dropdown-ico

0.04 mb

of 8

Summary
  • Universal HE-112W - page 1

    OWNER'S MANUAL PREASSEMBLED AUTOMA TIC SECURITY FLOODLIGHTS MOTION SENSOR SECURITY LIGHTING SYSTEMS LiteAide ® HE-100B HE-100BW HE-112 HE-112W HE-117 HE-117W HE-117-2B ...

  • Universal HE-112W - page 2

    OWNER'S MANUAL Also regard the following considerations:  The security floodlight operates on 1 10-120 volt, 60 Hertz electrical power only . Do not connect it to any other voltage source.  Locate the security floodlight at least 8 feet (2.5 meters) above the ground.  The security floodlight sensor may not point toward a reflective su ...

  • Universal HE-112W - page 3

    CAUTION Never allow sunlight to shine directly into the security floodlight sensor prior to, during or after installation. Direct sunlight could damage the sensor . 2 . Remove the preassembled security floodlight from the box. Locate shield slots and push down over four retainer pins. T urn to lock in place. 3. Observe three controls on the sensor ...

  • Universal HE-112W - page 4

    Connect the security floodlight only to 1 10-120 volt, 60 Hertz electrical power . There is sufficient voltage and current to harm you if you come into contact with the 1 10-120 volt, 60 Hertz electrical power . 1. T urn off all electrical power to the old floodlight as follows: W ARNING Ensure that the 1 10-120 volt, 60 Hertz electrical power to t ...

  • Universal HE-112W - page 5

    ADJUSTMENTS AND TESTING Four easy adjustment and testing steps put your security floodlight into operation: sensor and floodlight positioning, test, timing adjustment and sensitivity adjustment. Y ou can make these adjustments and tests in daylight. After a few days of operation, you may want to make readjustments - refer to FINAL ADJUSTMENTS. Sens ...

  • Universal HE-112W - page 6

    3 . After the correct position has been established, tighten the elbow joint screw and the sensor head locknut at the end of the elbow (near the cover). Screw the lamps into the sockets. W alk T est T esting can be performed during daylight. T esting includes applying electrical power , walking into the sensing area to determine if the sensor head ...

  • Universal HE-112W - page 7

    The floodlight remains on the set time between 5 seconds and 18 minutes (approximate). The manual mode permits you to turn the security floodlight on for as long a time period as you desire. Y ou end the on-time by manually turning the security floodlight off and then back on after 5 seconds (the security floodlight is now in the automatic mode). I ...

  • Universal HE-112W - page 8

    LIMITED 5 YEAR WARRANTY Universal Security Instruments, Inc. ("Universal") warrants your Universal product to be free from defects in material and workmanship for a period of five (5) years from the date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal residential use and servi ...

Universal Home Security System

:
-
-
-
-
-






1.
2.
3.
4.
5.
6.

Captcha

(0)