English dropdown-ico

Manual Grindmaster AMW B-Series

24 pages 1.61 mb
Download

Go to site of 24

Summary
  • Grindmaster AMW B-Series - page 1

    AMW B-SERIES OPERA TOR MANUAL INST ALLA TION ST ART UP PROCEDURE W A TER CONNECTION The National Sanitation Foundation requires the following for an NSF approved water hook-up: • A quick disconnect water connection or enough coiled tubing so that the machine can be moved for cleaning underneath. • An approved backflow prevention device, such as ...

  • Grindmaster AMW B-Series - page 2

    F ACT OR Y SETTINGS (for each dispense head) • T ank temperature is set at 200 degrees F . • Brew time is pre-set at 2:20. (V olume/time to be set on-site) • Pulse Brew is set for 1 pulse, 20 sec on, 20 sec off. • W armer Energy Savings mode is set for 60-minutes. (“OFF” for models without warmers) • Low T emp / No Brew option is set ...

  • Grindmaster AMW B-Series - page 3

    B-SERIES Page 3 ADJUSTMENTS (cont.): Refer to B-Series Programming Chart on page 5. Pour-Over Mode Left display controls this. • The display will read “P-O” (pour-over). • Press “BREW” button to proceed to the next setting. • Press up or down arrow to change to “YES” or “NO”. Plumbed-in units must be set to “NO”. • Press ...

  • Grindmaster AMW B-Series - page 4

    Page 4 B-SERIES LOW TEMP / NO BREW MODE: When set to “ON”, a brew cycle cannot be initiated until tank is hot and “READY” light is ON. When set to “OFF”, a brew cycle may be initiated at any time. POUR-OVER MODE: Note: Not available on B-6, B-DAP , and B-DGP (twin) models. Brewers are capable of operating without a pressurized water sou ...

  • Grindmaster AMW B-Series - page 5

    User Lockout User Lockout is achieved via the position of the LOCK jumper on the board header . Locate the header on the board (shown below) and place the jumper in the desired position. In the Locked position all menus in this document are locked out, and the unit will only allow brewing or grinding functions. There are two versions of the header ...

  • Grindmaster AMW B-Series - page 6

    Page 6 B-SERIES Programming for B-Series ...

  • Grindmaster AMW B-Series - page 7

    B-SERIES Page 7 Models B-3, B-3WR, B-3WL, B-SAP & B-ID Parts List serial numbers A166225 and lower (without a -P suffix) A12124 Spray Head Deflector Kit A531-072 Heater Relay , 12VDC coil A554-109 T ransformer 30V A, 24V ct A71934 Controller Kit A61467 Switch, 120 or 240 Heater (Dual volt models only) A71683 24V Inlet V alve A71619 Brew Basket ...

  • Grindmaster AMW B-Series - page 8

    Models B-3, B-3WR, B-3WL, B-SAP & B-ID Parts List serial numbers A166226P and higher (with a -P suffix) Model B-3 Dual V oltage Unit Shown A12124 Spray Head Deflector Kit A71450 Heater Relay , 24VDC coil A554-109 T ransformer 30V A, 24V ct A530-059 Controller A61467 Switch, 120 or 240 Heater (Dual volt models only) A71683 24V Inlet V alve A7161 ...

  • Grindmaster AMW B-Series - page 9

    Models B-3, B-3WR, B-3WL, B-SAP & B-ID Part s List Dual V oltage Unit Shown A71562 Element, 240V/3500W A62305 Thermost at, Hi-Limit A71567 Thermistor A544-008 Grommet, Probe (3) A71684 24V Dump V alve A61243 Grommet, Dump V alve T ouch Pad w/Cable* (see note under photo) A71561 Element, 120V/1500W A71681 Gasket, T ank A71570 Decal T -Pad, B-3, ...

  • Grindmaster AMW B-Series - page 10

    Models B-6, B-DGP & B-DAP Part s List serial numbers A166225 and lower (without a -P suffix) A71822 Decal, T- p a d B-6 A71823 Decal, T -p ad, B-DAP , B-DGP A548-128 Deflector Spray Head (2) A61481 T ransformer (2) 40V A, 24VCT A71934 Controller Kit (2) A71619 Brew Basket Assy . (not shown) (2) A13029 W armer Heater (not shown) A71577 W armer P ...

  • Grindmaster AMW B-Series - page 11

    Models B-6, B-DGP & B-DAP Part s List serial numbers A166226P and higher (with a -P suffix) A71822 Decal, T- p a d B-6 A71823 Decal, T -p ad, B-DAP , B-DGP A548-128 Deflector Spray Head (2) A61481 T ransformer 40V A, 24VCT A530-059 Controller A71619 Brew Basket Assy . (not shown) (2) A13029 W armer Heater (not shown) A71577 W armer Plate (not s ...

  • Grindmaster AMW B-Series - page 12

    Models B-6, B-DGP & B-DAP Part s List A62305 Thermost at Hi-Limit A71936 Element, 240V/6000W A71562 Element, 240V/3500W A71508 Heat Sensor Probe A61 108 Level Probe A71567 Thermistor (see NOTE 1 below) A71 147 Grommet Probe (4) A61243 Grommet Dump V alve A71684 V alve Dump T ouch Pad w/ Cable (2)** (see Note 2 below) A548-127 Nozzle, Spray Head ...

  • Grindmaster AMW B-Series - page 13

    TROUBLESHOOTING GUIDE Weak coffee Strong coffee Bitter coffee Grounds in coffee Brew basket overflowed Unpleasant taste Quantity of coffee dispensed each throw is not the same Circuit breaker trips continuously Control board displays “P-O” Control board displays “ER2” W ater boiling (or steaming) No lights are on (including warmer lights) T ...

  • Grindmaster AMW B-Series - page 14

    Wiring Diagram Models B-3, B-3WR, B-3WL, B-SAP & B-ID serial numbers A166225 and lower (without a -P suffix) Page 14 B-SERIES ...

  • Grindmaster AMW B-Series - page 15

    Wiring Diagram Models B-3, B-3WR, B-3WL, B-SAP & B-ID serial numbers A166225 and lower (without a -P suffix) B-SERIES Page 15 ...

  • Grindmaster AMW B-Series - page 16

    Wiring Diagram Models B-6, B-DAP , B-DGP serial numbers A166225 and lower (without a -P suffix) Page 16 B-SERIES ...

  • Grindmaster AMW B-Series - page 17

    Wiring Diagram - E Models Models B-6, B-DAP , B-DGP serial numbers A166225 and lower (without a -P suffix) B-SERIES Page 17 ...

  • Grindmaster AMW B-Series - page 18

    Wiring Diagram Models B-3, B-3WR, B-3WL, B-SAP & B-ID serial numbers A166226P and higher (with a -P suffix) Page 18 B-SERIES ...

  • Grindmaster AMW B-Series - page 19

    Wiring Diagram Models B-3, B-3WR, B-3WL, B-SAP & B-ID serial numbers A166226P and higher (with a -P suffix) B-SERIES Page 19 ...

  • Grindmaster AMW B-Series - page 20

    Wiring Diagram Models B-6, B-DAP , & B-DGP serial numbers A166226P and higher (with a -P suffix) Page 20 B-SERIES ...

  • Grindmaster AMW B-Series - page 21

    Wiring Diagram - E Models Models B-6, B-DAP , & B-DGP serial numbers A166226P and higher (with a -P suffix) B-SERIES Page 21 ...

  • Grindmaster AMW B-Series - page 22

    ...

  • Grindmaster AMW B-Series - page 23

    ...

  • Grindmaster AMW B-Series - page 24

    Grindmaster® Coffee Grinders and Br ewers • PrecisionBrew™ Br ewing Systems • Espressimo® Espresso Machines Crathco® Hot Beverage Dispensers • Crathco® Cold and Frozen Beverage Dispensers • AMW Cof fee and T ea Systems T el (502) 425-4776 • Fax (502) 425-4664 • 1-800-695-4500 (USA & Canada only) P .O. Box 35020 • Louisville, ...

Manufacturer Grindmaster Category Hot Beverage Maker

Documents that we receive from a manufacturer of a Grindmaster AMW B-Series can be divided into several groups. They are, among others:
- Grindmaster technical drawings
- AMW B-Series manuals
- Grindmaster product data sheets
- information booklets
- or energy labels Grindmaster AMW B-Series
All of them are important, but the most important information from the point of view of use of the device are in the user manual Grindmaster AMW B-Series.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Grindmaster AMW B-Series, service manual, brief instructions and user manuals Grindmaster AMW B-Series. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Grindmaster AMW B-Series.

Similar manuals

A complete manual for the device Grindmaster AMW B-Series, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Grindmaster AMW B-Series by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Grindmaster AMW B-Series.

A complete Grindmaster manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Grindmaster AMW B-Series - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Grindmaster AMW B-Series, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Grindmaster AMW B-Series, that we can find in the current document
3. Tips how to use the basic functions of the device Grindmaster AMW B-Series - which should help us in our first steps of using Grindmaster AMW B-Series
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Grindmaster AMW B-Series
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Grindmaster AMW B-Series in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Grindmaster AMW B-Series?

Use the form below

If you did not solve your problem by using a manual Grindmaster AMW B-Series, ask a question using the form below. If a user had a similar problem with Grindmaster AMW B-Series it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)