Manual Vulcan-Hart GL80E

12 pages 0.24 mb
Download

Go to site of 12

Summary
  • Vulcan-Hart GL80E - page 1

    GS, GL & GT SERIES FULL Y STEAM JACKETED GAS KETTLES MODEL GS25E ML-52633 GS30E ML-52634 GL40E ML-52635 GS60E ML-52660 GL80E ML-52637 GT100E ML-52638 GT125E ML-52639 GT150E ML-52640 VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201-0696, TEL. (502) 778-2791 FORM 30960 Rev. B (Oct. 2003) www.vulcanhart.com INST ALLA TION & OPERA TION M ...

  • Vulcan-Hart GL80E - page 2

    – 2 – IMPORT ANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS IS DETECTED. THIS INFORMATION CAN BE OB ...

  • Vulcan-Hart GL80E - page 3

    – 3 – T ABLE OF CONTENTS GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Unpacking . . . . . . . . . ...

  • Vulcan-Hart GL80E - page 4

    – 4 – Installation, Operation and Care of GS, GL & GT SERIES FULL Y STEAM JACKETED GAS KETTLES KEEP THESE INSTRUCTIONS FOR FUTURE USE GENERAL Your Vulcan steam jacketed kettle is produced with quality workmanship and material. Proper installation, usage and maintenance will result in many years of satisfactory performance. Vulcan-Hart Compa ...

  • Vulcan-Hart GL80E - page 5

    – 5 – INSTALLATION CODES AND STANDARDS In the United States, Vulcan kettles must be installed in accordance with state and local codes, with the National Fuel Gas Code, (ANSI-Z223.1, latest edition) available from the American Gas Association, 1515 Wilson Boulevard, Arlington, VA 22209, with the National Electrical Code (ANSI/NFPA No. 70, lates ...

  • Vulcan-Hart GL80E - page 6

    – 6 – FAUCET BRACKET A bracket is provided for mounting a faucet on the kettle; this would allow the addition of water to the kettle for the convenience of the food preparer. A faucet is available as an accessory. NOTE: Do not use tap water from faucet to fill kettle jacket. Refer to Jacket Water & Jacket Water Treatment on page 12. ELECTRI ...

  • Vulcan-Hart GL80E - page 7

    – 7 – OPERA TION WARNING : THE KETTLE AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING, CLEANING AND SERVICING THE KETTLE. Before operating, check the jacket water level by looking at the sight glass at the rear of the kettle with both upper and lower valves open. The water level should be at the midpoint of the sight glass. If water is below the ...

  • Vulcan-Hart GL80E - page 8

    – 8 – CONTROLS — KETTLES WITH ELECTRONIC IGNITION (Prior Construction, Fig. 2) Thermostat — Controls heat in the kettle. High dial settings are for cooking; low settings are for holding. On – Off Switch — Located on the upper right-hand corner of the control panel. When turned to ON, initiates the electronic ignition system. Combination ...

  • Vulcan-Hart GL80E - page 9

    – 9 – Fig. 4 Low Water Cutoff — Pilot and Main Burner won't operate if water level in jacket is low. Pressure Relief Valve — Protect the kettle against excessive pressure should the thermo- Pressure Limit Switch stat malfunction. The pressure relief valve is rated so that it will relieve generated steam faster than the burners can gene ...

  • Vulcan-Hart GL80E - page 10

    – 10 – TURNING ON A KETTLE EQUIPPED WITH ELECTRONIC IGNITION (Applies to Fig. 1 or Fig. 2) Before lighting the pilot, both the burner and pilot must have been off at least 5 minutes. 1. Remove the control panel cover screw. 2. Remove the control box cover (lift, pull out at bottom, lower). 3. Turn knob of the combination control valve countercl ...

  • Vulcan-Hart GL80E - page 11

    – 11 – CLEANING After each use, clean and flush the kettle liner immediately, especially if the product cooked contained salt, vinegar or acid in any concentration. Do not use chlorine based cleaning products. Do not use metalic scouring pads or brushes. Daily — Kettle Food Draw-Off Valve CAUTION: During disassembly, cleaning and reassembly o ...

  • Vulcan-Hart GL80E - page 12

    – 12 – MAINTENANCE WARNING : THE KETTLE AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING, CLEANING AND SERVICING THE KETTLE. WARNING : DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURE. PRESSURE RELIEF VALVE Open the pressure relief valve at least once a day to avoid lime build-up. If leakage occurs or if the va ...

Manufacturer Vulcan-Hart Category Hot Beverage Maker

Documents that we receive from a manufacturer of a Vulcan-Hart GL80E can be divided into several groups. They are, among others:
- Vulcan-Hart technical drawings
- GL80E manuals
- Vulcan-Hart product data sheets
- information booklets
- or energy labels Vulcan-Hart GL80E
All of them are important, but the most important information from the point of view of use of the device are in the user manual Vulcan-Hart GL80E.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Vulcan-Hart GL80E, service manual, brief instructions and user manuals Vulcan-Hart GL80E. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Vulcan-Hart GL80E.

A complete manual for the device Vulcan-Hart GL80E, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Vulcan-Hart GL80E by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Vulcan-Hart GL80E.

A complete Vulcan-Hart manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Vulcan-Hart GL80E - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Vulcan-Hart GL80E, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Vulcan-Hart GL80E, that we can find in the current document
3. Tips how to use the basic functions of the device Vulcan-Hart GL80E - which should help us in our first steps of using Vulcan-Hart GL80E
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Vulcan-Hart GL80E
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Vulcan-Hart GL80E in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Vulcan-Hart GL80E?

Use the form below

If you did not solve your problem by using a manual Vulcan-Hart GL80E, ask a question using the form below. If a user had a similar problem with Vulcan-Hart GL80E it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)