Bedienungsanleitung Winegard MV-4000

12 Seiten 0.75 mb
Download

Zur Seite of 12

Summary
  • Winegard MV-4000 - page 1

    1 Movin’ View TM Digital Satellite Mobile Antenna for Single Receiver for Use While Stationary or In-Motion Model MV-4000 Made in the U.S.A. U.S. Patent Nos. 6,023,247; 6,188,300 Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www.winegard.com Printed in U.S.A. © Winegard Company 2005 24 ...

  • Winegard MV-4000 - page 2

    2 DIRECTV ® is an official trademark of DIRECTV , a unit of GM Hughes Electronics Corporation. DISH Network TM is an official trademark of EchoStar Communications Corporaton. DIGITAL BROADCAST SYSTEM SATELLITE(S) Introduction Congratulations! Y ou have purchased one of Winegard’s latest development s in the mobile satel- lite reception product l ...

  • Winegard MV-4000 - page 3

    3           2. Determine which programming you will be using. This will determine how you set your switches. For DISH Network set switches to 1 19° . For ExpressVu ®, set switches to 091° . NOTICE! This model is PRESET for DIRECTV ® receivers Mounting Option A. If you have a DISH Network ® or ExpressVu ® ...

  • Winegard MV-4000 - page 4

    4 Operation 1. T urn on receiver and television set. The MV -4000 must be connected to a receiver that is plugged into 120 V AC. 2. V erify that you are getting the receiver ’s menu screens on the television. These screens are avail- able with or without the dish finding the signal. 3. T urn the power switch on for the MV -4000. The dish should s ...

  • Winegard MV-4000 - page 5

    5 To toggle between satellites when subscribing to multi-satellite programming— While in Sleep Mode , the MV -4000 will toggle be- tween the primary and seconday satellites for either DISH Network or DIRECTV . Both have program- ming on more than one satelite. When a channel is selected on the remote control and is not on the satellite currently ...

  • Winegard MV-4000 - page 6

    6 1 Barrel connector 1 large yellow spade connector 2 small red spade connectors All required screws, washers, bolt s, and nylocks 1 base with electronics, dish, single LNBF Silicone sealant Surface Wipes 30’ power cable and 30’ coaxial cable 1 . Open box and remove packing material. 2. Lift dome out of box vertically . Then lift unit out of bo ...

  • Winegard MV-4000 - page 7

    7 Base Diagram FIGURE 2 CONTROL BOX (DETAIL BELOW) COAX CABLE AT CONTROL BOX CONTROL BOX TO LNBF AZ MOTOR GPS ANTENNA FOOT MUST BE PARALLEL TO THE CENTER LINE OF THE VEHICLE LNBF VOLTAGE +12VDC POWER CABLE REFLECTOR SWITCH LOCATION (SIDE OF BOX, SEE PAGE 3) EL MOTOR CONTROL BOX DETAIL COAX TO LNBF COAX TO RECEIVER P4 ELEV A TION P3 AZIMUTH (#1 repr ...

  • Winegard MV-4000 - page 8

    8 Installation IMPORT ANT! Do not install this system in the rain, or under any wet conditions . Mois- ture may af fect electronics and void your warranty! 1. For best performance and to reduce signal ac- quisition time, park vehicle on a level surface; level the R V . 2. Select a level spot on your roof for installation. Using the chart, determine ...

  • Winegard MV-4000 - page 9

    9 Installation INSTALLING THE POWER SWITCH 1. Choose a location to install the MV -4000 power ON/OFF switch. Remember when selecting a location that you will need to run the +12VDC power cable from the MV -4000 to the switch. Be sure the switch is in the OFF position before continuing. See Figure 9 page 10. W all or panel mount : Drill 1-1/4” hol ...

  • Winegard MV-4000 - page 10

    10 Connect the coax cable from the roof to the “Satellite In” connection on the receiver . (A dual receiver upgrade kit is available. Contact Winegard Company for more information.) CONNECTING THE RECEIVER — Installation • Wiring INITIALIZING --- 1. Be sure vehicle is in a location free of all obstruc- tions and with a clear view of the sou ...

  • Winegard MV-4000 - page 11

    11 Troubleshooting The MV -4000 does not attempt to find a satellite or it never moves. The MV -4000 turns on and moves for a few sec- onds then stops and never moves again. The dish never stops on any of the signals that it sees. 1. Check your Power switch to verify that it is in the ON position. 2. Check +12 V wires at unit to verify power . Chec ...

  • Winegard MV-4000 - page 12

    12 Winegard Company • 3000 Kirkwood S treet • Burlington, IA 52601 • 319/754-0600 Fax 319/754-0787 • www .winegard.com Printed in U.S.A. © 2005 Winegard Company 2452065 Rev . 5/05 TWO YEAR LIMITED WARRANTY Winegard Company warrants this Winegard product (excluding receiver) against any defects in materials or workmanship within two (2) yea ...

Produzent Winegard Kategorie Satellite Radio

Dokumente, die wir vom Produzenten des Geräts Winegard MV-4000 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Winegard
- Bedienungsanleitungen MV-4000
- Produktkarten Winegard
- Informationsbroschüren
- oder Energieetiketten Winegard MV-4000
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Winegard MV-4000.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Winegard MV-4000, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Winegard MV-4000. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Winegard MV-4000 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Winegard MV-4000, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Winegard MV-4000 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Winegard MV-4000 verständlich ist.

Eine gänzliche Bedienungsanleitung von Winegard sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Winegard MV-4000 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Winegard MV-4000 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Winegard MV-4000, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Winegard MV-4000 - die uns die ersten Schritte während der Nutzung von Winegard MV-4000 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Winegard MV-4000 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Winegard MV-4000 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Winegard MV-4000?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Winegard MV-4000 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Winegard MV-4000 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)