Bedienungsanleitung Stearns Safety & Survival 24MSPT-1

16 Seiten 3.39 mb
Download

Zur Seite of 16

Summary
  • Stearns Safety & Survival 24MSPT-1 - page 1

    DO NOT REMOVE PRIOR T O SALE! OWNER’S MANUAL for Model 24MSPT -1 APPROV AL CONDITIONS AND CARRIAGE REGULA TIONS This inflatable PFD is approved by the U.S. Coast Guard for use as a T ype III Personal Flotation Device (PFD). It is not approved for water skiing or other high impact, high speed activities. This inflatable PFD was designed to be more ...

  • Stearns Safety & Survival 24MSPT-1 - page 2

    2 ...

  • Stearns Safety & Survival 24MSPT-1 - page 3

    3 SPECIFICA TIONS Chest Size : 30 - 52 inches (76 - 132 cm) Weight Range : More than 80 pounds (36 kg) Age Range : 16 years of age and older Buoyancy (minimum ): 22.5 Pounds (100 Newtons) when fully inflated Inflation System : Manual Inflation Mechanism (located on your right side) Oral T ube - (located on your left side) Jerk to Inflate T ab - (lo ...

  • Stearns Safety & Survival 24MSPT-1 - page 4

    4 II. INSTRUCTIONS FOR USE A. PRE-DONNING INSTRUCTIONS CHECK THE FOLLOWING BEFORE USING THIS PFD: 1. INSPECT PFD FOR DAMAGE 2. BE SURE A CYLINDER IS INSERTED INT O THE MECHANISM AND CYLINDER SEAL INDICA TOR IS GREEN READ BELOW FOR MORE DET AILED INFORMA TION! 1. Inspecting Y our PFD For Damage Make sure that the PFD is free from rips, tears or punc ...

  • Stearns Safety & Survival 24MSPT-1 - page 5

    5 c. CO 2 Cylinders are made with a protective coating that may wear off after a period of use or exposure to the environment. When this coat ing is worn off, the CO 2 Cylinder may start to show some signs of rusting. If this occurs, replace the CO 2 Cylinder . d. If a gram scale (such as a postal scale) is available, it is recommended to weigh the ...

  • Stearns Safety & Survival 24MSPT-1 - page 6

    6 3. COLD INFLA TION - Oral Inflation may be required in addition to man ual inflation if chamber is not firm due to cold temperatures at or below 40° F (4°C). Inflation T ime using CO 2 gas will be longer at these temperatures. See FREEZING TEMPERA TURES on page 7. 4. OTHER INFLA TION PRECAUTIONS a. CAUTION - Do not fully inflate orally then man ...

  • Stearns Safety & Survival 24MSPT-1 - page 7

    7 G. OTHER USE GUIDELINES 1. Always wear your PFD when underway unless you are inside a cabin. 2. If you need to jump from any height always fold arms over your chest to keep the PFD in place when entering the water . 3. Avoid all unnecessary activities that will be abrasive to the device. 4. Use extreme caution around sharp objects. 5. A void unne ...

  • Stearns Safety & Survival 24MSPT-1 - page 8

    8 Cleaning - Damp wipe only with mild detergent recommended for sy n thetic fabrics. Remove grease and oil immediately . Always rinse well with fresh water . Read instructions provided on the device. • DO NOT MACHINE W ASH • DO NOT MACHINE DR Y • DO NOT DR Y CLEAN • DO NOT USE SOL VENT BASED CLEANERS • DO NOT BLEACH C. INSPECTION Certifie ...

  • Stearns Safety & Survival 24MSPT-1 - page 9

    9 IV . IS YOUR PFD IN GOOD AND SER VICEABLE CONDITION? Check your PFD between outings to be sure that it is properly armed; that it is free of rips, tears or holes; that all seams are securely sewn; and that the fabric, straps and hardware are still strong. Inspect the inflatable portion of the PFD in accordance with Care and Maintenance Instructio ...

  • Stearns Safety & Survival 24MSPT-1 - page 10

    10 HOW DO YOU TEST YOUR PFD USING THE MANUAL INFLA TOR? 1. T o test your inflatable PFD, you will need: • Y our fully armed PFD , and • Rearming kit approved for your PFD. 2. Put on the PFD. 3. Actuate the inflation system by jerking firmly downward on the Jerk to Inflate tab. The PFD should fully inflate within 5 seconds. 4. Get into shallow w ...

  • Stearns Safety & Survival 24MSPT-1 - page 11

    11 HOW DO YOU TEST YOUR PFD USING THE ORAL INFLA TOR? 1. T o test your inflatable PFD, you will not need any spare parts or rearming kits . 2. Remove the CO 2 cylinder , to prevent inadvertent activation of the manual inflation system which could potentially damage the PFD. 3. Put on the PFD. 4. Get into shallow water , just deep enough that you ca ...

  • Stearns Safety & Survival 24MSPT-1 - page 12

    12 VIII. HYPOTHERMIA Prolonged exposure to cold water causes a condition known as hypothermia - a substantial loss of body heat, which leads to exhaustion and unconsciousness. Most drowning victims first suffer from hypothermia. The following chart shows the effects of hypothermia: PFDs can increase survival time because they allow you to float wit ...

  • Stearns Safety & Survival 24MSPT-1 - page 13

    13 Some Points to Remember About Hypothermia Protection: 1. Always wear your PFD. Even if you become incapacitated due to hypothermia, the PFD will keep you afloat and greatly improve your chances of rescue. 2. Do not attempt to swim unless it is to reach a nearby craft, fellow sur- vivor , or a floating object on which you can lean or climb. Swimm ...

  • Stearns Safety & Survival 24MSPT-1 - page 14

    14 5. Do not alter your PFD. If it doesn’t fit properly , get one that does. An altered device is no longer Coast Guard approved. 6. Y our PFD is not intended for use as a fender or kneeling pad. 7. If your PFD is wet, allow it to dry thoroughly before storing it. Store it in a well-ventilated area. 8. Do not dry your PFD in front of a radiator o ...

  • Stearns Safety & Survival 24MSPT-1 - page 15

    15 1 2 3 4 1. Lay device out flat with yellow inflatable chamber , arrows side, up. 2. Fold left side of chamber under and fold again. Wrap Oral Tube Access T ab around Oral T ube with a portion of the tab left outside of the device. Refer to Figure 3 for more detail. Secure V elcro ® Strips. Fold right side of chamber under and fold again. Secure ...

  • Stearns Safety & Survival 24MSPT-1 - page 16

    16 Halkey-Roberts V86160 Manual Inflator ReArming/Status Indicator Instructions DISASSEMBL Y (see figure) Step 1 : Unpack or open the life vest so that the manual inflator is visible. Step 2 : Remove gas CO 2 cylinder by rotating cylinder counterclockwise then pull out. Discard cylinder . REARMING Note: Rearming must follow the sequence below . Ste ...

Produzent Stearns Safety & Survival Kategorie Boating Equipment

Dokumente, die wir vom Produzenten des Geräts Stearns Safety & Survival 24MSPT-1 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Stearns Safety & Survival
- Bedienungsanleitungen 24MSPT-1
- Produktkarten Stearns Safety & Survival
- Informationsbroschüren
- oder Energieetiketten Stearns Safety & Survival 24MSPT-1
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Stearns Safety & Survival 24MSPT-1.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Stearns Safety & Survival 24MSPT-1, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Stearns Safety & Survival 24MSPT-1. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Stearns Safety & Survival 24MSPT-1 ansehen.

Die komplette Bedienungsanleitung des Geräts Stearns Safety & Survival 24MSPT-1, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Stearns Safety & Survival 24MSPT-1 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Stearns Safety & Survival 24MSPT-1 verständlich ist.

Eine gänzliche Bedienungsanleitung von Stearns Safety & Survival sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Stearns Safety & Survival 24MSPT-1 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Stearns Safety & Survival 24MSPT-1 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Stearns Safety & Survival 24MSPT-1, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Stearns Safety & Survival 24MSPT-1 - die uns die ersten Schritte während der Nutzung von Stearns Safety & Survival 24MSPT-1 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Stearns Safety & Survival 24MSPT-1 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Stearns Safety & Survival 24MSPT-1 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Stearns Safety & Survival 24MSPT-1?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Stearns Safety & Survival 24MSPT-1 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Stearns Safety & Survival 24MSPT-1 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)