Bedienungsanleitung C. E. Smith 52100

14 Seiten 0.39 mb
Download

Zur Seite of 14

Summary
  • C. E. Smith 52100 - page 1

    Stainless Steel T ops an d Boating Accessories t C.E. Smith Company Greensboro, NC USA Installation Instructions for Model 52100 Stainless Steel Ttop The 52100 Ttop provides a bolt together custom fit on virtually any center console boat. Bolt together cons truction relieves the stresses from engine vibration and wave shock that can crack 100% weld ...

  • C. E. Smith 52100 - page 2

    52100 MAIN KIT includes: • Canopy Frame. • Left Upright Frame, ( plugged hole fo r wires in front leg .) • Right Upright Frame, ( plugged hole for wires in re ar leg .) • Pair of front V-Brace Ba rs with integrated clamp ends. • V-Brace Console Castings: Front Ca sting & Top Casting (you will use one) • Installation Hardware Kit PAR ...

  • C. E. Smith 52100 - page 3

    Required Customer Supplied Materials: 1. 3M 5200 or equivalent marine sealant to seal the holes you will drill in your deck and console. 2. A small amount of heavy grease. Fitting the Ttop to your Boat: Fitting the 52100 Ttop to your boat is an easy step by step procedure. Take time to read thru all the steps below. Become familiar with all the dec ...

  • C. E. Smith 52100 - page 4

    f. Choose the shortest standoffs you can, so the room you have to walk around your console is maximized. g. Position your standoffs as high on the console as possible. Higher mounting provides increasingly be tter support to the Ttop canopy. h. Be sure to leave at least 1-1/ 4 inches of ”hand hold grab-clearance” especially around the fr ont up ...

  • C. E. Smith 52100 - page 5

    the standoff caps and lift the top off without disturbing the bedding of the standoffs to the console. 9. As you do #7, be sure to turn all 4 swiv el feet so the cap is to the outside. That way if you ever remove your Ttop for storage you can remove the caps and lift the top free of the feet without disturbi ng the bedding of the feet to the deck. ...

  • C. E. Smith 52100 - page 6

    1. On some boats there is not enough room to mount the console front casting between the seat cushion and the windshield. A good solution is to use a Dremel ® tool sanding drum to fashion a notch in the bottom edge of the windshield to open up some space for the casting to mount. a. To do this, put masking tape on the windshield and trace the cast ...

  • C. E. Smith 52100 - page 7

    Installing the Canopy Cover: The first step in assembling your Ttop is to lace on the Sunbrella cover (purchased separately in the color of your choice). Since you are installing a new Ttop, you will find lacing the cover is much easier if you do it on a table before mounting the canopy frame onto t he uprights. Or you may choose to wait until afte ...

  • C. E. Smith 52100 - page 8

    12. Put your drill in reverse. (with so me downward pressure a drill in reverse will cut into gel coat, but in reverse t here is no risk of the bit accidentally catching and biting into your boat deeper than you intended.) Using the long 1/4” drill bit, make center mark indentions into your deck at each Sharpie mark. 13. When all 16 hole centers ...

  • C. E. Smith 52100 - page 9

    back and tighten them more before the sealant sets up after all the screws are in place.) e. Now that you have the feet at tached to the deck, re-connect the upright to the feet and turn attention up to the standoffs. i. Be aware if you pre-drill al l the holes for both standoffs at one time, you may discover the alignment has changed slightly for ...

  • C. E. Smith 52100 - page 10

    Congratulations on your new Ttop! Please, share with us your thoughts about the product and installation. marine@cesmithco.com If you e-mail in photos of your boat and new Ttop we will add you on our website. Thanks for choosing ! 10 ...

  • C. E. Smith 52100 - page 11

    top mount V-brace and a narrow console side view showing possible standoff locations front mount V-brace and wide console figure 1. Top Mount Front Mount V-brace mount: Front if you land your V-brace in front of the windshield on the front of the console. Top if you choose to land your V-brace behind your windshield on top of your console. figure 2 ...

  • C. E. Smith 52100 - page 12

    Canopy Cover Tie Locations: Working on your boat or on a work table center your canopy cover on the frame using the 8 ties provided as shown. figure # 4 Canopy Lacing and Knotting: Lace only one grommet at the time pulling all cord thru before lacing the next grommet. figure # 5 12 ...

  • C. E. Smith 52100 - page 13

    Completed Canopy Lacing and Knotting: When finished your lacing and knotting should look like this. figure # 6 13 ...

  • C. E. Smith 52100 - page 14

    C.E. Smith Company Limited Warranty C.E. Smith Company, Inc., (SMITH) warr ants all stainless steel components of this product to be free from defects in material and workmanship for a period of two (2) years, One (1) year for the Sunbrella ® canopy, from the date of original purchase when properly insta lled, used and maintained. This warranty do ...

Produzent C. E. Smith Kategorie Boating Equipment

Dokumente, die wir vom Produzenten des Geräts C. E. Smith 52100 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen C. E. Smith
- Bedienungsanleitungen 52100
- Produktkarten C. E. Smith
- Informationsbroschüren
- oder Energieetiketten C. E. Smith 52100
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung C. E. Smith 52100.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen C. E. Smith 52100, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen C. E. Smith 52100. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts C. E. Smith 52100 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts C. E. Smith 52100, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von C. E. Smith 52100 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von C. E. Smith 52100 verständlich ist.

Eine gänzliche Bedienungsanleitung von C. E. Smith sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von C. E. Smith 52100 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von C. E. Smith 52100 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich C. E. Smith 52100, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts C. E. Smith 52100 - die uns die ersten Schritte während der Nutzung von C. E. Smith 52100 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit C. E. Smith 52100 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von C. E. Smith 52100 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich C. E. Smith 52100?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit C. E. Smith 52100 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit C. E. Smith 52100 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)