English dropdown-ico

Manual United States Stove EC95

20 pages 0.31 mb
Download

Go to site of 20

Summary
  • United States Stove EC95 - page 1

    EC95 1 Installation, Operation and Maintenance Instructions TABLE OF CONTENTS IMPORTANT SAFETY INFORMATION ................................................................................................................................................ 1 BUILDING CODES AND SAFETY STANDARDS ............................................................ ...

  • United States Stove EC95 - page 2

    2 EC95 SELECTING A LOCATION FOR THE HEATER When selecting a location for the heater, be sure attention is given to the following considerations: 1. If the heater is to be vented into a Listed High Temperature Type HT Factory-Built Residential Type And Building Heating Appliance Chimney, review the installation instructions for the chimney to comply ...

  • United States Stove EC95 - page 3

    EC95 3 FIGURE 3 - MINIMUM CLEARANCES TO COMBUSTIBLES FIGURE 4 - MINIMUM CLEARANCES TO COMBUSTIBLES SIDE SECTION VIEW PLAN SECTION VIEW ...

  • United States Stove EC95 - page 4

    4 EC95 FLOOR PROTECTION PIPE ANGLE UP HORIZONTAL TO HEATER FIGURE 6 - RISE OF HORIZONTAL CHIMNEY CONNECTOR PIPE TO CHIMNEY RISE: 1/4" FOR EACH FOOT OF CONNECTOR LENGTH FIGURE 5 - FLOOR PROTECTION This heater has been designed to prevent excessive temperatures on the floor beneath the heater. It is important, however, tha t a combustible floor ...

  • United States Stove EC95 - page 5

    EC95 5 There are five allowable ways that a chimney connector can be connected to a masonry chimney by passing through a combustible wall. NFPA Standard 211 allows the following wall pass-through systems. Use a minimum 3-1/2" thick brick masonry wall framed into the combustible wall. A fireclay liner (ASTM C315 or equivalent) having a 5/8" ...

  • United States Stove EC95 - page 6

    6 EC95 MINIMUM CHIMNEY CLEARANCES FROM MASONRY TO SHEET STEEL SUPPORTS AND COMBUSTIBLES 2 IN. CHIMNEY LENGTH FLUSH WITH INSIDE OF FLUE NONSOLUBLE REFACTORY CEMENT MASONRY CHIMNEY CONSTRUCTED TO NFPA 211 CHIMNEY CONNECTOR TO HEATER MINIMUM CLEARANCE 9 IN. ALL AROUND SHEET STEEL SUPPORTS (24 GAUGE MIN. THICKNESS) CHIMNEY FLUE SOLID INSULATED, LISTED ...

  • United States Stove EC95 - page 7

    EC95 7 SHEET STEEL SUPPORTS CHIMNEY SECTION CHIMNEY CONNECTOR AIR SPACE 2 IN. TWO VENTILATED AIR CHANNELS EACH 1 INCH. CONSTRUCTED OF SHEET STEEL. PART C FIGURE 5 PART D FIGURE 5 MINIMUM CLEARANCE 2 IN. ALL AROUND CHIMNEY THIMBLE 1 IN. AIR SPACE TO CHIMNEY LENGTH MASONRY CHIMNEY CONSTRUCTED TO NFPA 211 SHEET STEEL SUPPORTS (24 GAUGE MIN. THICKNESS) ...

  • United States Stove EC95 - page 8

    8 EC95 FIGURE 8 - CONNECTING HEATER’S CHIMNEY CONNECTOR TO MASONRY CHIMNEY WHEN CHIMNEY CON- NECTOR DOES NOT HAVE TO PASS THROUGH A COMBUSTIBLE WALL HEA TER INSPECTION Before installing the heater, inspect the heater for external damage and missing parts. Check the gaskets around the doors to assure that they are still in place. Also check inside ...

  • United States Stove EC95 - page 9

    EC95 9 Two common types of clearance reductions systems use sheet metal with a thickness of 28 gauge (galvanized steel, aluminum, copper) or a 3-1/2 inch (4 inch thick nominal) thick masonry wall. Either of these materials must be spaced out 1 inch from th e combustible surfaces. With sheet metal, noncombustible spacers are used to maintain the 1 i ...

  • United States Stove EC95 - page 10

    10 EC95 FIGURE 9 - HEATER OPERATION INFORMATION HEATER OPERATION IMPORTANT: DO NOT USE THE HEATER UNTIL A PROFESSIONAL INSPECTION HAS BEEN MADE OF THE ENTIRE INSTALLATION BY YOUR LOCAL FIRE DEPARTMENT, FIRE MARSHAL OR BUILDING CODE INSPEC- TOR. INSTALL A SMOKE DETECTOR ON EACH FLOOR OF YOUR HOME; IN CASE OF ACCIDENTAL FIRE FROM ANY CAUSE IT CAN PRO ...

  • United States Stove EC95 - page 11

    EC95 11 FIGURE 10 - OPENING AND CLOSING FUEL FEED DOOR FIRETENDING Firetending is the occasional poking or stirring of the burning fuel bed to ensure airflow through the fire and adding new wood as needed. With experience, you should determine how often fire tending is required to maintain the desired heat output of the heater. To ensure safe and s ...

  • United States Stove EC95 - page 12

    12 EC95 The second factor in determining heat output is its density or weight per cord. With equal seasoning and dryness, heavier, denser wood has more heating value per cord. For example, hickory is denser wood than pine, so a cord of hickory will give more heat than a cord of pine. For longer and safer heater life, never use manufactured composit ...

  • United States Stove EC95 - page 13

    EC95 13 Tap each chimney connector pipe with a small hammer or poke with a screwdriver to reveal where the metal is getting thin due to corrosion on the inside. Elbows usually give out first. Replace as necessary. YOU SHOULD ALWAYS INSPECT AND CLEAN THE HEATER’S VENTING SYSTEM BEFORE EACH HEATING SEASON. TROUBLESHOOTING Problems can arise during ...

  • United States Stove EC95 - page 14

    14 EC95 FIGURE 11 - CHIMNEY HEIGHT REQUIREMENTS 6. Check the entire system for obstructions that could be causing resistance to the flow of smoke and gases up the chimney. 7. Check the size of the chimney flue liner. If the chimney flue liner’s inside dimension is smaller that 6 inches round or 8 inches square, it will be too restrictive to the f ...

  • United States Stove EC95 - page 15

    EC95 15 2. Symptom: Fire rate too high when thermostat closed: Check for: a. Feed door or ash door not securely closed. b. Feed door or ash door gasket worn excessively. 3. Symptom: Smoke smell in living space: Check for: a. Items a through f of NO. 1 above. FINAL CHECKLIST OF DO’S AND DON’TS DO’S 1. Do read and follow the installation, opera ...

  • United States Stove EC95 - page 16

    16 EC95 DONT’S 1. Don’t dry clothing or other articles on or near the heater. 2. Don’t store or place flammable liquids, gases, or other pressurized containers near the heater. 3. Don’t use gasoline, gasoline type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or intensify a fire. Using these and other similar m ...

  • United States Stove EC95 - page 17

    EC95 17 FIGURE 12 ILLUSTRATION OF REPAIR PARTS. SEE LEDGER ON NEXT PAGE FOR PART NAMES AND PART NUMBERS. 47 58 ...

  • United States Stove EC95 - page 18

    18 EC95 SEE FIGURE 12 FOR ILLUSTRATION OF PARTS CUSTOMER NOTE: IN ADDI- TION TO THE REPAIR PARTS, KITS INCLUDE ANY RE- PLACEMENT FASTENERS WHICH WILL MOST LIKELY BE NEEDED TO INSTALL THE REPAIR PART. SAVE THIS MANUAL FOR FUTURE REFERENCE K E Y QTY. EC95 NO. PART NAME Per Unit PART NO. 1 Inner Unit Assy. Ptd. 1 69228B 2 Gasket 1 88094 3 Collar Flue ...

  • United States Stove EC95 - page 19

    EC95 19 INSTRUCTION MANUAL ADDENDUM This addendum is a supplement to the Installation, Operation, and Maintenance Instruction Manual for this appliance. Do not neglect to read all instructions thoroughly. ATTENTION: Installers of Fireplaces, Fireplace Stoves, Room Heaters, and Fireplace Inserts. SUBJECT: Determining Equivalent Materials for Use as ...

  • United States Stove EC95 - page 20

    20 EC95 ...

Manufacturer United States Stove Category Fan

Documents that we receive from a manufacturer of a United States Stove EC95 can be divided into several groups. They are, among others:
- United States Stove technical drawings
- EC95 manuals
- United States Stove product data sheets
- information booklets
- or energy labels United States Stove EC95
All of them are important, but the most important information from the point of view of use of the device are in the user manual United States Stove EC95.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals United States Stove EC95, service manual, brief instructions and user manuals United States Stove EC95. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product United States Stove EC95.

Similar manuals

A complete manual for the device United States Stove EC95, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use United States Stove EC95 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of United States Stove EC95.

A complete United States Stove manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual United States Stove EC95 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the United States Stove EC95, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the United States Stove EC95, that we can find in the current document
3. Tips how to use the basic functions of the device United States Stove EC95 - which should help us in our first steps of using United States Stove EC95
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with United States Stove EC95
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of United States Stove EC95 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning United States Stove EC95?

Use the form below

If you did not solve your problem by using a manual United States Stove EC95, ask a question using the form below. If a user had a similar problem with United States Stove EC95 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)