Bedienungsanleitung Crimestopper Security Products CS-2008PC

19 Seiten 0.65 mb
Download

Zur Seite of 19

Summary
  • Crimestopper Security Products CS-2008PC - page 1

    CS-2008PC SecurLinc™ ADVANCED REMOTE CONTROL ALARM SYSTEM INSTALLATION & OPERATING INSTRUCTIONS *NOTE: There are several features of the CS-2008PC system that can only be accessed and/or programm ed by using optional SecurLinc™ PC software and data cable via the system’s expansion port via a Personal Computer: An expansion kit is availabl ...

  • Crimestopper Security Products CS-2008PC - page 2

    TABLE OF CONTENTS Pre-Installation Cautions & Warnings…….…………………………………………………………..………………1 Control Module & Component M ounting…………………..……………………….………………………..…….2-3 Wiring Descriptions.………………………………………? ...

  • Crimestopper Security Products CS-2008PC - page 3

    COMPONENT MOUNTING SIREN: Mount the siren under the hood to an inner fender-well, wheel-well, or other body surface with the open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black to the body metal near the siren or you can use one of the siren’s mounting screws for a ground. LED/VALET POD: ...

  • Crimestopper Security Products CS-2008PC - page 4

    WIRING PIN 12: ORANGE WIRE: NEGATIVE ARMED OUTPUT – Starter Disable (500mA Ground, Optional) This wire becomes a (-) Ground output when system is armed. This output can be used for optional accessories such as window roll up modules, scanner LED’s, voice modules, etc. PIN 13: BLUE: NEGATIVE UNLOCK OUTPUT / POSITIVE LOCK OUPUT . PIN 14: GRAY WIR ...

  • Crimestopper Security Products CS-2008PC - page 5

    SYSTEM WIRING DIAGRAM #1 ...

  • Crimestopper Security Products CS-2008PC - page 6

    SYSTEM WIRING DIAGRAM #2 ...

  • Crimestopper Security Products CS-2008PC - page 7

    SHOCK SENSOR DUAL ADJUST Smart Sense™ Shock Sensor: GREEN RED Pre-Warn Tr i g g e r The supplied dual stage / dual adjust shock sensor does not require any additional wiring. Just mount the sensor, plug in the “Sensor #1” input plug on the 2008PC harness and adjust to the desired levels of sensitivity for pre-warn and shock sensor violations. ...

  • Crimestopper Security Products CS-2008PC - page 8

    POWER DOOR LOCK WIRING GREEN: (-) LOCK / (+) UNLOCK BLUE: (-) UNLOCK / (+) LOCK COMMON DOOR LOCK TYPES: (SEE FOR DESCRIPTIONS) Negative Trigger (-): Many Imports, Late Model Ford & General Motors Positive Trigger (+): Many GM, Chrysler/Dodge/Plymouth models: Reverse Polarity: Many Ford/Lincoln/Mercury, Dodge/Chrysler/ Plymouth and some GM Fulls ...

  • Crimestopper Security Products CS-2008PC - page 9

    POWER DOOR LOCK WIRING NEGA TIVE TRIGGER DOO RLOCK WIRING POSITIVE TRIGGER DO ORLOCK W IRING GREEN GREEN BLUE BLUE DIO DES FA C T O R Y FA C T O R Y L L LOCK LOCK POW ER POW ER LOCKING LOCKING UL UL RELA YS RELA Y S UNLOCK UNLOCK IN4001 DIO DES IN 4 00 1 A FTERMA RKET MOT OR/DOOR LOC K WIRING REVERSE POLA R ITY DOOR LOC K WIRING GREEN GREEN FUS ED ...

  • Crimestopper Security Products CS-2008PC - page 10

    REMOTE TRANSMITTER PROGRAMMING 1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3 rd time. (ON/OFF, ON/OFF, ON) You should hear (3) chirps. 2. Press the Program/Override Button for 5 seconds and you should hear 5 chirps and LED comes on solid. 3. Press #1 (LOCK) on the transmitter once, you should hear 1 chirp. Press Button #1 again, ...

  • Crimestopper Security Products CS-2008PC - page 11

    OPTION PROGRAMMING TABLE PROGRAMM ING OPTIONS CHART * = Default (Column 1) Option # Option Description BUTTON 1* LOCK BUTTON 2 UNLOCK BUTTON 3 TRUNK 1. Passive Arming/ Hands-free mode Passive OFF* Hands-free OFF* Passive Arming Enable Hands-free Mode Enable 2. Active Re-Arm / Hands-free Immobilizer Active Re-arm OFF* Immobilizer OFF* Active Re-arm ...

  • Crimestopper Security Products CS-2008PC - page 12

    OPTION DESCRIPTIONS 2. ACTIVE RE-ARMING / HANDS-FREE IMMOBILIZER This option controls the Active Re-arming feature and the Hands-free immobilizer. There are 3 selections: Button 1 (Lock) = Both Active Re-arming and Hands-free immobilizer are OFF. Button 2 (Unlock) = Enable Active Re-arming. Button 3 (Trunk) = Enable Hands-free immobilizer. • Acti ...

  • Crimestopper Security Products CS-2008PC - page 13

    OPTION PROGRAMMING 12. HORN OUTPUT / CARJACK WITH HANDS-FREE REMOTE (2 FEATURES) This option controls whether the system’s Factory Horn output AND full-time Carjack operation. There are 3 selections: Button 1 (Lock) = Horn Output Pulses on trigger and Full-time Carjack are disabled. Button 2 (Unlock) = Horn Output is on Solid when triggered. Butt ...

  • Crimestopper Security Products CS-2008PC - page 14

    OPTION RESET TO RESTORE ALL PROGRAMMABLE OPTIONS TO DEFAULT VALUES (*): 1. Turn the Ignition ON and press the Program/Override button 5 times. The siren will chirp 3 times indicating you are in programming mode. 2. Press the #3 Button (Trunk Symbol) on the Transmitter. The system will chirp (6) six times indication all options have been reset to De ...

  • Crimestopper Security Products CS-2008PC - page 15

    “HANDS FREE” REMOTE CONTROL (OPTIONAL) This 2008PC system is compatible with an optional “Hands-free” remote transmitters (not included in kit). The “Hands-free” remote transmitter adds two important features. • Convenient “hands-free” operation and additional security. • Additional Security: When using the hands free remote, th ...

  • Crimestopper Security Products CS-2008PC - page 16

    HANDS-FREE PROGRAMMING & SETUP NOTE: PASSIVE ARMING AND PASSIVE LOCKING M UST BE ENABLED ALONG WITH THE HANDS- FREE MODE. ENABLE HANDS FREE MODE: 1. Follow steps to enter Option Programming mode. (See page 7) 2. Press program button 1 time to get to option #1. 3. Press the Button #3 (Trunk Symbol) on the remote transmitter to enable this featur ...

  • Crimestopper Security Products CS-2008PC - page 17

    5-BUTTON REMOTE OPERATION: 5-Button One-Way Remote Functions: PA N I C BUTTON 1 BUTTON 3 BUTTON 2 BUTTON 4 BUTTON 5 (ON SIDE) BANK #1 (Directly Press Buttons) Button 1: Arm / Lock Button 2: Disarm / Unlock Button 3: Aux #1 (Trunk Release) Button 4: Panic Button 5: (Change to BANK #2) BANK #2 (Press Button 5 FIRST, then within 3 seconds Buttons 1-4) ...

  • Crimestopper Security Products CS-2008PC - page 18

    ALARM OPERATION PANIC FEATURE: In the event of an emergency situation or to attract att ention to your vehicle, press and hold Button #4 (Panic). The Siren will sound and lights will flash for 30 seconds. Press Button #2 (Unlock) reset. ONE-TIME SHOCK SENSOR BYPASS: To arm the system and bypass the shock for just that one time, press button #1 on e ...

  • Crimestopper Security Products CS-2008PC - page 19

    ALARM OPERATION DOME LIGHT ILLUMINATION: (Optional) This feature turns on the vehicle’s dome light upon disarm for 30 seconds or until the key is inserted and turned on. This will provide illuminated entry to your vehicle at night or in dimly lit areas for safety and security. FAULTY ZONE BYPASS: When the system arms (actively or passively) with ...

Produzent Crimestopper Security Products Kategorie Automobile Alarm

Dokumente, die wir vom Produzenten des Geräts Crimestopper Security Products CS-2008PC erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Crimestopper Security Products
- Bedienungsanleitungen CS-2008PC
- Produktkarten Crimestopper Security Products
- Informationsbroschüren
- oder Energieetiketten Crimestopper Security Products CS-2008PC
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Crimestopper Security Products CS-2008PC.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Crimestopper Security Products CS-2008PC, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Crimestopper Security Products CS-2008PC. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Crimestopper Security Products CS-2008PC ansehen.

Die komplette Bedienungsanleitung des Geräts Crimestopper Security Products CS-2008PC, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Crimestopper Security Products CS-2008PC hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Crimestopper Security Products CS-2008PC verständlich ist.

Eine gänzliche Bedienungsanleitung von Crimestopper Security Products sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Crimestopper Security Products CS-2008PC bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Crimestopper Security Products CS-2008PC befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Crimestopper Security Products CS-2008PC, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Crimestopper Security Products CS-2008PC - die uns die ersten Schritte während der Nutzung von Crimestopper Security Products CS-2008PC erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Crimestopper Security Products CS-2008PC hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Crimestopper Security Products CS-2008PC im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Crimestopper Security Products CS-2008PC?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Crimestopper Security Products CS-2008PC nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Crimestopper Security Products CS-2008PC hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (1)

Gennadiy

электросхемы чертежи