Manual Yeoman 8455

27 pages 1.96 mb
Download

Go to site of 27

Summary
  • Yeoman 8455 - page 1

    INSTALLATION, SERVICING AND USER INSTRUCTIONS For use in Great Britain and the Republic of Ireland (GB, IE) These instructions are to be left with the customer and should be read carefully and kept in a safe place. They will be necessary when servicing the appliance PM204 Issue 1 (July 2007) IMPORTANT THIS APPLIANCE MUST ONLY BE OPENED, INSTALLED A ...

  • Yeoman 8455 - page 2

    2 Contents APPLIANCE COMMISSIONING CHECKLIST 3 GUARANTEE 3 USER INSTRUCTIONS 4 INSTALLATION INSTRUCTIONS 9 Technical Specifications 9 Site Requirements 10 Installation 12 COMMISSIONING 18 SERVICING INSTRUCTIONS 19 Fault Finding 19 How to Replace Parts 21 Basic Spare Parts List 25 Service Records 26 ...

  • Yeoman 8455 - page 3

    3 FLUE CHECK PASS FAIL 1. Flue is correct for appliance 2. Flue flow test N/A 3. Spillage test N/A GAS CHECK 1. Gas soundness & let by test 2. Standing pressure test mb 3. Appliance working pressure (on High Setting) mb NB All other gas appliances must be operating on full 4. Gas rate m 3 /h 5. Does ventilation meet appliance requirements 6. Ha ...

  • Yeoman 8455 - page 4

    4 USER INSTRUCTIONS 1.1 A competent person must carry out installation and servicing. 1.2 In all correspondence, please quote the appliance type and serial number, which can be found on the databadge located on a tag/chain behind the appliance. 1.3 Ensure that curtains are not positioned above the appliance and there is at least 300mm between the s ...

  • Yeoman 8455 - page 5

    5 USER INSTRUCTIONS 4.1 Your stove is fitted with a control valve that can be upgraded to battery powered Remote Control. This upgrade can be fitted by anyone capable of simple DIY jobs. Your Yeoman dealer keeps two versions of the remote: 4.2 STANDARD REMOTE CONTROL (Yeoman PART NUMBER YM-8455) This remote controls the gas stove after the pilot ha ...

  • Yeoman 8455 - page 6

    6 USER INSTRUCTIONS • Remove the ceramic fuel bed components and place to one side You must protect floor covers and handle the ceramic logs with care 5.3 The logs should not require cleaning: • Do not use a vacuum cleaner or brush to clean the logs • Remove any large debris by hand • Make sure no debris blocks the burner ports 5.5 See Sect ...

  • Yeoman 8455 - page 7

    7 USER INSTRUCTIONS 6.5 There are two ash panels to lie across the front of the burner. • Place the panel with the flat edge facing the left side of the firebox. There are location holes on this log fitting the screw holes on the burner. • Place the second ash panel to the right of the first, the pointed end of this panel fitting the V shape an ...

  • Yeoman 8455 - page 8

    8 USER INSTRUCTIONS This is a safety feature incorporated in all Gazco fires to automatically switch off the gas supply if the pilot light goes out and fails to heat the thermocouple. The surface coating on your Yeoman stove ‘burns off’ during the first 24 hours of operation on high, producing a harmless and temporary odour. If the odour persis ...

  • Yeoman 8455 - page 9

    9 INSTALLATION INSTRUCTIONS TECHNICAL SPECIFICATION Model CAT. Gas Gas Type Working Pressure Aeration Injector Gas Rate m3⁄h Input kW (Gross) Country High Low Dartmoor: YM-N9201BFLUC YM-N9201BFLUCHC I 2H Naural Gas G20 20 mbar ø14.5 mm 375 0.611 6.4 Gross 3.2 Gross GB,IE Dartmoor: YM-N9201BFLUC YM-N9201BFLUCHC I 3+ LPG Propane G31 LPG Butane G30 ...

  • Yeoman 8455 - page 10

    10 NOTE: This appliance can only be installed in conjunction with the flue supplied. 1.1 The flue must be sited in accordance with BS5440: Part 1 (latest editon). See Diagram 1. 1.2 Any terminal which is less than 2 metres above any access (level ground, balcony or above a flat roof to which people have access), is to be fitted with the guard. 1.3 ...

  • Yeoman 8455 - page 11

    11 INSTALLATION INSTRUCTIONS SITE REQUIREMENTS 1.2 REAR FLUE 8526 Terminal dimensions: 395 x 200 x 200 mm (H x W x D) Cut to length as required on site. Guard Supplied. 2 AR0630 ...

  • Yeoman 8455 - page 12

    12 INSTALLATION INSTRUCTIONS INSTALLATION 1.1 Your stove is fitted with a control valve that can be upgraded to battery powered Remote Control. This upgrade can be fitted by anyone capable of simple DIY jobs. Your Yeoman dealer keeps two versions of the remote: 1.2 STANDARD REMOTE CONTROL (Yeoman PART NUMBER YM-8455) This remote controls the gas st ...

  • Yeoman 8455 - page 13

    13 INSTALLATION INSTRUCTIONS INSTALLATION • Remove the remnant of cardboard • File the newly cut edges to smooth 3.5 External Fixings From outside: • Push the flue assembly through the hole until the terminal is flat against the wall • Make sure the terminal is vertical NOTE ITS ORIENTATION, DIAGRAM 3 • Mark the four fixing holes • Remo ...

  • Yeoman 8455 - page 14

    14 INSTALLATION INSTRUCTIONS INSTALLATION 1 x wall plate 1 x 75mm restrictor fixing screws This kit provides the minimum materials and extra lengths can be added to the vertical and horizontal sections; refer to the next section (6) and Diagram 3. Refer to the Technical Specification page to identify when to use a restrictor. An additional bend can ...

  • Yeoman 8455 - page 15

    15 INSTALLATION INSTRUCTIONS INSTALLATION Canopy Fitting 3.3 To fit the canopy to the top of the stove: • Slide the canopy over the top plate, Diagram 4 • Make sure the stove top fits into the guide along the bottom of the canopy, Diagram 5 • Push the canopy back until it hits the stop • Make sure the canopy sits square on top of the stove ...

  • Yeoman 8455 - page 16

    16 INSTALLATION INSTRUCTIONS INSTALLATION • Open the door as set out in Section 5 of the Users Instructions • Remove all the protective packaging from the components The fuel bed consists of 5 logs and 2 ash panels. The logs have letters A,B,C,D and E moulded into them for identification. 5.1 • Take the rear log A • Place it up against the ...

  • Yeoman 8455 - page 17

    17 INSTALLATION INSTRUCTIONS INSTALLATION 5.6 • Place log E across from the rear of log A to log C on the right-hand side using the shaped cut-outs as location guides. The front of the log should sit on the front ash panels and should fit tight to log C, Diagram 13 5.7 • Manoeuvre the frame under the top edge to secure in place, Diagram 14 • ...

  • Yeoman 8455 - page 18

    18 INSTALLATION INSTRUCTIONS COMMISSIONING 1.1 Having run the gas supply to the stove: • Purge the Supply Pipe to expel any debris blocking the gas controls • Connect the gas supply to the 8mm compression elbow at the RH rear of the stove, see diagram 1 1.2 • Connect suitable pressure gauge to the test point on inlet fitting • Turn gas supp ...

  • Yeoman 8455 - page 19

    19 SERVICING INSTRUCTIONS SERVICING/FAULT FINDING 1 AR0620 This stove must be serviced at least once a year by a competent person. All tests must be serviced by best practice as described by the current CORGI recommendations. Refer to ADVICE ON HANDLING AND DISPOSAL OF FIRE CERAMICS In Installation Instructions section 5 1.1 Before any tests are un ...

  • Yeoman 8455 - page 20

    20 SERVICING INSTRUCTIONS SERVICING/FAULT FINDING ...

  • Yeoman 8455 - page 21

    21 SERVICING INSTRUCTIONS REPLACING PARTS 1.1 All main components can be replaced without removing the stove from its installation. I T IS ESSENTIAL THAT THE GAS SUPPLY TO THE STOVE IS TURNED OFF AT THE ISOLATION DEVICE BEFORE PROCEEDING FURTHER . 1.2 If you need to remove the flue from the stove, you must replace its seals. 2.1 Turn the gas supply ...

  • Yeoman 8455 - page 22

    22 SERVICING INSTRUCTIONS REPLACING PARTS 3.3 To remove the electrode: • Disconnect the ignition lead and undo the retaining nut • Remove the electrode noting the orientation of the electrode terminal when reassembling, Diagram 4 3.4 To remove the thermocouple: • Undo the retaining nut and withdraw the thermocouple, Diagram 5 • Undo the the ...

  • Yeoman 8455 - page 23

    23 SERVICING INSTRUCTIONS REPLACING PARTS 4.2 • Replace with a new ignition lead following the same route as the old one • Replace the valve cover and the pilot assembly 4.3 • Check operation of the new ignition lead 5.1 The piezo assembly used on this appliance is not serviceable and is unlikely to fail. 5.2 If a new piezo is required, you m ...

  • Yeoman 8455 - page 24

    24 SERVICING INSTRUCTIONS REPLACING PARTS • Undo the magnetic valve-retaining nut from the back of the control valve • Gently tap out the magnetic valve and replace with a new unit • Replace the retaining nut and tighten, Diagram 13 7.2 • Reassemble the interrupter block and leads • Secure the thermocouple connection at the rear of the ga ...

  • Yeoman 8455 - page 25

    25 SERVICING INSTRUCTIONS REPLACING PARTS 10.1 In order to change between gas types you need to change the following items. • Pilot Unit • Control Valve • Main Injector • Aeration Plate (if required) • Databadge The relevant parts can be ordered as a conventional kit from Yeoman. Always quote the stove type and serial number when ordering ...

  • Yeoman 8455 - page 26

    26 SERVICE RECORDS 1ST SERVICE Date of Service:........................................................................... Next Service Due:....................................................................... Signed:........................................................................................ Dealer's Stamp/CORGI Registration Num ...

  • Yeoman 8455 - page 27

    A division of Stovax Ltd Falcon Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7LF Tel: (01392) 474500 Fax: (01392) 219932 E-mail: yeoman@stovax.com www.yeoman-stoves.co.uk ...

Manufacturer Yeoman Category Riding Toy

Documents that we receive from a manufacturer of a Yeoman 8455 can be divided into several groups. They are, among others:
- Yeoman technical drawings
- 8455 manuals
- Yeoman product data sheets
- information booklets
- or energy labels Yeoman 8455
All of them are important, but the most important information from the point of view of use of the device are in the user manual Yeoman 8455.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Yeoman 8455, service manual, brief instructions and user manuals Yeoman 8455. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Yeoman 8455.

Similar manuals

A complete manual for the device Yeoman 8455, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Yeoman 8455 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Yeoman 8455.

A complete Yeoman manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Yeoman 8455 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Yeoman 8455, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Yeoman 8455, that we can find in the current document
3. Tips how to use the basic functions of the device Yeoman 8455 - which should help us in our first steps of using Yeoman 8455
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Yeoman 8455
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Yeoman 8455 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Yeoman 8455?

Use the form below

If you did not solve your problem by using a manual Yeoman 8455, ask a question using the form below. If a user had a similar problem with Yeoman 8455 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)