0.26 mb

of 4

Prev Next

Moen 12242 - page 1

MT692C INST ALLA TION INSTRUCTIONS THESE INSTRUCTIONS MUST BE LEFT WITH HOMEOWNER T187, T188, T189, T190, T191, T628, 2320, 2325, 2339, 2370, 2375, 2389 Series Models 12189, 12242, 12341, 12342, 62300, TL181, TL182, TL183, TL191 Measurements These are shown in the drawings. The depth measurement is critical. Use the front face of the plaster ground ...
Moen 12242 - page 2

MT692C WITHOUT STOPS WITH STOPS 7" 7" SHOWER SHOWER SUPPLY TUB TUB SUPPLY SUPPLY 2-3/4" C.C. & I.P.S. 2-5/16" C.C. & I.P.S. 4-13/16" C.C. 4-5/16" NOMINAL 4-1/2" PLASTER GROUND SIZE AND WALL OPENING C.C. I.P .S. CLAMP SCREW CA UTION This valve is equipped with the Moen long-life POSI- TEMP car tridge, desig ...
Moen 12242 - page 3

RETAINER CLIP CARTRIDGE NOTCH WASHER STOP TUBE KEY STOP TEMPERATURE LIMIT STOP KNOB HANDLE HANDLE ADAPTER CAP SCREW HANDLE SCREW HANDLE SCREW KNOB INSERT PLUG BUTTON HOT INLET FORWARD COLD INLET TO REAR INSTALL WITH CARTRIDGE STEM NOTCH DOWN TOP VIEW CAUTION: CARTRIDGE  MUST BE INSTALLED WITH HOT & C ...
Moen 12242 - page 4

MT692C NOV . 02 T rim MAKE SURE ALL W A TER SUPPLIES ARE OFF TO INST ALL TRIM AFTER ROUGH-IN Slide the flange onto the long end of the shower arm. Wrap both ends of shower arm with thread seal tape and screw long end of shower arm into pipe ell inside the wall. D o not install the showerhead. Install tub spout (see page 2). Remove screw holding pla ...

Moen Marine Sanitation System

:
-
-
-
-
-

1.
2.
3.
4.
5.
6.