-
Apple 073-0545 - page 1
073-0724 Re v . A Power Mac G4 (Mirrored Drive Doors) SCSI Cable Replacement Instructions F ollow the instructions in this sheet carefully . F ailure to f ollo w these instructions could damage your equipment and v oid its w arranty . Note: Written and video instructions covering customer-installab le par ts are av ailab le at http://www .info ...
-
Apple 073-0545 - page 2
Power Mac G4 (Mirrored Drive Doors) SCSI Cable - 2 6. T ouch the metal PCI access cov ers on the back of the computer . (Figure 1) Figure 1 Important: To avoid electrostatic discharge, always ground yourself by touching the port access covers before you touch any parts or install any components inside the computer. To avoid static electricity build ...
-
Apple 073-0545 - page 3
Power Mac G4 (Mirrored Drive Doors) SCSI Cable - 3 Removing the Installed SCSI Cable 1. Disconnect the SCSI cable from the SCSI card. (Figure 2) Figure 2 2. Disconnect the SCSI cable from the hard driv es at the front and back hard driv e carriers. (Figure 3) Figure 3 ...
-
Apple 073-0545 - page 4
Power Mac G4 (Mirrored Drive Doors) SCSI Cable - 4 Note: To reach the SCSI cable connector on the back hard drive, you may need to remove the carrier. If so, use a Phillips screwdriver to remove the mounting screw that holds the carrier to the chassis. Then pull the carrier lever forward and slide up the carrier to disconnect it from the chassis. ( ...
-
Apple 073-0545 - page 5
Power Mac G4 (Mirrored Drive Doors) SCSI Cable - 5 Closing the Computer 1. Raise the side access panel, lift the latch, and press the panel against the case until it snaps securely into place. 2. Reconnect all cables and restart your computer . W arning: Never turn on your computer unless all of its internal and e xternal parts are in place and it ...
