual Gefen EXT-DVI-1CAT5-ELR

28 pages 0.97 mb
Download

Go to site of 28

Summary
  • Gefen EXT-DVI-1CAT5-ELR - page 1

    Audio Embedder 3GSDI EXT-DVI-1CAT5-ELR User Manual DVI ELR Extender over one CAT5 *Pr eferred Release A1 ...

  • Gefen EXT-DVI-1CAT5-ELR - page 2

    ii 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this product near water . 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer ’s instructions. 8. Do not install or place this product near any heat sources su ...

  • Gefen EXT-DVI-1CAT5-ELR - page 3

    iii Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is notied within two (2) years from the date of shipment, Gefen will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanical, electric ...

  • Gefen EXT-DVI-1CAT5-ELR - page 4

    iv T echnical S upport (818) 772-9100 (800) 545-6900 8:00 AM to 5:00 PM Monday - Friday , Pacic T ime Fa x (818) 772-9120 Email support@gefen.com We b http://www .gefen.com Mailing Addr ess Gefen, LLC c/o Customer Service 20600 Nordhoff St. Chatsworth, CA 9131 1 Pr oduct R egistr ation Register your product here: http://www .gefen.com/kvm/Regist ...

  • Gefen EXT-DVI-1CAT5-ELR - page 5

    v v Operating Notes • Shielded T wisted-Pair (STP) CA T -5e or CA T -6 cabling is recommended. However , Un-shielded T wisted-Pair (UTP) CA T -5e or CA T -6 cabling is acceptable. Shielded cable is preferred as it provides immunity to Electromagnetic Interference (EMI), cell phones, and A/C motors. DVI ELR Extender over one CA T5 is a trademark o ...

  • Gefen EXT-DVI-1CAT5-ELR - page 6

    vi Features and Packing List Features • Extends DVI up to 495 feet (150 meters) over one CA T -5e cable • Supports resolutions up to 1080p Full HD and 1920 x 1200 (WUXGA) • EDID management for rapid integration of source and display • Enable/Disable switches for HPD pass-through • Power-Save (Green Mode) selector switch • 150m/100m rang ...

  • Gefen EXT-DVI-1CAT5-ELR - page 7

    ...

  • Gefen EXT-DVI-1CAT5-ELR - page 8

    viii Table of Contents 1 Get ting St arted Introduction............................................................................................................ 2 Sender Unit ................................................................................................... 2 Receiver Unit ........................................................ ...

  • Gefen EXT-DVI-1CAT5-ELR - page 9

    ...

  • Gefen EXT-DVI-1CAT5-ELR - page 10

    ...

  • Gefen EXT-DVI-1CAT5-ELR - page 11

    DVI ELR Extender over one CAT5 1 Ge t ting St ar t ed Introduction............................................................................................................ 2 Sender Unit ................................................................................................... 2 Receiver Unit ............................................. ...

  • Gefen EXT-DVI-1CAT5-ELR - page 12

    page | 2 Introduction Sender Unit 5V DC Link DVI In Power DVI ELR Extender over one CAT5 S Link EXT -DVI-1CAT5-ELRS Gefen 5V DC Link DVI In Power DVI ELR Extender over one CAT5 S Link EXT -DVI-1CAT5-ELRS Gefen 5V DC Link DVI In Power DVI ELR Extender over one CAT5 S Link EXT -DVI-1CAT5-ELRS Gefen 4 5 2 3 Getting S tart ed Getting S tart ed 1 ...

  • Gefen EXT-DVI-1CAT5-ELR - page 13

    page | 3 Introduction ID Name Description 1 Link Connect a CA T -5 cable from this jack to the Link jack on the Receiver unit. 2 5V DC Connect the included 5V DC power supply to this power receptacle. 3 Link (LED) This green LED indicates the current state of the product. See LED Status (page 10 ) for more information on LED status messages. 4 DVI ...

  • Gefen EXT-DVI-1CAT5-ELR - page 14

    page | 4 Introduction Getting S tart ed Getting S tart ed Receiver Unit 5V DC Link DVI Out Power DVI ELR Extender over one CAT5 R Link EXT -DVI-1CAT5-ELRR Gefen 5V DC Link DVI Out Power DVI ELR Extender over one CAT5 R Link EXT -DVI-1CAT5-ELRR Gefen 5V DC Link DVI Out Power DVI ELR Extender over one CAT5 R Link EXT -DVI-1CAT5-ELRR Gefen 4 5 2 3 1 ...

  • Gefen EXT-DVI-1CAT5-ELR - page 15

    page | 5 Introduction Getting S tart ed ID Name Description 1 Link Connect a CA T -5 cable from this jack to the Link jack on the Sender unit. 2 5V DC Connect the included 5V DC power supply to this power receptacle. 3 Link (LED) This green LED indicates the current state of the product. See LED Status (page 10 ) for more information on LED status ...

  • Gefen EXT-DVI-1CAT5-ELR - page 16

    page | 6 Installation Getting S tart ed Connection Instructions 1. Use the included DVI cable to connect the DVI source to the DVI In port on the Sender unit. 2. Connect the Receiver unit to the DVI display using another DVI cable. 3. Connect a CA T -5 (CA T -5e or better is recommended) cable, up to 495 feet (150 meters) from the Link jack on the ...

  • Gefen EXT-DVI-1CAT5-ELR - page 17

    ...

  • Gefen EXT-DVI-1CAT5-ELR - page 18

    ...

  • Gefen EXT-DVI-1CAT5-ELR - page 19

    page | 9 DVI ELR Extender over one CAT5 2 Basic Oper ation LED Status .......................................................................................................... 10 DIP Switch Conguration ..................................................................................... 11 Default Settings ...................................... ...

  • Gefen EXT-DVI-1CAT5-ELR - page 20

    page | 10 Adv anced Oper ation LED Status Basic Oper ation The Power and Link LED indicators on the Sender and Receiver unit provide basic information on the current status of the DVI ELR Extender over one CA T5. The information, in the table below , applies to both the Sender and Receiver unit. LED Status Description Power Solid blue • Power con ...

  • Gefen EXT-DVI-1CAT5-ELR - page 21

    page | 1 1 DIP Switch Conguration Adv anced Oper ation There is a bank of four DIP switches on the bottom of the Sender and Receiver unit. Remove the piece of colored tape to reveal the DIP switch bank. These DIP switches provide control over EDID management, HPD pass-through, power modes, and range selection. Default Settings Description Sender ...

  • Gefen EXT-DVI-1CAT5-ELR - page 22

    page | 12 Adv anced Oper ation DIP Switch Conguration Each of the following sections describe the DIP switch settings that control each feature. DIP switches that are not related to a specic feature have been grayed-out. Note that DIP switch settings can be used independently or in conjunction with other features, as desired. EDID Management ...

  • Gefen EXT-DVI-1CAT5-ELR - page 23

    page | 13 DIP Switch Conguration Basic Oper ation Power Mode Description Sender unit Receiver unit Power-Save (Green) mode. The Receiver unit is powered only when a video signal is present on the DVI (or HDMI) cable. Sleep Mode consumes less than 1 W att of power . Normal mode. In this mode, the Receiver unit is always powered. Long-Reach Mode W ...

  • Gefen EXT-DVI-1CAT5-ELR - page 24

    ...

  • Gefen EXT-DVI-1CAT5-ELR - page 25

    DVI ELR Extender over one CAT5 3 Appendix Specications ...................................................................................................... 16 ...

  • Gefen EXT-DVI-1CAT5-ELR - page 26

    page | 16 Appendix Specications Supported Formats Resolutions (max.) • 1920 x 1200 (WUXGA) • 1080p Full HD Connectors, Indicators, and Controls DVI In (Sender) • 1 x DVI-I, 29-pin, female (digital only) DVI Out (Receiver) • 1 x DVI-I, 29-pin, female (digital only) IP control (Sender / Receiver) • 1 x RJ-45 Power (Sender / Receiver) • ...

  • Gefen EXT-DVI-1CAT5-ELR - page 27

    ...

  • Gefen EXT-DVI-1CAT5-ELR - page 28

    20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.gefen.com support@gefen.com Stretch it. Switch it. Split it. Gefen’s got it. ® 20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.gefen.com support@gefen.com *Pr eferred ...

Manufacturer Gefen Category Marine Radio

Documents that we receive from a manufacturer of a Gefen EXT-DVI-1CAT5-ELR can be divided into several groups. They are, among others:
- Gefen technical drawings
- EXT-DVI-1CAT5-ELR manuals
- Gefen product data sheets
- information booklets
- or energy labels Gefen EXT-DVI-1CAT5-ELR
All of them are important, but the most important information from the point of view of use of the device are in the user manual Gefen EXT-DVI-1CAT5-ELR.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Gefen EXT-DVI-1CAT5-ELR, service manual, brief instructions and user manuals Gefen EXT-DVI-1CAT5-ELR. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Gefen EXT-DVI-1CAT5-ELR.

A complete manual for the device Gefen EXT-DVI-1CAT5-ELR, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Gefen EXT-DVI-1CAT5-ELR by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Gefen EXT-DVI-1CAT5-ELR.

A complete Gefen manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Gefen EXT-DVI-1CAT5-ELR - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Gefen EXT-DVI-1CAT5-ELR, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Gefen EXT-DVI-1CAT5-ELR, that we can find in the current document
3. Tips how to use the basic functions of the device Gefen EXT-DVI-1CAT5-ELR - which should help us in our first steps of using Gefen EXT-DVI-1CAT5-ELR
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Gefen EXT-DVI-1CAT5-ELR
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Gefen EXT-DVI-1CAT5-ELR in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Gefen EXT-DVI-1CAT5-ELR?

Use the form below

If you did not solve your problem by using a manual Gefen EXT-DVI-1CAT5-ELR, ask a question using the form below. If a user had a similar problem with Gefen EXT-DVI-1CAT5-ELR it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)