English dropdown-ico

Manual Dimplex WB15

13 pages 0.08 mb
Download

Go to site of 13

Summary
  • Dimplex WB15 - page 1

    AUTO-FILL WATER BOILERS INSTRUCTION MANUAL MODELS COVERED WB3 WB7 WB15 WB5E 1 ...

  • Dimplex WB15 - page 2

    2 IMPORTANT HEALTH AND SAFETY INFORMATION PLEASE READ BEFORE USING YOUR NEW WATER BOILER Your new water boiler is designed to pr ovide a constant source of near boiling water for the preparation of hot drinks. THIS IS VERY HOT All personnel must be provided with suffi cient and appropriate training in the safe use of this appliance. An instruction ...

  • Dimplex WB15 - page 3

    3 INTRODUCTION Your new water boiler is designed to give years of trouble free service provided that the instructions contained in this manual are followed carefully. Your new boiler is energy efficient, si mple to operate and easy to service. It is recommended that the installation is ca rried out by a properly qualified fitter. CHECK LIST Before ...

  • Dimplex WB15 - page 4

    4 WARNING: THIS APPLIANCE MUST BE EARTHED REAR ENTRY OF CABLE Fixed or flexible ca ble to be connected direct to t he terminal block, cable gland not utilised. BOTTOM ENTRY OF CABLE Use the cable gland. Loos en cable-gripping nut. Pass cable through gland, leaving enough free cable to connect into the terminal block. Tighten cable gland grip nut. D ...

  • Dimplex WB15 - page 5

    5 BOTTOM ENTRY Connect to a suitable cold drinking water supply using 15mm copper pipe and push on the ‘T’ piece supplied. The ‘T’ has been blanked off using a brass plug. Leave this plug in place. Push the ‘T’ piece firmly onto the water inlet solenoid pipe with the brass plug facing forward. Then push the 15mm cold water supply firmly ...

  • Dimplex WB15 - page 6

    6 OVERFLOW PIPE REAR ENTRY In your fitting kit you will find a straight push on connector wit h a small length of 15mm copper tube pushed into it. If rear entry has been chosen this connec tor must be replaced by a push on elbow (available from plum ber’s merchants). Push the elbow onto the overflow pipe on the bracket (alongside the solenoid). T ...

  • Dimplex WB15 - page 7

    7 OPERATION (All models except WB5E) After the electrical and water connecti ons have been made, switch the power and water supply on. The power and ready lights will flash once. The power light will then be constantly illuminated to indicate mains supply. Providing the water supply is present, the ma chine will start to fill. If the machine does n ...

  • Dimplex WB15 - page 8

    8 OPERATION (WB5Eonly) After the electrical and water connecti ons have been made, switch the power and water supply on. When the power supply is switched on, t he small indicator lamp on the front panel will glow orange. This means that t he water is filling to the bottom probe. When the bottom probe has been reached, the indicator lamp will chang ...

  • Dimplex WB15 - page 9

    9 TECHNICAL SPECIFICATION ALL MODELS Tank constructed in stainless steel. Tank insulated from outer casi ng with high temper ature polystyrene. All boilers have electronic control of t he main functions. This means that the temperature is controlled precisely within given parameters. The circuit constantly monitors the operation of the machine and ...

  • Dimplex WB15 - page 10

    10 DE-SCALING All m odels except WB5E To de-scale your machine, first disconnec t the machine from the power supply. Remove the case by removing the top and bottom screws hol ding the case to the wall bracket. Drain the remaining water through the drain plug in the bottom of the tank. Remove the boiler lid by unscrewing t he fixing screws. The tank ...

  • Dimplex WB15 - page 11

    11 Clean the level sensing probes and their white holders completely using a clean non-metallic scourer. Ensure all traces of de-scaler are removed before using the boiler again. Rather than frequently de-scalin g the machine, it may be preferable to install an effective scale reducer or WRC appr oved food quality water softener. This will reduce t ...

  • Dimplex WB15 - page 12

    12 SERVICE WARNING LIGHT (All Models except WB5E) All models except WB5E have this facility. This light is designed to help you discover the cause of any malfunction. If the circuit senses a problem, the service light will flash a number of times and then pause and repeat this sequence. Count the number of flashes between pauses and refer to the ta ...

  • Dimplex WB15 - page 13

    13 fallen to a point at which the heating element(s) could be damaged. If in order call service department on 01704 502911 Quoting the Serial Number 12 The machine has over-boiled and the level has fallen to a point at which the element(s) could be damaged. Or safety cut out has come into operation see paragraphs re Temperature Control Call service ...

Manufacturer Dimplex Category Water Heater

Documents that we receive from a manufacturer of a Dimplex WB15 can be divided into several groups. They are, among others:
- Dimplex technical drawings
- WB15 manuals
- Dimplex product data sheets
- information booklets
- or energy labels Dimplex WB15
All of them are important, but the most important information from the point of view of use of the device are in the user manual Dimplex WB15.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Dimplex WB15, service manual, brief instructions and user manuals Dimplex WB15. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Dimplex WB15.

Similar manuals

A complete manual for the device Dimplex WB15, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Dimplex WB15 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Dimplex WB15.

A complete Dimplex manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Dimplex WB15 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Dimplex WB15, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Dimplex WB15, that we can find in the current document
3. Tips how to use the basic functions of the device Dimplex WB15 - which should help us in our first steps of using Dimplex WB15
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Dimplex WB15
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Dimplex WB15 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Dimplex WB15?

Use the form below

If you did not solve your problem by using a manual Dimplex WB15, ask a question using the form below. If a user had a similar problem with Dimplex WB15 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)