Manual Directed Electronics CO552

25 pages 1.72 mb
Download

Go to site of 25

Summary
  • Directed Electronics CO552 - page 1

    Component Speaker MODEL CO552 CO652 OWNER'S MANUAL ™ Vista, CA 92801 DIRECTED.COM ...

  • Directed Electronics CO552 - page 2

    © 2007 directed electronics—all rights reserved 1 T ABLE OF CONTENTS E n g l i s h ........................................................................ 1 Français ................................................................ 9 Español ............................................................... 13 Deutsche ........................... ...

  • Directed Electronics CO552 - page 3

    2 © 2 00 7 d ir e ct ed el e ct ro ni c s— al l r i gh ts re s er ve d Model Number: _____________________________ Serial Number: _____________________________ Date of Purchase: _____________________________ WHA T’S IN THE BOX Included in this box are all the necessary mounting hardware and cables for your basic installation. Listed below is a ...

  • Directed Electronics CO552 - page 4

    2 © 2 00 7 d ir e ct ed el e ct ro ni c s— al l r i gh ts re s er ve d © 2007 directed electronics—all rights reserved 3 needs. The locations must be large enough for the speakers to fit. Care is needed to ensure that the location you have chosen will not affect any of the mechanical or electrical operations of the vehicle. Determining the be ...

  • Directed Electronics CO552 - page 5

    4 © 2 00 7 d ir e ct ed el e ct ro ni c s— al l r i gh ts re s er ve d INST ALLING THE MID/WOOFERS Step 1: Determine where the speakers will be mounted. Make sure there is a flat area large enough for the speakers to fit properly . An uneven mounting surface can damage the driver . Step 2: Check to make sure the space you have chosen for the spe ...

  • Directed Electronics CO552 - page 6

    4 © 2 00 7 d ir e ct ed el e ct ro ni c s— al l r i gh ts re s er ve d © 2007 directed electronics—all rights reserved 5 INST ALLING THE TWEETER SURF ACE MOUNTING Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location. Step 2: Place the provided template or tweeter cup against the pane ...

  • Directed Electronics CO552 - page 7

    6 © 2 00 7 d ir e ct ed el e ct ro ni c s— al l r i gh ts re s er ve d Step 5: Install tweeter in flush mount housing. Step 6: Connect the speaker wires observing the correct polarity . Step 7: Install tweeter and housing in the hole cut for mounting, so that the trim ring is flat with the front of the surface. Step 8: Use the supplied pressure ...

  • Directed Electronics CO552 - page 8

    6 © 2 00 7 d ir e ct ed el e ct ro ni c s— al l r i gh ts re s er ve d © 2007 directed electronics—all rights reserved 7 WIRING DIAGRAM T o woofer T o tweeter T o Amplifier Note: The tweeter positive is the wire marked with the stripe. Note: Le câble positif du haut-parleur d'aigus est rayé. Nota. El positivo del tweeter es el cable qu ...

  • Directed Electronics CO552 - page 9

    8 © 2 00 7 d ir e ct ed el e ct ro ni c s— al l r i gh ts re s er ve d SPECIFICA TIONS Part Number 22130 22135 Model CO552 CO652 Nominal Impedance 4 ohm 4 ohm Power Continuous/Maximum 40 /100 w 50 /120 w Frequency Response 120 -20kHz 60 - 20kHz Sensitivity 87dB 85dB Mounting Depth 1.97"/50mm 2.36"/60mm Mounting Diameter 4.72"/120m ...

  • Directed Electronics CO552 - page 10

    8 © 2 00 7 d ir e ct ed el e ct ro ni c s— al l r i gh ts re s er ve d © 2007 directed electronics—all rights reserved 9 FRANÇAIS OÙ MONTER LES HAUT -P ARLEURS Le choix du bon emplacement des haut-parleurs aura un effet majeur sur la qualité du son du système. Plusieurs choses doivent être prises en considération pour faire le meilleur ...

  • Directed Electronics CO552 - page 11

    10 © 20 07 di r ec te d e l ec tr on i cs —a ll r ig ht s r e se rv ed A TTENTION: Vérifiez l'espace libre du mécanisme et des fils électriques des fenêtres AV ANT de percer . Étape 5: Amenez les câbles à leurs haut-parleurs. Assurez-vous de les garder loin de tout bord métallique ou autre aiguisé. Pour passer à travers le métal, ...

  • Directed Electronics CO552 - page 12

    10 © 20 07 di r ec te d e l ec tr on i cs —a ll r ig ht s r e se rv ed © 2007 directed electronics—all rights reserved 11 Étape 7: Installez le haut-parleur et le logement dans le trou découpé pour le montage, afin que la garniture soit au niveau de l'avant de la surface. Étape 8: Utilisez l'anneau de pression inclus pour fixer ...

  • Directed Electronics CO552 - page 13

    © 2007 directed electronics—all rights reserved 13 ESP AÑOL UBICACIONES DE MONT AJE DE LOS AL T A VOCES Escoger la ubicación correcta de los altavoces tendrá el mayor efecto en la calidad del sonido del sistema. Es necesario que usted tenga en cuenta varias consideraciones cuando escoja el lugar que mejor se adapte a sus necesidades. Los luga ...

  • Directed Electronics CO552 - page 14

    14 © 20 07 di r ec te d e l ec tr on i cs —a ll r ig ht s r e se rv ed * Sierra circular de 4 3/4 plg. (woofer de 5 1/4 plg.) * Sierra circular de 5 5/8 plg. (woofer de 6 1/2 plg.) ADVERTENCIA: V erifique que haya espacio para los mecanismos de ventana y los cables eléctricos ANTES de taladrar . Paso 5: Encamine el cable de altavoz hasta los al ...

  • Directed Electronics CO552 - page 15

    14 © 20 07 di r ec te d e l ec tr on i cs —a ll r ig ht s r e se rv ed © 2007 directed electronics—all rights reserved 15 Paso 4. Haga el agujero para el tweeter . Cuando instale el tweeter en ubicaciones de fábrica, este paso se puede omitir . Se puede hacer el agujero con unas tijeras de metal o una sierra circular de 1 7/8 plg. para mater ...

  • Directed Electronics CO552 - page 16

    © 2007 directed electronics—all rights reserved 17 DEUTSCHE SO PLA TZIEREN SIE DIE LAUTSPRECHER Die Wahl der korrekten Lautsprecherposition hat große Auswirkungen auf die Soundqualität des Systems. Bei der Wahl der Lautsprecherposition, die Ihren Ansprüchen am besten entspricht, sind mehrere Faktoren zu beachten. Es muss an der Stelle genüge ...

  • Directed Electronics CO552 - page 17

    18 © 20 07 di r ec te d e l ec tr on i cs —a ll r ig ht s r e se rv ed WARNUNG: Prüfen Sie VOR dem Bohren, dass Sie keine Fenstermechanismen oder Stromkabel anbohren. 5. Schritt: Verlegen Sie die Lautsprecherkabel zu den Lautsprechern. Dabei müssen Sie die Kabel von scharfen Metallkanten oder anderen Kanten entfernt halten. Bei der Verlegung d ...

  • Directed Electronics CO552 - page 18

    18 © 20 07 di r ec te d e l ec tr on i cs —a ll r ig ht s r e se rv ed © 2007 directed electronics—all rights reserved 19 ausschneiden. WARNUNG: Prüfen Sie VOR dem Bohren, dass Sie keine Fenstermechanismen oder Stromkabel anbohren. 5. Schritt: Installieren Sie den Hochtöner im bündig eingebauten Gehäuse. 6. Schritt: Schließen Sie die Lau ...

  • Directed Electronics CO552 - page 19

    © 2007 directed electronics—all rights reserved 21 IT ALIANO INDIVIDUAZIONE DELLA POSIZIONE DI MONT AGGIO DEGLI AL TOP ARLANTI La scelta della posizione degli altoparlanti ha la massima influenza sulla qualità del suono dell'impianto. Nella scelta delle posizioni di montaggio che soddisfano meglio le proprie esigenze, occorre considerare d ...

  • Directed Electronics CO552 - page 20

    22 © 20 07 di r ec te d e l ec tr on i cs —a ll r ig ht s r e se rv ed o una sega a tazza della misura dell'altoparlante indicata di seguito. o sega a tazza da 4-3/4" (per installare un woofer da 5-1/4") o sega a tazza da 5-5/8" (per installare un woofer da 6-1/2") A TTENZIONE: controllare la distanza dai meccanismi e da ...

  • Directed Electronics CO552 - page 21

    22 © 20 07 di r ec te d e l ec tr on i cs —a ll r ig ht s r e se rv ed © 2007 directed electronics—all rights reserved 23 Fase 4: praticare il foro per il tweeter . Quando si inserisce l'altoparlante nelle sedi predisposte in fabbrica, è possibile tralasciare queste operazioni. Eseguire il foro con un paio di forbici da lattoniere o con ...

  • Directed Electronics CO552 - page 22

    © 2007 directed electronics—all rights reserved 25 POR TUGUÊS DETERMINAÇÃO DOS LOCAIS P ARA INST ALAÇÃO DOS AL TOS-F ALANTES A seleção dos locais corretos para instalação dos alto-falantes é o fator que mais influenciará a qualidade do som produzido pelo sistema. É necessário considerar vários aspectos ao escolher os locais mais ad ...

  • Directed Electronics CO552 - page 23

    26 © 20 07 di r ec te d e l ec tr on i cs —a ll r ig ht s r e se rv ed ser cortado com uma tesoura para metal fina, uma serra tico-tico ou a ar , ou uma serra copo correspondente ao tamanho do alto-falante de graves médios descrito abaixo. • Serra copo de 120 mm (4-3/4") para instalação do woofer de 133 mm (5-14”) • Serra copo de 1 ...

  • Directed Electronics CO552 - page 24

    26 © 20 07 di r ec te d e l ec tr on i cs —a ll r ig ht s r e se rv ed © 2007 directed electronics—all rights reserved 27 metal ou uma serra copo de 476 mm (1-7/8”) para materiais duros. A TENÇÃO: V erifique se há espaço suficiente até os mecanismos e fios elétricos de operação do vidro da janela ANTES de perfurar . Etapa 5: Instale ...

  • Directed Electronics CO552 - page 25

    © 2007 Directed Electronics. All rights reser ved G22130.35 2007-11 For more information on Orion products please visit www.orioncaraudio.com ™ Vista, CA 92801 DIRECTED.COM Directed Electronics is committed to delivering world class quality products and ser vices that excite and delight our customers. Directed Electronics is an ISO 9001 register ...

Manufacturer Directed Electronics Category Car Speaker

Documents that we receive from a manufacturer of a Directed Electronics CO552 can be divided into several groups. They are, among others:
- Directed Electronics technical drawings
- CO552 manuals
- Directed Electronics product data sheets
- information booklets
- or energy labels Directed Electronics CO552
All of them are important, but the most important information from the point of view of use of the device are in the user manual Directed Electronics CO552.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Directed Electronics CO552, service manual, brief instructions and user manuals Directed Electronics CO552. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Directed Electronics CO552.

A complete manual for the device Directed Electronics CO552, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Directed Electronics CO552 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Directed Electronics CO552.

A complete Directed Electronics manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Directed Electronics CO552 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Directed Electronics CO552, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Directed Electronics CO552, that we can find in the current document
3. Tips how to use the basic functions of the device Directed Electronics CO552 - which should help us in our first steps of using Directed Electronics CO552
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Directed Electronics CO552
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Directed Electronics CO552 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Directed Electronics CO552?

Use the form below

If you did not solve your problem by using a manual Directed Electronics CO552, ask a question using the form below. If a user had a similar problem with Directed Electronics CO552 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)