English dropdown-ico

Manual Ryobi EJ101

20 pages 0.47 mb
Download

Go to site of 20

Summary
  • Ryobi EJ101 - page 1

    OPERA T OR'S MANUAL 2 CYCLE GASOLINE POWERED RECIPROCA TING SA W MODEL NO. EJ101 For Questions, Call 1-800-525-2579 in the U.S. or 1-800-265-6778 in Canada www.ryobi.com SA VE THIS MANUAL FOR FUTURE REFERENCE SPECIFICATIONS: Length of stroke 1 in. (25.4mm) Strokes per minute 0-2000 spm Length (without blade) 17 in. (430 mm) Engine Type Air Coo ...

  • Ryobi EJ101 - page 2

    Page 2 TABLE OF CONTENTS ■ Table of Contents ........................................................................................................................................ 2 ■ Introduction ................................................................................................................................................. 2 ...

  • Ryobi EJ101 - page 3

    Page 3 Note: For users on U.S. Forest Land and in the states of California, Maine, Oregon and Washington. All U.S. Forest Land and the state of California (Public Resources Codes 4442 and 4443), Oregon and Washington require, by law that certain internal combustion engines operated on forest brush and/or grass-covered areas be equipped with a spark ...

  • Ryobi EJ101 - page 4

    Page 4 Look for this symbol to point out important safety precautions. It means attention!!! Y our safety is involved. The operation of any reciprocating saw can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side ...

  • Ryobi EJ101 - page 5

    Page 5 READ ALL INSTRUCTIONS ■ KNOW YOUR POWER TOOL - Read operator's manual carefully. Learn its applications and limita- tions as well as the specific potential hazards re- lated to this tool. ■ KEEP GUARDS IN PLACE and in working order. ■ KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents. ■ AVOID DANGEROUS ENVIRONME ...

  • Ryobi EJ101 - page 6

    Page 6 ■ DRUGS, ALCOHOL, MEDICATION. Do not oper- ate tool while under the influence of drugs, alcohol, or any medication. ■ WHEN SERVICING USE ONLY IDENTICAL RYOBI REPLACEMENT PARTS. ■ WARNING: TO AVOID POSSIBLE SERIOUS IN- JURY, KEEP HANDS AND FINGERS FROM BE- TWEEN THE MOTOR HOUSING AND SAW BLADE CLAMP. ■ SAVE THESE INSTRUCTIONS. Refer t ...

  • Ryobi EJ101 - page 7

    Page 7 • Use only genuine Ryobi replacement parts when servicing this unit. These parts are available from your authorized service dealer. Do not use parts, accessories or attachments not authorized by Ryobi for this unit. Doing so could lead to serious injury to the user, or damage to the unit, and void your warranty. • Keep unit clean from fo ...

  • Ryobi EJ101 - page 8

    Page 8 STOP UNPACKING Your saw has been shipped completely assembled and ready for use. Inspect it carefully to make sure no breakage or damage has occurred during shipping. If any parts are damaged or missing, contact your nearest Ryobi dealer to obtain replacement parts before attempting to operate saw. A blade pack, spark plug wrench, 4 mm hex k ...

  • Ryobi EJ101 - page 9

    Page 9 FEA TURES SWITCH See Figure 2. Your saw is equipped with an On/Off Switch for starting and stopping the engine. You must slide the switch forward to the ON (I) position in order to allow for the engine to be started when pulling starter rope. Slide the switch back to OFF (0) position to stop engine. LOCK-OFF LEVER See Figure 2. Your saw is a ...

  • Ryobi EJ101 - page 10

    Page 10 OIL AND FUEL INFORMA TION OIL AND FUEL MIXING INSTRUCTIONS Old and/or improperly mixed fuel are the main reasons for the unit not running properly. Be sure to use fresh, clean unleaded fuel. Follow the instructions carefully for the proper fuel/oil mixture. DEFINITION OF BLENDED FUELS Today's fuels are often a blend of gasoline and oxy ...

  • Ryobi EJ101 - page 11

    Page 11 ST ARTING/ST OPPING INSTRUCTIONS PREPARING FOR OPERATION 1. Mix gas with oil. Fill fuel tank with fuel/oil mixture. See Oil and Fuel Mixing Instructions on previous page. 2. Do not overfill or spill fuel. 3. Replace gasoline cap on gas tank. Make sure it is securely tightened before attempting to start engine. 4. Make sure all screws and fa ...

  • Ryobi EJ101 - page 12

    Page 12 OPERA TION W ARNING: The engine of your saw should never be running when you are installing or removing blades. Stop the engine and let it cool to prevent accidental contact with the blade, muffler, etc. that could cause serious injury. Disconnect the spark plug to make sure the saw will not start. TO INSTALL BLADES See Figure 5. ■ Use th ...

  • Ryobi EJ101 - page 13

    Page 13 Fig. 8 Fig. 7 Fig. 9 OPERA TION GENERAL CUTTING See Figure 7. Hold your saw firmly in front of and clearly away from you. Make sure saw blade is clear of any foreign material. Be sure material to be cut is held firmly. Small work pieces should be securely clamped in a vise or with clamps to the work bench or table. Mark the line of cut clea ...

  • Ryobi EJ101 - page 14

    Page 14 W ARNING: When servicing use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage. W ARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask. W ARNING: To prevent serious persona ...

  • Ryobi EJ101 - page 15

    Page 15 MAINTENANCE AIR FILTER MAINTENANCE See Figure 12. W ARNING: To avoid serious personal injury, always turn your saw off and allow it to cool before you clean or do any maintenance on it. 1. Using a small phillips screwdriver, loosen and remove the air filter cover screws (2) and air filter cover. 2. Separate and remove the air filter element ...

  • Ryobi EJ101 - page 16

    Page 16 MAINTENANCE CARBURETOR ADJUSTMENT See Figure 10. The carburetor on your saw has been factory set. After extended use of your saw adjustments may be required. The high speed needle has been permanently set from the factory at 1-1/4 turns counterclockwise from the closed position. No additional adjustments should be required or made to this n ...

  • Ryobi EJ101 - page 17

    Page 17 CLEANING AND ST ORAGE W ARNING: To avoid serious personal injury, always turn your saw off and allow it to cool before you clean or do any maintenance on it. GENERAL Avoid using strong detergents or solvents when cleaning plastic parts. Most plastics are susceptible to various types of commercial solvents and may be damaged by their use. Us ...

  • Ryobi EJ101 - page 18

    Page 18 TROUBLESHOOTING ENGINE LACKS POWER OR STALLS WHEN CUTTING ENGINE WILL NOT ACCELERATE ENGINE WILL NOT IDLE ENGINE WILL NOT START CAUSE ACTION On/Off Switch is in OFF position Turn On/Off Switch to ON Empty fuel tank Fill fuel tank with properly mixed fuel Primer bulb wasn't pressed enough Press primer bulb fully and slowly 5-7 times Eng ...

  • Ryobi EJ101 - page 19

    Page 19 NOTES ...

  • Ryobi EJ101 - page 20

    OPERA T OR'S MANUAL 2 CYCLE GASOLINE POWERED RECIPROCA TING SA W MODEL NO. EJ101 972000-634 8-99 Printed in U.S.A. R YOBI AMERICA CORP . 1424 Pearman Dairy Road Anderson, SC 29625 Post Office Box 1207 Anderson, SC 29622-1207 Phone 1-800-525-2579 R YOBI CANADA INC. Post Office Box 910 Cambridge, Ontario N1R 6K2 Phone 1-800-265-6778 • SER VICE ...

Manufacturer Ryobi Category Cordless Saw

Documents that we receive from a manufacturer of a Ryobi EJ101 can be divided into several groups. They are, among others:
- Ryobi technical drawings
- EJ101 manuals
- Ryobi product data sheets
- information booklets
- or energy labels Ryobi EJ101
All of them are important, but the most important information from the point of view of use of the device are in the user manual Ryobi EJ101.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Ryobi EJ101, service manual, brief instructions and user manuals Ryobi EJ101. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Ryobi EJ101.

Similar manuals

A complete manual for the device Ryobi EJ101, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Ryobi EJ101 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Ryobi EJ101.

A complete Ryobi manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Ryobi EJ101 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Ryobi EJ101, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Ryobi EJ101, that we can find in the current document
3. Tips how to use the basic functions of the device Ryobi EJ101 - which should help us in our first steps of using Ryobi EJ101
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Ryobi EJ101
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Ryobi EJ101 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Ryobi EJ101?

Use the form below

If you did not solve your problem by using a manual Ryobi EJ101, ask a question using the form below. If a user had a similar problem with Ryobi EJ101 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)