Bedienungsanleitung Vita-Mix 100 VAC

13 Seiten 0.23 mb
Download

Zur Seite of 13

Summary
  • Vita-Mix 100 VAC - page 1

    220/240 and 1 00 V AC Models © 2001 Vita-Mix Corporation. No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopy , recording or any information storage and retrieval system without the written permission of the Vita-Mix Corporation. VIT A-MIX ® CORPORA TION Internati ...

  • Vita-Mix 100 VAC - page 2

    13. Always operate with the lid in place. 14. W ARNING: When processing hot liquids: • The 2-part latching lid must be securely in place. This allows steam to escape naturally , and will prevent the lid from coming off when the machine is turned on. • Use caution with hot liquids. Spraying from under the lid plug can occur , or escaping steam m ...

  • Vita-Mix 100 VAC - page 3

    T ouch and Go TM Blending Station ® ON/OFF switc h - Located on the side of the Motor Base the ON/OFF switch controls the power to the machine. With the machine plugged in, switch the machine to ON to ready the machine for blending. ST AR T/ST OP b utton - Pressing ST AR T/ST OP once star ts and r uns the machine and turns the blades. Press the ST ...

  • Vita-Mix 100 VAC - page 4

    6 7 4. Within 10 seconds the SIX PRE-SET buttons will be re-programmed and the DISPLA Y WINDOW will read ‘Saved’ then ‘ Ready’. If nothing happens when the programming chip is fully inserted, turn the chip in the opposite direction and try again. 3. Remove the programming chip and return it to the original package. 5. Press one of the six P ...

  • Vita-Mix 100 VAC - page 5

    IN-COUNTER HOLE Cut 14 cm wide x 19 cm deep 19 cm deep 14 cm wide 30.48 cm 30.48 cm Additional Unit (if applicable) Additional Unit (if applicable) 24.3 cm 44.45 cm 14 . 4 cm 15.2 cm 54.7 cm 31.75 cm I n-Counter Installation 8 9 Preparing the counter area: • Before cutting holes, make sure that there is adequate clearance under the counter for th ...

  • Vita-Mix 100 VAC - page 6

    THREE PRONG AD APTERS ARE NOT T O BE USED IN CANADA. 10 11 lending T ips 1. If your recipe freezes up, try reducing the amount of ice. Compared to other blenders, you do not need as much ice to make an equally frozen drink in a T ouch and Go TM Blending Station. ® 2. Place liquids and soft foods in your container first. Hard items and ice should b ...

  • Vita-Mix 100 VAC - page 7

    T amper Tw o - part Lid 1.5 Liter P olycarbonate container The two part lid is easy to clean and easy to put on, take off and seal. • T o remove fully latched lid, squeeze tabs together on both sides of the container , pull upward and off. • T wist the center lid plug to fasten or remove. NO TE: To make ne w lids easier to inser t and remov e, ...

  • Vita-Mix 100 VAC - page 8

    4. Select desired programmed setting by pressing any of the Pre-Set Buttons 1 through 6. The machine will begin immediately to cycle through the selected program, and turn off when the program is complete. Each button has a different pre-selected combination of speed and length for blending. NO TE: If you detect a change in the sound of the machine ...

  • Vita-Mix 100 VAC - page 9

    1. Follow steps one through three of ‘Using The Pre-Set Programmed buttons’ section on page 14. 2. The speed of the motor can be changed with: 3. The PULSE buttons can also be used to temporarily increase the motor speed or decrease the motor speed. (See HIGH/LOW PULSE button description on page 5.) 4. When done blending press the ST ART/STOP b ...

  • Vita-Mix 100 VAC - page 10

    Item# Part #752 2 liter - Container without lid assembly or blade assembly #755 2 liter - Lid plug #756 2 liter - Container , blade assembly & lid assembly #1 191 2 liter - 2-piece lid assembly #1 192 2 liter - Lid only (no plug) PLS145 2 liter - 1-piece non-latching rubber lid #1 159 1 .5 liter - Lid plug #15502 1 .5 liter - Container only #15 ...

  • Vita-Mix 100 VAC - page 11

    Container 1. T o clean: Fill pitcher 1/4 full with warm (43˚C) water and add a couple drops of dish soap. * Return container to motor base and firmly position the two part lid. Run machine for 30 seconds. Empty container . Repeat this step. * NO TE: Polycarbonate container , cover and thermoplastic rubber lid are dishwasher safe. However , to prol ...

  • Vita-Mix 100 VAC - page 12

    T roubleshooting 22 23 Cooling the motor: If the machine has o verheated: • The motor will stop and the message “MOT OR HAS OVERHEA TED REMOVE THE CONT AINER, THEN PRESS ST ART”, will scroll across the display window , while the words “HOT SHUTDOWN” will remain in the display window alerting you of the problem. • The machine will not ru ...

  • Vita-Mix 100 VAC - page 13

    © 2001 Vita-Mix Corporation. No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopy , recording or any information storage and retrieval system without the written permission of the Vita-Mix Corporation. VIT A-MIX ® CORPORA TION International Foodservice Division 861 ...

Produzent Vita-Mix Kategorie Blender

Dokumente, die wir vom Produzenten des Geräts Vita-Mix 100 VAC erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Vita-Mix
- Bedienungsanleitungen 100 VAC
- Produktkarten Vita-Mix
- Informationsbroschüren
- oder Energieetiketten Vita-Mix 100 VAC
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Vita-Mix 100 VAC.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Vita-Mix 100 VAC, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Vita-Mix 100 VAC. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Vita-Mix 100 VAC ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Vita-Mix 100 VAC, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Vita-Mix 100 VAC hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Vita-Mix 100 VAC verständlich ist.

Eine gänzliche Bedienungsanleitung von Vita-Mix sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Vita-Mix 100 VAC bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Vita-Mix 100 VAC befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Vita-Mix 100 VAC, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Vita-Mix 100 VAC - die uns die ersten Schritte während der Nutzung von Vita-Mix 100 VAC erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Vita-Mix 100 VAC hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Vita-Mix 100 VAC im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Vita-Mix 100 VAC?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Vita-Mix 100 VAC nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Vita-Mix 100 VAC hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)