Manual Grindmaster 850

16 pages 0.66 mb
Download

Go to site of 16

Summary
  • Grindmaster 850 - page 1

    1 104 Form # AM-324-03 American Met al W are ® Hot W ater Boiler Inst allation, Operation & Service Manual For Models 815, 830, 850 Gas Electric S team S pecial Features After completing inst allation and set-up, the equipment owner should keep this manual for future reference. © Grindmaster Corporation™, 1995 PRINTED IN USA Grindmaster Cor ...

  • Grindmaster 850 - page 2

    Page 1 American Met al W are Hot W ater Boiler Electric Models 815, 830, 850 Equipped with Option 46 Automatic Refill Option 39 Low W ater Cut-Off System General Description This unit is a high temperature hot water boiler . It consists of a non-pressure, vented water compartment into which is inst alled an electric immersion heater thermostaticall ...

  • Grindmaster 850 - page 3

    American Met al W are Hot W ater Boiler Page 2 TO CHECK REFILL RA TE, allow water to fill to stop/full level automatically; then turn of f master switch. Draw off 1 gallon of water from faucet. Turn master switch back on and time how long it takes for the water level to come up to stop/full mark again. Comp are time with chart provided and adjust a ...

  • Grindmaster 850 - page 4

    Page 3 American Met al W are Hot W ater Boiler ...

  • Grindmaster 850 - page 5

    American Met al W are Hot W ater Boiler Page 4 Thermost at Factory set so that knob on BREW setting holds unit at brewing temperature toward HIGH end of brew zone on thermometer dial. Then, if turned back to HOLD position, thermost at should cycle on and off and hold at LOW 'end of BREW zone on thermometer . Thermost at Adjustment 1. 2. If wat ...

  • Grindmaster 850 - page 6

    Page 5 American Met al W are Hot W ater Boiler Service Instructions PROBLEM: THERMOST A T DIAL TURNED T O BREW AND W A TER IN COMP ARTMENT REMAINS COLD POSSIBLE CAUSE 1. 2. PROBLEM: W A TER BOILS CONTINUOUSL Y WITH THERMOST A T DIAL ON POSITION BREW OR HOLD. POSSIBLE CAUSE 1. 2. 3. Set knob on BREW and remove knob by pulling outward. Using small sc ...

  • Grindmaster 850 - page 7

    American Met al W are Hot W ater Boiler Page 6 Dual Level Control Auto Refill And Low W ater Cutoff System I) II) Dual Level Control: What it does: Description and Operation of Dual Level Control System: A. B. C. A. AUTO REFILL of the water comp artment to keep the tank filled with water . When water is used, the fill valve opens automatically to l ...

  • Grindmaster 850 - page 8

    Page 7 American Met al W are Hot W ater Boiler II) III) Quick Service Check of Dual Level Control System: Description and Operation of Dual Level Control System (continued) B. Operation W ater Level Action 1) Below both electrodes 1) 2) Rises to low electrode 2) above heater coils 3) Rises to high electrode 3) 4) Falls below high electrode only 4) ...

  • Grindmaster 850 - page 9

    American Met al W are Hot W ater Boiler Page 8 A) B) C) Overfilling of water tank when power is off. Overfilling of water tank only when power to unit is on. Auto refill fails to fill water tank. PROBLEM IV) T rouble Shooting Auto Refill, Low Water Cutof f, and Dual Level Control System POSSIBLE CAUSE SERVICE CHECK REMEDY 1) 2) 1) 2) 3) 4) 1) 2) Fi ...

  • Grindmaster 850 - page 10

    Page 9 American Met al W are Hot W ater Boiler C) D) Auto refill fails to fill water tank (continued). Auto Refill is erratic. PROBLEM IV) T rouble Shooting Auto Refill, Low Water Cutof f, and Dual Level Control System (continued) POSSIBLE CAUSE SERVICE CHECK REMEDY 3) 4) 5) 6) 7) 8) 1) 2) 3) W ater strainer clogged. No power on Dual Level Control. ...

  • Grindmaster 850 - page 11

    American Met al W are Hot W ater Boiler Page 10 NOTE: The level control board works on the principle that water is conductive and with some pure water inst allations, an increased senseitivity may be required in the level control system. Consult factory if this be the case. If you still need help, call our service department at (800) 568-5715 Ext. ...

  • Grindmaster 850 - page 12

    Page 1 1 American Met al W are Hot W ater Boiler Read installation instructions- thoroughly . Failure to comply can result in valve failure or system damage or personal injury . Do not use solenoid valves on applications or fluid media not specifically cataloged without prior approval of Alco Engineering Department. W ARNING: DO NOT USE WITH FLAMMA ...

  • Grindmaster 850 - page 13

    American Met al W are Hot W ater Boiler Page 12 Diassembly Disassemble in the same general order as indicated in exploded-view illustrations except as noted in the following steps: 1. 2. 3. Notes: Do NOT Lose Nameplate, as it is extremely important if it becomes necessary to order a parts kit, coil or duplicate valve . Assembly 1. 2. 3. T roublesho ...

  • Grindmaster 850 - page 14

    Page 13 American Met al W are Hot W ater Boiler Part s List 815, 830, 850 - Electric, Gas or S team Heat AMW Part # Description 522004 Aluminum Gauge Shield Only for 815 - 5/8” x 13” 522006 Aluminum Gauge Shield Only for 830 - 5/8” x 16” 522010 Aluminum Gauge Shield Only for 850 - 5/8” x 20” 522034 Gauge Glass Only for 815 - 5/8” x 13 ...

  • Grindmaster 850 - page 15

    American Met al W are Hot W ater Boiler Page 14 RED HEA T FILL H H XL HI C GREEN ...

  • Grindmaster 850 - page 16

    Grindmaster® Coffee Grinders and Brewers • Espressimo® Espresso Machines • Crathco® Hot Beverage Dispensers Crathco® Cold and Frozen Beverage Dispensers • American Metal Ware® Coffee and Tea Systems Tel (502) 425-4776 • Fax (502) 425-4664 • 1-800-695-4500 P.O. Box 35020 • Louisville, KY 40232 • USA www.grindmaster.com • email: ...

Manufacturer Grindmaster Category Water Heater

Documents that we receive from a manufacturer of a Grindmaster 850 can be divided into several groups. They are, among others:
- Grindmaster technical drawings
- 850 manuals
- Grindmaster product data sheets
- information booklets
- or energy labels Grindmaster 850
All of them are important, but the most important information from the point of view of use of the device are in the user manual Grindmaster 850.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Grindmaster 850, service manual, brief instructions and user manuals Grindmaster 850. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Grindmaster 850.

Similar manuals

A complete manual for the device Grindmaster 850, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Grindmaster 850 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Grindmaster 850.

A complete Grindmaster manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Grindmaster 850 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Grindmaster 850, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Grindmaster 850, that we can find in the current document
3. Tips how to use the basic functions of the device Grindmaster 850 - which should help us in our first steps of using Grindmaster 850
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Grindmaster 850
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Grindmaster 850 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Grindmaster 850?

Use the form below

If you did not solve your problem by using a manual Grindmaster 850, ask a question using the form below. If a user had a similar problem with Grindmaster 850 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)