-
Profile CD7200 - page 1
CD7200 INSTALLATION INSTRUCTIONS / OWNER S MANUAL , AM/FM HIGH POWER DETACHABLE FACE CD PLAYER ...
-
Profile CD7200 - page 2
1 I NTRODUCTION Congratulations on your purchase of a Profile state-of-the-art single disc CD player. Your selection of a Profile car audio product indicates a true appreciation of fine musical reproduction. Whether adding to an existing system or including your Profile CD player in a new system, you are certain to notice immediate performance bene ...
-
Profile CD7200 - page 3
2 S AFETY PRECAUTIONS Secure the CD player When installing your CD player in the vehicle, make sure it is mounted properly in the dash, using an after market installation kit if needed. When using the supplied mounting sleeve, it is a must that you also use the supplied back brace to support the back of the CD player. Use caution when mounting the ...
-
Profile CD7200 - page 4
3 C ARE AND MAINTENANCE Cleaning the CD player When cleaning the vehicle, be sure not to get any water in or on the CD player. Clean only the exterior surface of the unit with a dry, clean soft towel using no chemical solvents. Operating in extreme temperatures Sometimes the unit will not operate in extreme, hot or cold temperatures. If this is the ...
-
Profile CD7200 - page 5
4 DISC CARE AND PLAY: Before playing, clean the disc with a clean, lint-free cloth. Wipe the disc in the direction of the arrow. Do not use solvents such as benzine or thinners. Commercially available cleaners or anti static spray will damage the unit. Insert a disc with the labeled surface up. Do not try to insert another disc when one has already ...
-
Profile CD7200 - page 6
5 E LECTRICAL AND SIGNAL CONNECTIONS FOUR SPEAKER SYSTEM Before making the following connections, take time to look over the vehicle s wiring and determine the location and wires you will be connecting to. If you do not wish to cut or tap into the vehicles existing factory wiring, there are wiring kits available at your car audio retailer that will ...
-
Profile CD7200 - page 7
6 CAUTION! Tape unused wires so they do not short against other wires or chassis ground. TWO SPEAKER SYSTEM CD7200 NOT USED NOT USED NOT USED NOT USED + + + + YELLOW ANTENNA CONNECTOR MEMORY +12V BLACK(GND) RED (B+) FRONT RIGHT SPEAKER BLUE AUTO ANTENNA WHITE WHITE/BLACK GRAY/BLACK GRAY BATTERY +12V + - SWITCHED +12V (ON WITH IGNITION) Low level si ...
-
Profile CD7200 - page 8
7 M OUNTING THE CD PLAYER There are two different ways to mount the CD Player. In most Japanese vehicles you can use the factory mounting brackets, taking advantage of the ISO/DIN opening. If your vehicle does not have ISO/DIN opening, you can mount the CD Player using the supplied DIN sleeve and rear support bracket. When considering your mounting ...
-
Profile CD7200 - page 9
8 Attach the back brace to the CD player using the supplied hardware. Then attach the other end of the brace to a firm mounting surface (i.e. Dash brace, fire wall, e.t.c.) This will brace the back of the CD player to ensure solid mounting to prevent theft and provide optimal CD play. CD7200 Once the CD player is secured, fit the trim ring over out ...
-
Profile CD7200 - page 10
9 ISO/DIN MOUNTING If you own a Japanese vehicle, you can use the standard ISO/DIN mounting screw holes on the side of the CD player to attach to the existing factory mounting bracket, without using the provided DIN sleeve. Remove the factory ISO/DIN mounting bracket from the car along with the factory radio. Remove the factory radio from the brack ...
-
Profile CD7200 - page 11
10 CD7200 LOCATION AND FUNCTION OF CONTROLS ...
-
Profile CD7200 - page 12
11 1 POWER To t u r n O N t h e unit, press any button except the EJT and OPEN button. To t u r n O F F t h e unit, press the PWR button. 2 DETACH PANEL Press the OPEN button to detach the front panel. This will allow you to remove the front panel. 3 CD PLAY To play a CD, gently insert the CD into the slot with the label side facing up. The disc wi ...
-
Profile CD7200 - page 13
12 9 10 RADIO TUNE & CD TRACK UP/DOWN, CD FAST FORWARD/REWIND Under radio mode, press the UP 9 or DN 10 button momentarily and repeatedly to change the frequency number up or down one step. Press and hold the button for more than 1 second to seek to the next clear station. In CD play mode, press the UP 9 or DN 10 button to move to the next or p ...
-
Profile CD7200 - page 14
13 DSP - The unit is equipped with 4 preset equalization modes. Press the SEL button for more than 1 second to display DSP OFF. Then use V.UP 5 and V.DN 6 buttons to choose one of 4 following preset EQ s in the following order. In DSP OFF mode, the EQ is controlled by Bass and Treble settings. DSP OFF FLAT CLASSIC ROCK POP BEEP - The beep sound whe ...
-
Profile CD7200 - page 15
14 16 RANDOM PLAY In CD play mode, press the RDM 16 button to play all tracks of the disc in random sequence. Press it again to cancel random play. 17 RADIO SCAN In radio mode, press the SCN 17 button to scan up one strong radio station signal at a time. If a valid radio station is detected, the station number will blink on the LCD for 3 seconds be ...
-
Profile CD7200 - page 16
15 T ROUBLE SHOOTING THE SYSTEM The following chart will help in solving most problems that ma y occur. Should any problem persist after you have made these checks, please consult yo ur nearest Profile retailer. Before going through this check list, refer back to the wiring a nd operating procedures. SYMPTOM CAUSE SOLUTION The vehicle's igniti ...
-
Profile CD7200 - page 17
SYMPTOM CAUSE SOLUTION The installation angle is greater than 30 degrees Adjust the angle of the unit to l ess than 30 degrees The disc player is installed incorrectly Check to see if the unit is fastened securely with the back brace supporting the rear of the unit. The compact disc is extremely dirty or defective disc. Clean the compact disc with ...
-
Profile CD7200 - page 18
S PECIFICATIONS GENERAL Power Supply Requirements...........................................DC 12 Volts, Negative Ground Chassis Dimensions ....................................................................7(W) x 6 1/2 (D) x 2 (H) Tone Controls........................................................................................................ ...
-
Profile CD7200 - page 19
LIMITED WARRANTY Profile Consumer Electronics, Inc. warrants this product to be free from defects in material and workmanship for a period of One (1) Year from the date of sale to the original consumer purchaser. If this product is proven to be defective within this one year period, Profile will repair it when said product is returned, with a copy ...
-
Profile CD7200 - page 20
PROFILE CONSUMER ELECTRONICS, INC. 15060 SHOEMAKER AVE SANTA FE SPRINGS, CA 90670 TEL: (562)404-9393 FAX: (562)404-9433 WWW.PROFILEUSA.COM WARRANTY REPAIR POLICY In the unlikely event of product failure, the following procedures should be followed 1) The unit must be under the 1-year warranty period. 2) The unit must have no physical damage. 3) A c ...
Haben Sie eine Frage bezüglich Profile CD7200?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Profile CD7200 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Profile CD7200 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.