-
Jeep HP6375 - page 1
A D Jeep ® T rail Guide ™ B 1/2” (12.5 mm) 7/32” (5.6 mm) • Disconnect and isolate the negative battery cable. • Clean dash with isopropyl alcohol. • Débranchez et isolez le câble négatif de la batterie. • Nettoyez le tableau de bord avec de l’alcool isopropylique . • Desconecte y aísle el cable negativo de la batería. • L ...
-
Jeep HP6375 - page 2
Secure template on underside of top panel. ♦ Fixez le gabarit sur la face inférieure du panneau supérieur . ♦ Arme la plantilla a la parte de abajo del panel superior . ♦ If present, remove compass module from underside of top panel. ♦ S’il est installé, retirez le module de boussole de la face inférieure du panneau supérieur . ? ...
-
Jeep HP6375 - page 3
Remove template. Drill holes. ♦ Retirez le gabarit. Percez les trous. ♦ Retire la plantilla. Perfore los agujeros. ♦ 7/32” (5.6 mm) Connect cigarette lighter harness. Route cable up through dash. T est for switched power at the cigarette lighter using a (DVOM) Digital V olt – Ohm Meter . Reinstall trim panel. ♦ Connectez le câble de la ...
-
Jeep HP6375 - page 4
Snap ♦ Fixation ♦ Ajuste ♦ Route cable through hole in top panel. Connect to bottom of mount. ♦ Passez le câble dans le trou du panneau supérieur . Connectez-le au bas du support. ♦ Pase el cable por el agujero del panel superior . Conecte el cable con el sistema. ♦ 8 C 9 Line up mount with holes. Screw down. Reinstall and plug in com ...
-
Jeep HP6375 - page 5
E N Manually calibrate the compass, as follows: NOTE: Do not calibrate the compass near large metal objects, such as other vehicles, large buildings, or bridges; or near overhead or underground power lines. 1. Start the engine, but leave the vehicle in P ARK . 2. Depress the STEP button for approximately 10 seconds until the V AR menu is displayed. ...
