Bedienungsanleitung Ultra Start 430 Series

12 Seiten 1.04 mb
Download

Zur Seite of 12

Summary
  • Ultra Start 430 Series - page 1

    T ec hnical Suppor t 866-698-5872 e xt 0 Suppor t@ultr astar ter s.com FCC/ID Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired oper ...

  • Ultra Start 430 Series - page 2

    Ta b l e O f C o n t e n t s P a g e 2 Wiring Diagram Page 3 Inst allation T ip s Page 4 Pre-Installation Suggestions Inst allation Suggestions Mounting The Module Installing The LED Installing The Program Button Under Hood Connections Mounting The Siren Wire Connectors Page 5 14 Pin Main Harness Connector 4 Pin Red Connector- Keyless Entry 2 Pin C ...

  • Ultra Start 430 Series - page 3

    Blue Connect to hood and / or trunk pin Hood Input Green Connect to door pin. (-) when opened Door Input Purple Connect to door pin. (+) when opened Door Input Black Connect to chassis ground Ground Input Brown Connect to Siren wire. 2amp Maximum Siren Output Red Connect to constant power . 20amp input 12 V olt Input Ye l l o w Connect to vehicles ...

  • Ultra Start 430 Series - page 4

    R ecommended Installation Procedur es White (+) Park light s Park light output. Orange (-) When Armed Negative output when system is armed. Grey (-) T runk Release Negative output for trunk release. 500ma max. Y ellow Ignition Input Input from vehicles ignition wire. RedMain Power Input Constant 12 V olt input. Brown (+) Siren Output Positive outpu ...

  • Ultra Start 430 Series - page 5

    10 Pin P ow er Connector Step 2- Plug-In T he Module Step 3- T est And Adjust T he Shock Sensor Y our Basic Install Is Complete! Step 4- T est T he System Step 1 - Connect All Of the F ollo wing W ir es When all the connections are done, the control module can be plugged in. Before connecting the control module, make sure the ignition is in the OFF ...

  • Ultra Start 430 Series - page 6

    Program mode allows you to adjust the settings and options of your system. Y our system has been intelligently designed by installers with years of experience. The system’s default settings do not require any program changes in most cases. However , this system does incorporate a advanced programming system with settings that can be easily adjust ...

  • Ultra Start 430 Series - page 7

    Entering program mode is done by the following steps: 1) Make sure ignition is in the off position. 2) T urn the ignition key ON - OFF , leaving key in the OFF position. 3) Press and release the V alet button two times. 4) The siren will chirp one time to confirm entering program mode. ( If this does not happen, turn ignition off, wait five seconds ...

  • Ultra Start 430 Series - page 8

    T o change settings: 1 - Enter Program Mode - (Ignition ON-OFF , followed by V alet 2 times) 2 - Press & release transmitter buttons in the following sequence #1 - #1 then #3 3 - The siren will respond with the following: 1 Chirp V oltage Sensing- No Door Pin Connection Needed 2 Chirp s Door Pin- Door Pin Connection Required Repeat sequence to ...

  • Ultra Start 430 Series - page 9

    - Press and release to arm the alarm and lock the doors. - Press and hold to activate Panic mode. - Press and release to deactivate triggered alarm. - Press and release to disarm and unlock the doors . - Press and hold to activate the T runk Release. - Press and release to deactivate triggered alarm. - Press and hold to activate the Car Finder Mode ...

  • Ultra Start 430 Series - page 10

    1.Press and hold the UNLOCK button for three seconds. 2.The doors will unlock, continue holding the unlock button three seconds. the T runk release will then activate. The trunk release will be confirmed by one park light flash. 3.For safety reasons, the trunk release output will not activate when ignition key is in the “On” po si t i on . 1.Pr ...

  • Ultra Start 430 Series - page 11

    Star ter Disable The system has an optional starter disable output that can be connected by your dealer . When the starter disable relay is installed and connected to the system, the vehicle’ s starter will be disabled when the system is armed. T o activate the st arter disable press the lock button on the remote. The system will arm and the star ...

  • Ultra Start 430 Series - page 12

    87 86 85 87a 30 87 86 85 87a 30 87 86 85 87a 30 87 86 85 87a 30 87 86 85 87a 30 Ne gativ e T ype Door Locks P ositive T ype Door Locks 5 W ir e / Re v er se Polarity T ype Door Locks Ne gativ e P ar k Lights- In some cases the park light s may flash erratically after installing the negative p ark light relay . T o correct this issue add a diode bet ...

Produzent Ultra Start Kategorie Automobile Alarm

Dokumente, die wir vom Produzenten des Geräts Ultra Start 430 Series erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Ultra Start
- Bedienungsanleitungen 430 Series
- Produktkarten Ultra Start
- Informationsbroschüren
- oder Energieetiketten Ultra Start 430 Series
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Ultra Start 430 Series.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Ultra Start 430 Series, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Ultra Start 430 Series. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Ultra Start 430 Series ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Ultra Start 430 Series, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Ultra Start 430 Series hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Ultra Start 430 Series verständlich ist.

Eine gänzliche Bedienungsanleitung von Ultra Start sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Ultra Start 430 Series bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Ultra Start 430 Series befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Ultra Start 430 Series, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Ultra Start 430 Series - die uns die ersten Schritte während der Nutzung von Ultra Start 430 Series erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Ultra Start 430 Series hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Ultra Start 430 Series im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Ultra Start 430 Series?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Ultra Start 430 Series nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Ultra Start 430 Series hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (1)

Виктория

Где найти инструкцию на русском языке на посудомоечную машину DW12-PFE2 ?