Bedienungsanleitung Centro 2000

20 Seiten 1.92 mb
Download

Zur Seite of 20

Summary
  • Centro 2000 - page 1

    W ARNING Failure to follow all of the manufactur er’ s instructions could result in hazar dous fires, explosions, pr operty damage, or serious personal injury or even death. W ARNING Follow all leak check procedur es carefully prior to operation of barbecue, even if barbecue was stored assembled. Do not try to light this barbecue without reading ...

  • Centro 2000 - page 2

    i i T ABLE OF CONTENT S W arrant y . . . . . . . . . . . . . . . . . i i Installation Informatio n . . . . . . 1 Additional W a r ning s . . . . . . . . 1 Use of LP Gas Cylinde r , . . . . . 1- 2 T ransportation and Storage of the LP Cylinde r , Filling the LP Cylinde r Prior to Using the Gril l . . . . . . . 3 Safety Hose and Regulato r . . . . 4 ...

  • Centro 2000 - page 3

    1 ADDITIONAL W ARNINGS INST ALLA TION INFORMA TION The installation of this appliance must be in accordance with all local codes, or in the absence of local codes: • Canadian installation must conform to the current national standar ds, which at this time are CAN / CGA-B149.1/2-Natural Gas / Propane installation code. Drawing A Minimum clearance ...

  • Centro 2000 - page 4

    2 FILLING THE LP CYLINDER The cylinder must be filled prior to use and must have the air purged. For safety , follow these instructions when having your cylinder filled: • Have only your local qualified LP gas dealer fill or repair a cylinder . • Do not overfill the cylinder beyond the safe 80% fill level. • Make sure the dealer tests and che ...

  • Centro 2000 - page 5

    3 PRIOR TO USING Drawing E Do not use your barbecue until you have carefully r ead and fully understand all the information in this manual. Please ensure the following: • Y our barbecue is properly assembled. • There ar e no leaks in the system (see “Leak T est”). • The burner is properly assembled, with the V enturi tubes seated over the ...

  • Centro 2000 - page 6

    4 SAFETY HOSE AND REGULA TOR Propane Gas Models: Y our barbecue is designed to operate on L.P . (Propane) gas at a pressur e of 2.74 Kpa (11˝ water column). A regulator preset to this pr essure is supplied with the barbecue and must be used. This regulator is equipped with the T ype-1 quick-closing connecting system, which incor- porates these saf ...

  • Centro 2000 - page 7

    5 Drawing B Drawing C Drawing D SAFETY LEAK TESTING Perform a “Leak T est” • Before lighting your barbecue for the first time. • Every time the cylinder is refilled, or any component is r eplaced. • At least once every year , preferably at the start of the season. The “Leak T est” must be done outdoors, away from heat, open flames and ...

  • Centro 2000 - page 8

    6 LIGHTING THE GRILL Make Sure you have followed all the safety checks, pr ocedures and instructions indicated in the previous section, befor e attempting to light the grill. Lighting The Main Burners 1. Always open the hood completely and always inspect the grill and burners to confirm that all components are pr operly positioned before lighting t ...

  • Centro 2000 - page 9

    7 6. Confirm that the burner is properly lit. If the flame pattern is other than normal, consult the T roubleshooting Guide for corrective action. 7. Always preheat the Barbecue befor e starting to cook. Light all bur ners and adjust them to the HIGH position for 5-10 minutes. Before placing any food on the Barbecue, clean the cooking grids with a ...

  • Centro 2000 - page 10

    8 8 P ARTS LISTING FOR 85-1103 (PROP ANE) G41301 Item No. Quantity Specification Part No. A 1 T op Lid Assembly AA 1 T op Lid Weldment G413-0100-01 AB 1 Handle F/ T op Lid G413-0001-01 AC 1 Thermometer G413-0029-01 AD 2 Screw for T op Lid G607-0002-01 B 1 Burner Box Assembly BA 1 Burner Box Weldment G413-0200-01 BB 1 Left Side Upper Panel G413-0300 ...

  • Centro 2000 - page 11

    9 CL BG CI CJ DA EA BB CB CK AD AC BH BI AA BF AD AB BC DC EB CA DB BA CD CE CG CF CH CC EC ED EE EF EG EH BD BA BE CD 85-1103 (PROP ANE) G41301 ...

  • Centro 2000 - page 12

    10 P ARTS LISTING FOR 85-1003-6 (NA TURAL GAS) G41302 Item No. Quantity Specification Part No. A 1 T op Lid Assembly AA 1 T op Lid Weldment G413-0100-01 AB 1 Handle F/ T op Lid G413-0001-01 AC 1 Thermometer G413-0029-01 AD 2 Screw for T op Lid G607-0002-01 B 1 Burner Box Assembly BA 1 Burner Box Weldment G413-0200-01 BB 1 Left Side Upper Panel G413 ...

  • Centro 2000 - page 13

    11 CL BG CI CJ DA EA BB CK AD AC BI AA BF AD AB BC DC EB CA DB BA CD CE CG CF CH CC EC ED EE EF EG EH BD BA BE CD CL BG CI CJ DA EA CB BB CK AD AC BH BI AA BF AD AB BC DC EB CA DB BA CD CE CG CF CH CC EC ED EE EF EG EH BD BA BE CD 85-1003-6 (NA TURAL GAS) G41302 ...

  • Centro 2000 - page 14

    12 12 1/4” x 38 mm Screw (x4) Hardwar e Pack List No. Description Part Number Quantity 1 1/4” x 38 mm Screw 20120-13038-250 4 2 1/4” x 13 mm Screw 20120-13013-250 12 3 Ø7 Lock Washer 41400-07000-250 16 4 Ø7 Flat Washer 40300-07000-250 16 5 1/4”-20UNC Nut 30220-13000-250 6 6 No. 10 x 10 Screw 20124-10010-250 12 7 Ø5 Lock Washer 41400-0500 ...

  • Centro 2000 - page 15

    13 EG EH EF EA 2 3 5 4 EB EF 1 Attach two front casters (EH) and two back casters with lock (EG) to the bottom shelf (EF) by using the provided wr ench hardware #11. A B DB EB DA EA 6 7 8 2 Assemble the cart left side panel (EA) and cart right side panel (EB) to the bottom shelf (EF) using hardwar e #2, #3, #4 and #5 (x6). 3 Assemble the whole top ...

  • Centro 2000 - page 16

    14 5 Open lid (A) and position the three flame tamers (BF) above the burners (BD) as shown. Place the two cooking grates (BG) above the flame tamers. BB EA CE CH BG BF BD 4 Assemble the upper brace (CH) below the control panel (CE) as shown using hardwar e #6,#7 and #8 (x4). Remove the screws and nuts fr om the top lid handle (AB), then assemble th ...

  • Centro 2000 - page 17

    15 BC DB CC 7 Insert grease tray left and right rail (CJ) & (CK) into the holes at the inside of the cart assembly as shown. Insert the tank heat shield (CI) into the holes in the upper rail. Assemble the upper back panel (CL) to the back of the burner box by using hardwar e #1, #3 and #4 (x4). Then attach the upper back panel (CL) to the edge ...

  • Centro 2000 - page 18

    16 CD 10 10 Unscrew the igniter cap and place AA battery which is pr ovided into igniter (CD) with positive end (+) facing outward. Scr ew igniter cap onto igniter as shown. 11 For propane model only Secure 20lb pr opane tank onto the bottom shelf of the cart as shown, attach the regulator valve to 20lb pr opane tank. W ARNING Do not store the extr ...

  • Centro 2000 - page 19

    17 This model has a 12’ hose with a male coupling plug that will allow you to attach your barbecue to your residential gas line. WE STRONGL Y RECOMMEND CONT ACTING A CERTIFIED GAS-TECHNICIAN TO INST ALL YOUR NA TURAL GAS UNIT . Connecting to Gas Line 1. Pull back the outer sleeve located on the residential gas line (see illustration). 2. Insert t ...

  • Centro 2000 - page 20

    DISTRIBUTOR T rileaf Distribution T rifeuil T oronto, Canada M4S 2B8 ...

Produzent Centro Kategorie Gas Grill

Dokumente, die wir vom Produzenten des Geräts Centro 2000 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Centro
- Bedienungsanleitungen 2000
- Produktkarten Centro
- Informationsbroschüren
- oder Energieetiketten Centro 2000
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Centro 2000.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Centro 2000, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Centro 2000. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Centro 2000 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Centro 2000, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Centro 2000 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Centro 2000 verständlich ist.

Eine gänzliche Bedienungsanleitung von Centro sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Centro 2000 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Centro 2000 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Centro 2000, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Centro 2000 - die uns die ersten Schritte während der Nutzung von Centro 2000 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Centro 2000 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Centro 2000 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Centro 2000?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Centro 2000 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Centro 2000 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)