-
Sears 113.177035 - page 1
Save This Manual For Future Reference SEARS owner's manual MODEL NO. 113.177035 Serial Number Model and serial numbers may be found on the handle. You should record both model and serial numbers in a safe place for future use. FOR YOUR SAFETY READ ALL INSTRUCTIONS CAREFULLY CRRFTSMRN® 16 GALLON CORD RETRACTOR WET/DRY VAC • assembly ,_. op, ...
-
Sears 113.177035 - page 2
FULL ONE YEAR WARRANTY ON CRAFTSMAN WET/DRY VACS If within one year from the date of purchase, this Craftsman Wet/Dry Vac fails due to a defect in material or workmanship, Sears will repair it, free of charge. If this Craftsman Wet/Dry Vac is used for commercial or rental pur- poses, this warranty coverage applies for only 90 days from date of purc ...
-
Sears 113.177035 - page 3
To reduce the risk of injury from acciden- tal starting, unplug power cord before changing or cleaning filter. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. Do not use with damaged cord, plug or other parts. If your Wet/Dry Vac is not working as it should, has missing parts, has been dropped, damaged, left out- doors, o ...
-
Sears 113.177035 - page 4
Introduction This Wet/Dry Vac is intended for house- hold use only. IMPORTANT NOTE Please Read Carefully Static Shocks Are Common - In dry areas or when the relative humidity of the air is low. To reduce the frequency of static shocks in your home the best rem- edy is to add moisture to the air with a console humidifier. Owner's Manual Content ...
-
Sears 113.177035 - page 5
Float/Cage Assembly WARNING: For your own safety, never connect plug to power source outlet until all assembly steps are complete and you have read and understood the safety and operation instructions. Do not operate vac with any parts damaged or missing. 1. Place the power assembly of vac upside down into the drum. 2. Locate the float. Place the f ...
-
Sears 113.177035 - page 6
Caster/Caster Foot Assembly 1. Remove the power assembly from the dust drum and set aside. 2. Turn the dust drum upside down on the floor. 3. Insert the caster feet into the bottom of drum, as shown (4 places). 4. Push on the caster foot until the foot is flush with bottom of the dust drum. 5. Insert the caster stem into the socket of the caster fo ...
-
Sears 113.177035 - page 7
6. Insert the soft end of the hose, which is opposite the swivel end, into the vac- uum port directly above the drain. 7. Place the utility nozzle securely on the swivel end of the hose and the vac is ready for use. NOTE: The swivel end of the hose is removable if more hoses need to be attached for more length from the vac. To remove the swivel por ...
-
Sears 113.177035 - page 8
Operation WARNING To reduce the risk of fire or explosion, do not operate this vac in areas with flammable gases, vapors or explosive dust in the air. Flammable gases or vapors include but are not limited to; lighter fluid, solvent type cleaners, oil- base paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but are not limited to; ...
-
Sears 113.177035 - page 9
3.When the liquid in the drum reaches a predetermined level, the float mechanism will rise automatically to cutoff air-flow. You will know that the float has risen because vac airflow ceases andthe motor noise will become higher in pitch, due to increased motor speed. When this happens, turnoff the vac, unplug the power cord, andempty thedrum. • ...
-
Sears 113.177035 - page 10
Cord Retractor For cord storage, this vac includes a cord retractor to remove the cord from sight. Due to the height of the cord exit, it is spe- cifically designed to retract slowly. Operation 1. Locate the plug end recessed in the left side of the motor cover. 2. Place one hand on the motor cover and use the other hand to pull the cord from the v ...
-
Sears 113.177035 - page 11
Maintenance Filter WARNING: To reduce the risk of I injury from accidental starting, I unplug power cord before changing or cleaning filter. NOTE: This filter is made of high quality paper designed to stop very small parti- cles of dust. The filter can be used for wet or dry pick up. Handle the filter carefully when removing to clean or installing ...
-
Sears 113.177035 - page 12
Wet Nozzle To pick up liquids off a smooth surface, use the 2-1/2" wet nozzle accessory sup- plied with your wet/dry vac. To use this nozzle, simply attach the nozzle to the end of an extension wand. Connect a second extension wand to the first, and connect the 2-1/2" x 7' hose to the extension wand. Liquids may be picked up by dragg ...
-
Sears 113.177035 - page 13
CRRFTSMRN® Accessories and Attachments Get more versatility from your Craftsman wet/dry vacuum by adding these accessories. Additional wet/dry vac accessories may be purchased at your local Sears retail store or Sears/Craftsman Power and Hand Tool Catalog. 17822 2-1/2"x7' Hose 16934 Hose Grip 16922 Utility Nozzle 16930 Hose Lock 16917 Ho ...
-
Sears 113.177035 - page 14
Repair Parts 16 Gallon Wet/Dry Vac Model Number 113.177035 Always order by Part Number - Not by Key Number WARNING SERVICING OF DOUBLE-INSULATED WET/DRY VAC In a double-insulated Wet/Dry Vac, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should a means for grounding ...
-
Sears 113.177035 - page 15
Repair Parts 16 Gallon Wet/Dry Vac Model Number 113,177035 3 4 15 ...
-
Sears 113.177035 - page 16
For in-home major brand repair service: Call 24 hours a day, 7 days a week 1-800-4-MY-HOM E (1-800-469-4663) Para pedir servicio de reparacion a domicilio - 1-800-676-5811 For the repair or replacement parts you need: Call 6 am - 11 pm CST, 7 days a week PartsDirect 1-800-366-PART (1-800-366-7278) Para ordenar piezas con entrega a domicilio - 1-800 ...
Do you have a question concerning Sears 113.177035?
Use the form below
If you did not solve your problem by using a manual Sears 113.177035, ask a question using the form below. If a user had a similar problem with Sears 113.177035 it is likely that he will want to share the way to solve it.