English dropdown-ico

Manual Miele DA 2050

28 pages Not applicable
Download

Go to site of 28

Summary
  • Miele DA 2050 - page 1

    Operating and installation instructions Cooker hood DA 2050 To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 07 306 730 en - GB, AU, NZ ...

  • Miele DA 2050 - page 2

    Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Modes of operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Guide to the ...

  • Miele DA 2050 - page 3

    Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and can normally be recycled. Packaging e.g. cling film, polystyrene and plastic wrappings must be kept out of the reach of babies and young children. Danger of suffocation! Dispose of or recycle al ...

  • Miele DA 2050 - page 4

    This appliance complies with all relevant local and national safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before using it for the first time. They contain important information on the safety, i ...

  • Miele DA 2050 - page 5

    ~ Before connecting the appliance to the mains supply, make sure that the voltage and frequency details given on the data plate correspond with the on-site electricity supply, otherwise the appliance could be damaged. Consult a qualified electrician if in any doubt. ~ The electrical safety of this appliance can only be guaranteed when continuity is ...

  • Miele DA 2050 - page 6

    ~ Do not connect the appliance to the mains electricity supply by a multi-socket unit or an extension lead. These do not guarantee the required safety of the appliance (e.g. danger of overheating). ~ This appliance may only be used in mobile installations such as ships, caravans, aircraft etc. if a risk assessment of the installation has been carri ...

  • Miele DA 2050 - page 7

    In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heater are in operation simultaneously, an underpressure of 0.04 mbar (4 pa) is the maximum permissible in the room. Ventilation can be maintained by air inlets which must not be blocked, in wi ...

  • Miele DA 2050 - page 8

    ~ Do not use the cooker hood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. ~ The filters should be regularly cleaned or changed as appropriate. Saturated filters are a fire hazard. See "Cleaning and care". ~ Do not use a steam-cleaner to cle ...

  • Miele DA 2050 - page 9

    The cooker hood works with . . . air extraction: The air is drawn in, cleaned by the grease filter and then directed outside. If the on-site ventilation system does not have a non-return flap , then the non-return flap supplied with the appliance must be fitted in the exhaust socket in the motor unit. Having a non-return flap fitted in the ducting ...

  • Miele DA 2050 - page 10

    a Lighting switch b Fan switch c Hob lighting d Charcoal filters Special accessory for recirculation mode e Grease filter Guide to the appliance 10 ...

  • Miele DA 2050 - page 11

    To switch the lighting on and off The hob lighting a can be switched on and off independently of the fan. "0" - lighting off "1" - lighting on To switch the fan on ^ Turn switch b for the fan to "1". To select a power level You can select one of three power levels with switch b depending on how much the air needs to be ...

  • Miele DA 2050 - page 12

    Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the isolator, or – it is switched off at the wall socket and the plug removed, or – the fuse is withdrawn from the fused spur connection unit, or – the mains fuse is withdrawn, or – the screw-out f ...

  • Miele DA 2050 - page 13

    To avoid damaging the filter or the hob below, make sure you hold the filter securely at all times when handling it. Cleaning the grease filter by hand ^ Clean the filter with a soft nylon brush in a mild solution of hot water and a small amount of washing-up liquid. Do not use undiluted washing up liquid. Do not use: – cleaning agents containing ...

  • Miele DA 2050 - page 14

    Fitting and replacing the charcoal filters If the cooker hood is connected for recirculation, two charcoal filters must be inserted in addition to the grease filter. They are designed to absorb cooking odours and are fitted in the canopy above the grease filter. New filters can be purchased from your Miele Dealer / Chartered Agent or from the Miele ...

  • Miele DA 2050 - page 15

    Changing a halogen lamp Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the isolator, or – it is switched off at the wall socket and the plug removed, or – the fuse is withdrawn from the fused spur connection unit, or – the mains fuse is withdrawn ...

  • Miele DA 2050 - page 16

    Safety distance between hob and cooker hood When planning the installation height of your cooker hood, the minimum safety distance between the top of a cooker or hob and the bottom of the cooker hood is as follows, unless a greater distance is specified by the manufacturer of your cooking appliance: Electric cookers / hobs: 450 mm (GB), 600 mm (AU, ...

  • Miele DA 2050 - page 17

    – When deciding on the safety distance between the hob and cooker hood, please note that a distance of 650 mm above electric cookers/hobs may be preferable to give more working space under the hood. – Account should also be taken of the height of the person who will be using the hood most often. The person should have sufficient space to work c ...

  • Miele DA 2050 - page 18

    Fitting the non-return flap (Air extraction mode only) ^ If a non-return flap is not present in the venting system, the non-return flap supplied must be fitted onto the exhaust socket in the motor unit. The flaps must open upwards. Building in The cooker hood is intended to be built into wall units, cooker hood housing units, and above breakfast ba ...

  • Miele DA 2050 - page 19

    Recirculation If site conditions are not suitable for the cooker hood to be used with air extraction, the appliance must be set up for recirculation. For this, conversion kit DUU 151 (available from your Miele dealer or the Miele Spare Parts Dept.) is required. You will also need two charcoal filters (see “Technical data”). ^ Dismantle the non- ...

  • Miele DA 2050 - page 20

    , Important: To avoid the danger of toxic fumes, please observe the Warning and Safety instructions. This is especially crucial when using the cooker hood at the same time as another heating appliance which relies on air from the same room. The cooker hood should be installed according to local and national building regulations. Seek approval from ...

  • Miele DA 2050 - page 21

    Important: If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. Condensate trap (optional extra) In addition to insulating the exhaust ducting, w ...

  • Miele DA 2050 - page 22

    All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. Ensure power is not supplied to the appli ...

  • Miele DA 2050 - page 23

    In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent or – The Miele Customer Contact Centre (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. These are shown on the dat ...

  • Miele DA 2050 - page 24

    Total connected load ..........1 8 5W - Fan motor ..................8 5W - Hob lighting ..............2x5 0W Voltage ................. A C2 3 0V Frequency ................. 5 0H z Fuse rating ....................5A Electrical cable length .........1 . 5m Weight .......................8k g Fan performance Extraction power according to EN 61591 Extra ...

  • Miele DA 2050 - page 25

    25 ...

  • Miele DA 2050 - page 26

    26 ...

  • Miele DA 2050 - page 27

    27 ...

  • Miele DA 2050 - page 28

    Alteration rights reserved / 4209 M.-Nr. 07 306 730 / 03 ...

Manufacturer Miele Category Exhaust hood

Documents that we receive from a manufacturer of a Miele DA 2050 can be divided into several groups. They are, among others:
- Miele technical drawings
- DA 2050 manuals
- Miele product data sheets
- information booklets
- or energy labels Miele DA 2050
All of them are important, but the most important information from the point of view of use of the device are in the user manual Miele DA 2050.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Miele DA 2050, service manual, brief instructions and user manuals Miele DA 2050. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Miele DA 2050.

Similar manuals

A complete manual for the device Miele DA 2050, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Miele DA 2050 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Miele DA 2050.

A complete Miele manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Miele DA 2050 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Miele DA 2050, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Miele DA 2050, that we can find in the current document
3. Tips how to use the basic functions of the device Miele DA 2050 - which should help us in our first steps of using Miele DA 2050
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Miele DA 2050
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Miele DA 2050 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Miele DA 2050?

Use the form below

If you did not solve your problem by using a manual Miele DA 2050, ask a question using the form below. If a user had a similar problem with Miele DA 2050 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)