Manual Omega Engineering PHTX-11

14 pages 0.47 mb
Download

Go to site of 14

Summary
  • Omega Engineering PHTX-11 - page 1

    AnO.VfEG.4 Group Company OjyjEGA ENGINEERING, INC. Operator ’ s Manual ...

  • Omega Engineering PHTX-11 - page 2

    M446/026 1 0 Copyright 1986 OMEGA ENGINEERING, INC. All rights reserved including illustrations. Nothing in this manual may be reproduced in any manner, either wholly or in part for any purpose whatsoever without written permission from OMEGA ENGINEERING, INC. Printed in U.S.A. OMEGA3 is a registered trademark of OMEGA ENGINEERING, INC. THERE ARE N ...

  • Omega Engineering PHTX-11 - page 3

    4/s 5/6 PART V SERVICE 1. 2. 3. 4. Block diagram 7 Table I 8 Transmitter dimensions input/output connections and Adjustment pot location Table II 9 10 1 2 2 2 3 4 - CALIBRATION 1. Calibration interval 5 2. Equipment required 5 3. Calibration procedure & TECHNICAL INFORMATION 1. Controls 2. Operation PART IV - OPERATION INSTRUCTION - INSTALLATIO ...

  • Omega Engineering PHTX-11 - page 4

    -l- @ 60 Hz Manual or auto to 95% 600 VDC or peak -120dB +60°C 0 .Ol%/Volt -10 to 3% digit LC D pH k.01 pH ht.01 02%/OC (Display and current out) f. pH *.Ol iim+DC>O~~~ONAL 0 to 3400 ohms Ez ii 2onlA 12 to 80 VDC 1013 ohm 4 to MODEL PHTX-11 SPECIFICATIONS Spans: Input Impedance: Output Current: Power Supply: Load Resistor: Linearity: Temperatur ...

  • Omega Engineering PHTX-11 - page 5

    -2- "U" bolts should bolt to the heavy PVC mounting feet. "U" bolts and nuts. The - attachment to a round pipe requires #lO screws and nuts. 2.3 Pipe Mounting - mounting to a flat surface requires the heavy PVC mounting feet be attached to the box. The surface should be drilled and the feet mounted with 3/4"). Cut the threa ...

  • Omega Engineering PHTX-11 - page 6

    -3- ppm/OC. f ppm/'C or wire wound *50 25'C compensation. The re- sistor used should be metal film 8.66K resistor is normally supplied with the transmitter, this value is correct for Manual temperature compensation requires only a resistor at the terminal strip connection marked with a resistor symbol. Refer to Table I for the value vs. t ...

  • Omega Engineering PHTX-11 - page 7

    -4- iO.0 buffer solution. to the user. pH or a adjustment.when the probe is in a The choice of a 4.0 or 10.0 is up 4.0 pH buffer solution "pH CAL" with the for a reading of 7.0 and the "Slope" probe in a 7.0 pH value of the buffer solution. 2.2 Probe standardization is accomplished by adjusting II-31 of this manual and placing t ...

  • Omega Engineering PHTX-11 - page 8

    -5- pH units. 112 in place. The output is adjustable for a span of 2 to 6 fl and #2 is with jumpers pH point of the range. The adjustments are sensitive and interactive, do not attempt large changes, work both ad- justments in turn with small changes. RANGE mA point at the highest 20 pH point of the range, and the "Span" sets the mA point ...

  • Omega Engineering PHTX-11 - page 9

    -6- pH levels. mA at the desired mA and the "Span" for 20 PII simulator at the input, a resistor at the temperature compensation terminals. (Refer to Table I for the correct resistor and millivolt values). Adjust the "Zero" for 4 h ZERO adjustments interact and require going back and forth between them. Connect a millivolt sourc ...

  • Omega Engineering PHTX-11 - page 10

    - --- _ - _ ----!-! -7 ‘ i _ iI __ l I < ...

  • Omega Engineering PHTX-11 - page 11

    -a- . 1.58K 1.98K 3.08K 4.74K 5.94K 8.66K 20.27K -518.2 Temp. Comp. Res. -4-4-8.8 -476. 6 -504. 4 -148.1 10 -162. 6 -177. 5 -186. 4 -192. 4 -204. 3 -216. 2 -222. 1 11 -216. 8 -236. 6 -248. 5 -256. 5 -272. 4 -288. 2 -296. 1 12 -270. 1 -295. 8 -310. 7 -320. 6 -340. 5 -360.3 , -370. 2 13 -325. 1 -354. 9 -372. 8 -384. 7 -408. 5 -432. 3 -444. 2 14 -379. ...

  • Omega Engineering PHTX-11 - page 12

    1 v- - 9 b ...

  • Omega Engineering PHTX-11 - page 13

    -l O - .t 7 ’ D I A . HOLE EL CUT-OUT TABLE II PAN ...

  • Omega Engineering PHTX-11 - page 14

    06907-0047 (203) 359-1660 Telex: 996404 Cable: OMEGA FAX: (203) 359-7700 Cornpuny One Omega Drive, Box 4047 Stamford, Connecticut AnO.MEGrl Group Benchtopllaboratory Meters Cl Controllers Cl Calibrators/Simulators ?? Transmitters PM •! Electrodes Cl Turbine/Paddlewheel Systems Cl Vortex Meters and Flow Computers FLOW C l Rotameters Cl Flowmeter S ...

Manufacturer Omega Engineering Category Satellite Radio

Documents that we receive from a manufacturer of a Omega Engineering PHTX-11 can be divided into several groups. They are, among others:
- Omega Engineering technical drawings
- PHTX-11 manuals
- Omega Engineering product data sheets
- information booklets
- or energy labels Omega Engineering PHTX-11
All of them are important, but the most important information from the point of view of use of the device are in the user manual Omega Engineering PHTX-11.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Omega Engineering PHTX-11, service manual, brief instructions and user manuals Omega Engineering PHTX-11. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Omega Engineering PHTX-11.

A complete manual for the device Omega Engineering PHTX-11, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Omega Engineering PHTX-11 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Omega Engineering PHTX-11.

A complete Omega Engineering manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Omega Engineering PHTX-11 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Omega Engineering PHTX-11, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Omega Engineering PHTX-11, that we can find in the current document
3. Tips how to use the basic functions of the device Omega Engineering PHTX-11 - which should help us in our first steps of using Omega Engineering PHTX-11
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Omega Engineering PHTX-11
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Omega Engineering PHTX-11 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Omega Engineering PHTX-11?

Use the form below

If you did not solve your problem by using a manual Omega Engineering PHTX-11, ask a question using the form below. If a user had a similar problem with Omega Engineering PHTX-11 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)