English dropdown-ico

Manual Ice-O-Matic CD300

21 pages 1.48 mb
Download

Go to site of 21

Summary
  • Ice-O-Matic CD300 - page 1

    Service/Installation Manual Hotel Dispenser Model - CD300 Mile High Equipment 1 1 100 East 45th A ve Denver , Colorado 80239 Part Number 9081292-01 Print Date 04/02 ...

  • Ice-O-Matic CD300 - page 2

    Introduction CD300 Page 1 To the ow ner or user: This product manu al is a s ource of inform ation about th e installation, start up, clea ning, maint enance an d repair of the product. Table of Contents Introduction Page 1 Specificati on/Limitati ons Page 2 Diag rams Page 3 Uncrating Page 4 Ice Machine I nstallation Page 5 Utility Connections Page ...

  • Ice-O-Matic CD300 - page 3

    Specificatio ns CD300 Page 2 Specificati ons and Limitations This dispenser is designed to dispense cubed ice only and to be installed and operated indoors, in a controlled enviroment. Its minimum and maximum operating temperature limits are the same as those for the ice machine. Limitations: l Must meet the sa me limitations as the cuber installed ...

  • Ice-O-Matic CD300 - page 4

    Diagrams CD300 Page 3 ...

  • Ice-O-Matic CD300 - page 5

    Uncratin g CD300 Page 4 Remove th e carton from the skid. C ut the plastic stra ps that secure the leg kit to the ski d and rem o ve t he bo x. Use the di spenser carton as a cushion and l ay the dispens er down on it s back. Re move the bolts holding th e skid to the mac hine, and separ ate the skid f rom the di spenser. Install t he dispens er le ...

  • Ice-O-Matic CD300 - page 6

    Ice Mach ine Install atio n CD300 Page 5 All models: P lace the dispenser in the location where it will be used. Level the top edge of the dispenser front to back an d left to right w ith the adjusta ble legs. Place the i ce machi ne on the dis penser and sec ure it to the dispenser w ith the hardwar e and straps. Install it according t o the instr ...

  • Ice-O-Matic CD300 - page 7

    Util ity C onnections C D300 Page 6 Drain Connections -Follow all appli cable codes. As ice mel ts in the dispenser , the water must be drain ed away. It i s critical that a pr oper drain b e connected to the dispenser. Remember that this i s a grav it y drai n system, the drai n tubing must slope dow n a minimum of ¼ inch per foot of horiz ontal ...

  • Ice-O-Matic CD300 - page 8

    Init ial Start U p and U se CD300 Page 7 Final Check List 1. Is the ice machine properl y installed? 2. Is the disp enser level? 3. Has the w ater supply been co nnected to the i ce machine? 4. Has the pr oper pow er been conn ected to the i ce mac hine and disp enser? Note: When electrical power is supplied to the dispenser the rot or will rotate ...

  • Ice-O-Matic CD300 - page 9

    Sanitatio n / Maintena nce CD300 Page 8 Schedule An ice sy stem repres ents a sizable i nvestment of ti me and money in any compa ny’s busi ness. In order to receiv e the best retur n on that i nvestment, peri odic maintenance is required. I t is the user responsibility to see t hat the machine is properly m aintained . Maintenance and cleaning s ...

  • Ice-O-Matic CD300 - page 10

    Component Identificati on CD300 Page 9 View w hen sink assembly i s removed. Rotor as seen fr om the top. Inside v iew of ice chute. Rot or shaft. ...

  • Ice-O-Matic CD300 - page 11

    Main tenance CD300 Page 10 Regular inspection and m aintenanc e will provi de the bes t assurance o f trouble f ree operation . Begin by removing the si nk assembly . Check the a ction of the ice chute a nd return spr ings. Retu rn Sprin gs Check and T ighten Fast eners Clean out t he lower drai n pan. Pour h ot water into the drain to be sure that ...

  • Ice-O-Matic CD300 - page 12

    Service Diagnosis CD 300 Page 11 Symptom Probable Cause Possible Corre ction Does not disp ense. No power to dispenser. Check for power . Ice chute not all the w ay up. Push ice chu te up. No ice in hopper. Check ice mac hine, it may be off or the dispenser’s storage cap acity may hav e been ex ceeded. Dispenser ON- Off switch is OFF. Mov e switc ...

  • Ice-O-Matic CD300 - page 13

    Ad justments CD300 Page 12 The gear motor cam mu st be properly adj ust ed to properly position the dispensing rotor. 1. Disconnect el ectrical power to the di spenser. 2. Locate t he sink key , unlock sink and r emov e it from the dispenser . 3. Observe the position of th e rotor throug h the cube chute. The rotor and cam sw itch must be in the po ...

  • Ice-O-Matic CD300 - page 14

    Removal and Replacement CD300 Page 13 Rotor 1. Disconnect el ectrical power to the di spenser and i ce machine. 2. At the back, r emov e two bolts s ecuring the ice mac hine to the dis penser. If a bin thermostat i s being used, p ull the ther m ostat capillary tube up and out of the ho pper. 3. Push the ice machine ba ck 51/2 inched from its origi ...

  • Ice-O-Matic CD300 - page 15

    Wirin g Diagra m CD300 Page 14 Button Dispensing Model CD300P ...

  • Ice-O-Matic CD300 - page 16

    Schematic Diagram CD300 Page 15 Button Dispensing Model CD300P ...

  • Ice-O-Matic CD300 - page 17

    Wirin g Diagra m CD300 Page 16 Coin Mechanism CD300C ...

  • Ice-O-Matic CD300 - page 18

    Schematic Diagram CD300 Page 17 Coin Mechanism CD300C CD300C ...

  • Ice-O-Matic CD300 - page 19

    Wirin g Diagra m CD300 Page 18 Key Card CD300K ...

  • Ice-O-Matic CD300 - page 20

    Schematic Diagram CD300 Page 19 Key Card CD300C CD300K ...

  • Ice-O-Matic CD300 - page 21

    Befo re Callin g Fo r Service CD300 Page 20 Check thes e things. 1. Is the disp enser plugged i n? 2. Has the dispe nser’s internal sw itch been switched to the ON position? 3. Is the ice machine plug ged in? 4. Has the ice machine’s int ernal sw itch been switched to the ON position? 5. Is there ic e in the dispenser ? 6. Is the ice ch ute all ...

Manufacturer Ice-O-Matic Category Beverage Dispenser

Documents that we receive from a manufacturer of a Ice-O-Matic CD300 can be divided into several groups. They are, among others:
- Ice-O-Matic technical drawings
- CD300 manuals
- Ice-O-Matic product data sheets
- information booklets
- or energy labels Ice-O-Matic CD300
All of them are important, but the most important information from the point of view of use of the device are in the user manual Ice-O-Matic CD300.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Ice-O-Matic CD300, service manual, brief instructions and user manuals Ice-O-Matic CD300. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Ice-O-Matic CD300.

Similar manuals

A complete manual for the device Ice-O-Matic CD300, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Ice-O-Matic CD300 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Ice-O-Matic CD300.

A complete Ice-O-Matic manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Ice-O-Matic CD300 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Ice-O-Matic CD300, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Ice-O-Matic CD300, that we can find in the current document
3. Tips how to use the basic functions of the device Ice-O-Matic CD300 - which should help us in our first steps of using Ice-O-Matic CD300
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Ice-O-Matic CD300
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Ice-O-Matic CD300 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Ice-O-Matic CD300?

Use the form below

If you did not solve your problem by using a manual Ice-O-Matic CD300, ask a question using the form below. If a user had a similar problem with Ice-O-Matic CD300 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)