Manual KitchenAid 1435

16 pages 1.03 mb
Download

Go to site of 16

Summary
  • KitchenAid 1435 - page 1

    - Installation Instructions 30” Built-In Microwave Convection Hood L IMPORTANT: Installer: Leave Installation Instructions with the Homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use. READ THESE INSTRUCTIONS BEFORE YOU START TO INSTALL THIS UNIT. KEEP IN ...

  • KitchenAid 1435 - page 2

    30” BUILT-IN MICRO WAVE /HOOD MODEL KHMC106 W INSTALLATION INSTRUCTIONS CONTENTS: Introduction ....................................................................... 1 Mounting Space .................................................................. 1 Wall Construction ............................................................... 2 Electrical ...

  • KitchenAid 1435 - page 3

    INTRODUCTION Proper installation is the installer’s responsibility. A qualified technician should install this microwave oven. Make sure you have everything necessan/ for correct installation. It is the responsibility of the installer to comply with the installation clearances specified on the serial/rating plate. The serial/rating plate is locat ...

  • KitchenAid 1435 - page 4

    WALL CONSTRUCTION Personal Injury or Property Damage Hazard l This microwave oven must be mounted against and supported by a flat, vertical wall. l This microwave oven must be attached with two lag screws to a minimum of one, vertical 2” x 4” wall stud. l Do Not mount microwave oven to an Island or peninsula cabinet. l The microwave oven top an ...

  • KitchenAid 1435 - page 5

    ELECTRICAL REQUIREMENTS Electrical ground is required on this appliance. E-&~&Hazard l Checkwithaqualifiedelectricianifyouareindoubtastowhethertheapplianceisp~perlygrounded. Improper connection of the equipment-grounding conductor can result in electrical shock. l This appliance must be properly grounded. Failure to do so may result in elec ...

  • KitchenAid 1435 - page 6

    HOOD EXHAUST DUCT When the hood is vented to the outside, a HOOD EXHAUST DUCT is required. All ductwork must be metal (do not use plastic duct). Check that all connections are made securely. Please read the following carefully: Fire Hazard Mntirg system must terminate to the outside. Do Not terminate the ductwoh in an attic or other enclosed space. ...

  • KitchenAid 1435 - page 7

    TOOLS RECOMMENDED FOR INSTALLATION Phillips Screwdriver Electric Drill l/2”, 5/8” and 3/32’ Drill Bits 1 -l/2’ Wood Bit or metal hole cutter (if metal cabinet is used) Saw to cut exhaust opening (if needed) Knife or single edge razor Pencil Measure Tape Protective drop cloth for product and range. You may use part of the carton for protecti ...

  • KitchenAid 1435 - page 8

    PREPARATION OF CARTON Utilization of the canon may make installation easier. CHECK THE PRODUCT FOR DAMAGE 1. Remove product and shipping pads. Visually check the product after removing from carton. Remove all packing material from inside the oven cavity. Check the oven for any damage, such as misaligned door, damaged gaskets around door or dents in ...

  • KitchenAid 1435 - page 9

    VENTILATION SYSTEM THIS MICROWAVE OVEN/HOOD SYSTEM IS DESIGNED FOR ADAPTATION TO THREE TYPES OF HOOD VENTILATION SYSTEMS: A. Vertical Exhaust -- outside ventilation B. Horizontal Exhaust -- outside ventilation C. Recirculating -- non-vented, ductless Select the type required for your installation. Recirculating (ductless) installation requires CHAR ...

  • KitchenAid 1435 - page 10

    HORIZONTAL EXHAUST (Continued) 2. Withdraw hood fan unit upward carefully (Fig.4). Figure 4 1. 3. Rotate hood fan unit l/4 turn as shown in Figure5 Figure 5 4. Replace hood fan unit into the oven unit. Be careful not to pinch the lead wire between the inner bracket and the hood fan unit (Fig.6). Figure 6 8 ...

  • KitchenAid 1435 - page 11

    1 ,, .:y 2. -- .; . . . -A.,~*;-,-, .-. 5. Replace the fan cover bracket. Make sure the fan blades are visible through the rear openings in the cover before proceeding. Attach cover to unit with 3 screws (Fig. 7). The hood fan unit is now rotated for horizontal exhaust operation See page 11 for exhaust adaptor assembly installation instructions. C. ...

  • KitchenAid 1435 - page 12

    PREPARATION OF WALL AND TOP CABINET MOUNTING TEMPLATES THIS PRODUCT CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON BOTH TEMPLATES. READ AND FOLLOW MOUNTING INFORMATION ON BOTH TOP CABINET AND WALL TEMPLATES WALL AND TOP CABINET I personal Injury or property Dama* Hazard The mounting area on the top cabinet and ...

  • KitchenAid 1435 - page 13

    5. If horizontal exhaust is used, attach the exhaust adaptor assembly to each of the mounting plates by aligning the holes on the assembly with the tabs on the plates, holding the as- sembly in place and bending the tabs to secure the assembly to the plates (Fig. 13). Exhaust Adaptor Assembly zontal exhaust only) Property Damage Hazard Place a port ...

  • KitchenAid 1435 - page 14

    Thread the oower sunulv cord throueh the hole made at the bottom of the ton cabinet I Personal Injury Hazard Two people are required to lift this microwave. Failure to use more than one person during installation may result in oersonal iniurv. I Hang the unit on the lower edge of the mounting plates. Rotate the unit upward until it engages the uppe ...

  • KitchenAid 1435 - page 15

    8. Use the two top cabinet mounting screws (C) and flat washers (D), supplied in the installation hardware, to attach the unit to the top cabinet. See Figurel6. Note: If mounting plates were installed using only toggle bolts, use the adjusting screws to attach the unit to the top cabinet. ommet (for metal Figure1 6 9. Make a bundle of the power sup ...

  • KitchenAid 1435 - page 16

    4 I-? 4S72 PART NO. KHMCIOGW PRINTED IN U.S.A. ...

Manufacturer KitchenAid Category Microwave Oven

Documents that we receive from a manufacturer of a KitchenAid 1435 can be divided into several groups. They are, among others:
- KitchenAid technical drawings
- 1435 manuals
- KitchenAid product data sheets
- information booklets
- or energy labels KitchenAid 1435
All of them are important, but the most important information from the point of view of use of the device are in the user manual KitchenAid 1435.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals KitchenAid 1435, service manual, brief instructions and user manuals KitchenAid 1435. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product KitchenAid 1435.

A complete manual for the device KitchenAid 1435, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use KitchenAid 1435 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of KitchenAid 1435.

A complete KitchenAid manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual KitchenAid 1435 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the KitchenAid 1435, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the KitchenAid 1435, that we can find in the current document
3. Tips how to use the basic functions of the device KitchenAid 1435 - which should help us in our first steps of using KitchenAid 1435
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with KitchenAid 1435
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of KitchenAid 1435 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning KitchenAid 1435?

Use the form below

If you did not solve your problem by using a manual KitchenAid 1435, ask a question using the form below. If a user had a similar problem with KitchenAid 1435 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)