Manual Miele CS 1421

32 pages 0.74 mb
Download

Go to site of 32

Summary
  • Miele CS 1421 - page 1

    Operating and Installation Instructions Salamander Grill CS 1421 To prevent accidents and machine damage, read the Operating Manual before installation or use. M.-Nr. 07 472 000 e n-C A ...

  • Miele CS 1421 - page 2

    Safety instructions and warnings ....................................3 Description of the unit ..............................................8 Before using for the first time ........................................9 Operation .......................................................1 0 Raising and lowering the browning unit ......................... ...

  • Miele CS 1421 - page 3

    WARNING- When using your appliance follow basic precautions, including the following: Read all instructions before installation or use to prevent injury and appliance damage. This appliance conforms to all uniform safety codes and regulations. The manufacturer cannot be held responsible for damage or injury caused by improper use of this appliance. ...

  • Miele CS 1421 - page 4

    Children ~ Always supervise any children in the vicinity of the appliance. Do not allow children to play with the unit. ~ Children should use the grill only if they have received sufficient instruction to operate it safely. They must be able to understand and recognize the potential hazards of improper operation. ~ Take special care that children d ...

  • Miele CS 1421 - page 5

    Technical safety ~ Only skilled persons duly authorized by the manufacturer may install this appliance or perform maintenance and repair work on it. Work performed by unqualified persons carries the risk of serious harm to the user, for which the manufacturer will not be held liable. ~ Before installation, check the appliance for visible signs of e ...

  • Miele CS 1421 - page 6

    ~ Repair of the appliance during the warranty period should be performed only by Customer Service personnel who are duly authorized by the manufacturer; otherwise any damage will not be covered by the warranty. ~ Before any maintenance or repair work is performed, the appliance must be disconnected from the main power supply. It is electrically dis ...

  • Miele CS 1421 - page 7

    ~ Do not set up or operate the appliance in the open air. ~ Do not use the ledge for storage. If the appliance is accidentally switched on or there is residual heat, there is the danger that any items located there will heat up and melt, depending on the materials involved, and generating a risk of fire and burns. ~ Do not keep heat-sensitive items ...

  • Miele CS 1421 - page 8

    a Browning unit, retractable b Ledge, removable c Display Control knob d For setting the power level e For selecting the height of the browning unit Display f "ON" light g Residual heat indicator Description of the unit 8 ...

  • Miele CS 1421 - page 9

    Clean the appliance ^ Remove any protective foil. ^ Wipe down all surfaces with a damp cloth, then dry. The metal parts have a protective coating. This will cause an odour the first time the appliance is used. Note that the odour and any vapours will disappear after a brief period of time and are not a sign of malfunction or a defective appliance. ...

  • Miele CS 1421 - page 10

    Raising and lowering the browning unit ^ To raise the browning unit, turn the left-hand control to Extend (" - "). The browning unit will automatically extend to its full height, even when you release the control knob back to " ß ". You can stop the unit at any height by briefly turning the control knob to " e ". ^ Tu ...

  • Miele CS 1421 - page 11

    Browning ^ Raise the browning unit. ^ Place the dish you wish to brown on the ledge. ^ Lower the browning unit until the heating element is 1 3 / 16 "-1 15 / 16 " (30 - 50 mm) away from the top of the food. ^ Turn the control knob to setting "12". The food will brown in 3-5 minutes, depending on the desired result. Brown only on ...

  • Miele CS 1421 - page 12

    Safe retraction To avoid damaging the appliance, your grill is equipped with a retraction safety device. The browning unit can be fully retracted only once the appliance has cooled sufficiently, i.e., after the residual heat indicator has gone out. Height recognition The unit heats up only when the browning unit is raised at least 2 3 / 4 " (7 ...

  • Miele CS 1421 - page 13

    Warning: NEVER use a steam cleaner to clean this appliance. Steam could reach the electrical components and cause a short circuit. Clean the appliance on a regular basis, preferably after each use. First allow the appliance to cool down. After any cleaning with liquid, wipe the appliance dry. This will help prevent limescale deposits. To avoid damg ...

  • Miele CS 1421 - page 14

    Stainless steel Use a non-abrasive stainless steel cleanser for cleaning the appliance. To help keep the appliance clean longer, we recommend using a stainless steel care product (see "Optional accessories"). Apply the product sparingly, using a soft cloth. Do not use stainless steel cleanser on areas where there is printing. It will rub ...

  • Miele CS 1421 - page 15

    Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The manufacturer cannot be held responsible for unauthorized work. The unit will not raise? Possible fault Solution Dirt has built up in the gap around the browning uni ...

  • Miele CS 1421 - page 16

    In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting Technical Service please quote the serial number and model of the appliance. This information is visible on the silver data plate supplied with the appliance. Technical Servi ...

  • Miele CS 1421 - page 17

    Installation Instructions IMPORTANT: SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE To prevent accidents and machine damage read these instructions before installation or use. ...

  • Miele CS 1421 - page 18

    Note to the installer: Please leave this instruction book with the consumer for the local electrical inspector’s use. The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire. The cabinetry and venting hood should be installed first to prevent da ...

  • Miele CS 1421 - page 19

    Safety distances above the appliance The minimum distance between the appliance and an installed exhaust hood must be at least 25 9 / 16 " (650 mm). However, if the hood manufacturer requires a larger distance, the larger distance takes precedence. If there are no specifications from the hood manufacturer, or if easily flammable materials (e.g ...

  • Miele CS 1421 - page 20

    Safety distances to the sides of the appliance The appliance should only be installed as shown in the illustrations, while maintaining the required safety distances shown. Do not install the appliance between two tall cabinets, this is a fire hazard. A distance of alteast 2" (50 mm) must be kept between the countertop cut-out and the rear wall ...

  • Miele CS 1421 - page 21

    Installation dimensions a Spring clips b Appliance front c Installation height d Power supply box with connection cable, L=7 8 3 / 4 " (2000 mm) e Browning unit, height-adjustable Installation 21 ...

  • Miele CS 1421 - page 22

    Cut out ^ Make the worktop cut-out for one or more appliances as applicable. Remember to maintain a minimum safety distance from the back wall , as well as from any tall unit or side wall to the right or left of the appliance(s). See also "SAFETY INSTRUCTIONS FOR INSTALLATION". ^ Seal the cut surfaces with a suitable sealant to avoid swel ...

  • Miele CS 1421 - page 23

    Installation of multiple appliances When installing more than one combiset appliance, a support bar b must be installed between the appliances. Countertop cut-out two appliances For the installation of two appliances the width of the countertop cut-out D is the sum of A and C. A , B and C = appliance widths 11 5 / 16 ", 15" or 22 11 / 16 ...

  • Miele CS 1421 - page 24

    Sample calculations for a countertop cut-out for three appliances A appliance width minus 5 / 16 "( 8m m ) B appliance width C appliance width minus 5 / 16 "( 8m m ) D Countertop cut-out 11" (280 mm) 11 5 / 16 " (288 mm) 11" (280 mm) 33 3 / 8 " (848 mm) 11" (280 mm) 15" (380 mm) 14 5 / 8 " (372 mm) 40 5 ...

  • Miele CS 1421 - page 25

    a Spring clips b Support bars c Space between support bar and countertop An additional support bar is required for each additional appliance. The position for attachment of an additional spacing strip depends on the width of the appliance B . Installation 25 500 A B C b a a 25-30 D a a a a 25-30 280/372/568 280/372/568 288/380/576 50 50 50 50 c c ...

  • Miele CS 1421 - page 26

    Attach the spring clips and support bars Wood or solid surface countertops ^ Place the supplied spring clips a and the support bars b at the marked positions as shown above, by laying them on the upper edge of the cut-out and then securing them with the 1 / 8 " x 1" (3.5 x 25 mm) screws (supplied). Granite countertop ^ Position and attach ...

  • Miele CS 1421 - page 27

    ^ Coat the edges of the spring clips a , ^ and the space d between the strips b and the countertop with silicone (supplied). Installation 27 b d a ...

  • Miele CS 1421 - page 28

    Installing the appliance ^ Feed the power cord down through the cut-out. ^ Then place the front side of the appliance in the countertop cut-out. ^ Then with a hand on each side of the appliance press down evenly on the edges until it clicks into position. When doing so make sure that the appliance seal sits tightly on the countertop to ensure it is ...

  • Miele CS 1421 - page 29

    Sealing The appliance must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the appliance provides a sufficient seal for the countertop. If the appliance is sealed into position, the countertop or appliance could be damaged if it needs to be removed for maintenance or service. Tiled surfaces The grou ...

  • Miele CS 1421 - page 30

    , CAUTION: Before installation or servicing, disconnect the power supply by either removing the fuse, shutting off the main power supply or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by ...

  • Miele CS 1421 - page 31

    Disposal of packing materials The cardboard box and packing materials are biodegradable and recyclable. Please recycle. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of children. Danger of suffocation! Disposal of an old appliance Old appliances contain materials that can be recycled. Please contact ...

  • Miele CS 1421 - page 32

    Alteration rights reserved / 4608 For the most updated manual see the Miele web site. M.-Nr. 07 472 000 / 00 ...

Manufacturer Miele Category Electric Grill

Documents that we receive from a manufacturer of a Miele CS 1421 can be divided into several groups. They are, among others:
- Miele technical drawings
- CS 1421 manuals
- Miele product data sheets
- information booklets
- or energy labels Miele CS 1421
All of them are important, but the most important information from the point of view of use of the device are in the user manual Miele CS 1421.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Miele CS 1421, service manual, brief instructions and user manuals Miele CS 1421. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Miele CS 1421.

A complete manual for the device Miele CS 1421, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Miele CS 1421 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Miele CS 1421.

A complete Miele manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Miele CS 1421 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Miele CS 1421, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Miele CS 1421, that we can find in the current document
3. Tips how to use the basic functions of the device Miele CS 1421 - which should help us in our first steps of using Miele CS 1421
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Miele CS 1421
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Miele CS 1421 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Miele CS 1421?

Use the form below

If you did not solve your problem by using a manual Miele CS 1421, ask a question using the form below. If a user had a similar problem with Miele CS 1421 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)