English dropdown-ico

Manual Electrolux 34942G

28 pages 0.25 mb
Download

Go to site of 28

Summary
  • Electrolux 34942G - page 1

    34942G Gas hob Operating Instructions GB ...

  • Electrolux 34942G - page 2

    2 Important Safety Information Y ou MUST r ead these warnings car efully befor e installing or us ing the hob. If you need assistance, contact our Customer Care Department on 087 05 350 350 Installation  This hob must be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant British Standards.  An ...

  • Electrolux 34942G - page 3

    3  When using the hob for a long period of time, the ventilation should be improved, by opening a window or increasing the extractor speed.  Do not use this hob if it is in contact with water . Do not operate the hob with wet hands.  Ensure the control knobs are in the ‘OFF’ position when not in use.  When using other electrical app ...

  • Electrolux 34942G - page 4

    4 Contents Important Safety Information .................................................................... 2 Instructions for the User .............................................................................. 6 Description of the Hob ........................................................................................... 6 Operation ..... ...

  • Electrolux 34942G - page 5

    5 This appliance is manufactured accor ding to the following EEC directives: 73/23 EEC - 90/683 EEC - 93/68 EEC - 89/336 EEC - 90/396 EEC, current edition. Guide to Use the in struction s The following symbols will be found in the text to guide you throughout the Instructions: Safety Instructions Step by step instructions for an oper ation Hints an ...

  • Electrolux 34942G - page 6

    6 1. Hob T op 2. Rapid Burner 3. Semi-rapid Burners 4 . Triple-cr own Burner 5. Auxiliary Burner 6. Control knob for back left burner (semi-rapid) 7. Control knob for back right burner (semi-r apid) 8. Control knob for front right burner (auxiliary) 9 . Control knob for central burner (triple-crown) 10 . Control knob for front right burner (r apid) ...

  • Electrolux 34942G - page 7

    7 Operation Burner minimum m aximum diameter diameter Triple-crown (ultra-rapid) 160 mm 260 mm Lar ge (r apid ) 160 mm 240 mm Medium (semi-rapid) 120 mm 220 mm Small (auxiliary) 80 mm 160 mm As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering. If you use a saucepan which is smaller than the recom ...

  • Electrolux 34942G - page 8

    8 Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply . The hob is best cleaned whilst it is still warm, as spillage can be removed mor e easily than if it is left to cool. The Hob To p Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little washing ...

  • Electrolux 34942G - page 9

    9 Something Not Working? If the hob is not working correctly , please carry out the following checks before contacting your local Service Force Centre. SYMPT OM  There is no spark when lighting the gas  The gas ring burns unevenly SOLUTION  Check that the unit is plugged in and the electrical supply is switched on  Check that the RCCB h ...

  • Electrolux 34942G - page 10

    10 Service and Spar e Part s When you contact the Service Centre, they will need the following information: 1. Y our name, address and post code. 2. Y our telephone number 3. Clear and concise details of the fault 4 . The model and the serial number (see rating label on the back of this instruction booklet) 5. Date of purchase If you requir e spare ...

  • Electrolux 34942G - page 11

    11 Guarantee Conditions Standar d guarantee conditions We, AEG-Electrolux, undertake that if within 12 months of the date of the purchase this AEG- Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workman- ship or materials, we will, at our discretion repair or r eplace the same FREE OF CHARGE for labour , ...

  • Electrolux 34942G - page 12

    12 OVERALL DIMENSIONS Width: 860 mm Depth: 500 mm Height: 8 8 m m Weight: 1 6 K g CUT OUT DIMENSIONS Width: 830 mm Depth: 470 mm Thickness: 3 0 m m SUPPLY CONNECTIONS Gas: RC 1/2 inch (1/2 inch male) Rear right hand corner Electric: 2 30 V 50 Hz , 220 V 60 Hz s upply , 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fus ...

  • Electrolux 34942G - page 13

    13 Burner Dia. Tap By-pass 1/100 mm Auxiliary 28 Semi-rapid 32 Rapid 40 Triple-Crown 5 6 Aeration adjustment none BURNER RAPID S E M I-RAPID AUXILIARY T R IP L E (large) ( m edium) ( small) CROWN POSITION MA X MI N MA X M IN M AX MI N MA X MI N NOMINAL THERMAL POWER (kW) 3 . 0 0 . 6 5 2 . 0 0 . 4 5 1 . 0 0 . 3 3 4 . 0 1 . 2 NOMINAL FLOW RATE (m 3 / ...

  • Electrolux 34942G - page 14

    14 Important safety r equir ements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). Detailed recommendations are contained in the following British Standards Codes Of Practice: B .S. 6 172/ B.S. 5440, P ar . 2 and B.S. 6891 Current Edi ...

  • Electrolux 34942G - page 15

    15 CLEARANCES REQUIRED WHEN FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE CLEARANCES REQUIRED WHEN FITTING THE GAS HOB WITH A COOKER HOOD ABOVE Installation IMPORTANT This hob must be installed by qualified personnel to the relevant British Standar ds. Any gas installation must be carried out by a CORGI register e d installer . The manufacturer w ...

  • Electrolux 34942G - page 16

    16 A) End of shaft with nut B) Washer C) Elbow FO 0814 FO 0264 On the end of the shaft, which includes the G 1/2" threaded elbow , adjustment is fixed so that the washer is fitted between the components as shown in the diagram. Scr ew the parts together without using excessive force. It is important to install the elbow corr ectly , with the s ...

  • Electrolux 34942G - page 17

    17 Cut Out Size The dimensions of the cut-out are given in the diagram. Building In Building over a cupboar d or drawer If the hob is to be installed above a cupboard or dr awer it will be necessary to fit a heat resistant boar d below the base of the hob on the underside of the work surface. It is also recommended to carry out the electrical conne ...

  • Electrolux 34942G - page 18

    18 ON/OFF SWITCH FLEX OUTLET ON/OFF SWITCH FLEX OUTLET FO 0763 FO 0764 12 Building over a kitchen unit with door Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in diagram 3. The panel fitted under t ...

  • Electrolux 34942G - page 19

    19 Building in Fitting the hob to the worktop Before fitting the hob into the cut out, a sealing gasket supplied with the hob must be fitted to the edge of the cut out. It is essential that no gaps are left in this seal in or der to prevent spillage near the hob seeping into the cabinet below . 1) Place the sealing gasket all around the edge of the ...

  • Electrolux 34942G - page 20

    20 Electrical connection s Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS HOB MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. This hob is designed to be connected to a 23 0 V ...

  • Electrolux 34942G - page 21

    21 P ermanent Connection In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the requir ed load in compliance with the curr ent electric regulations. The switch must not brea ...

  • Electrolux 34942G - page 22

    22 Fault Finding Preliminary Electrical Sy stems Check START Isolate appliance and carry out: A: Earth Continuity check. Has inlet fuse blown? Carry out: C: Polarity check. Electricity supply should now be satisfactory. Carry out: D: Resistance to Earth check. Inlet wiring faulty. Rectify any fault. Isolate appliance and carry out: B: Insulation ch ...

  • Electrolux 34942G - page 23

    23 A. EARTH CONTINUITY CHECK Appliance must be electrically disconnected - meter set on ý (Ohms) x 1 scale and adjust zero if necessary . — Test leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 ý (Ohm), check all earth wires for continuity and all contacts are clean and tight. B. INSULA TION CHECK Ap ...

  • Electrolux 34942G - page 24

    24 Check gas supply at burner Ignition System / Gas Ignition YES Check plug top fuse and replace if necessary Check polarity and earth continuity of supply point Check earth continuity of appliance Ignitor does not spark Check fitting of burners Check position of the electrode Check by pass simmer adjusted Light burner manually Check continuity fro ...

  • Electrolux 34942G - page 25

    25 Commis sioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedur e below . 1) T urn the gas tap to the MAX position and ignite. 2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extingui ...

  • Electrolux 34942G - page 26

    26 Conver sion fr om Natur al Gas to LPG It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted and the gas rate is adjusted to suit. Method 1 ) Ensure that the gas taps are in the 'OFF' position 2 ) Isolate the hob fro ...

  • Electrolux 34942G - page 27

    27 ...

  • Electrolux 34942G - page 28

    35690-3001 03 /05 Grafiche MDM - Forlì From the Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 m illion Electrolux G r oup products (such as refrigerators, cookers, washing machines, vacuum cleaners, chain saws and lawn mo ...

Manufacturer Electrolux Category Gas Grill

Documents that we receive from a manufacturer of a Electrolux 34942G can be divided into several groups. They are, among others:
- Electrolux technical drawings
- 34942G manuals
- Electrolux product data sheets
- information booklets
- or energy labels Electrolux 34942G
All of them are important, but the most important information from the point of view of use of the device are in the user manual Electrolux 34942G.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Electrolux 34942G, service manual, brief instructions and user manuals Electrolux 34942G. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Electrolux 34942G.

Similar manuals

A complete manual for the device Electrolux 34942G, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Electrolux 34942G by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Electrolux 34942G.

A complete Electrolux manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Electrolux 34942G - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Electrolux 34942G, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Electrolux 34942G, that we can find in the current document
3. Tips how to use the basic functions of the device Electrolux 34942G - which should help us in our first steps of using Electrolux 34942G
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Electrolux 34942G
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Electrolux 34942G in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Electrolux 34942G?

Use the form below

If you did not solve your problem by using a manual Electrolux 34942G, ask a question using the form below. If a user had a similar problem with Electrolux 34942G it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)