Bedienungsanleitung Weber FLAME

20 Seiten 4.85 mb
Download

Zur Seite of 20

Summary
  • Weber FLAME - page 1

     W ARNING If the information in this manual is not followed exactly , a fi re or explosion may result causing property damage, personal injury or loss of life. • Do not store or use gasoline or other fl ammable vapors and liquids in the vicinity of this or any other appliance. - WHA T T O DO IF YOU SMELL GAS: • Do not try to light any appl ...

  • Weber FLAME - page 2

    2 DANGERS AND W ARNINGS  DANGER Failure to follow the Dangers, W arnings and Cautions contained in this Owner ’ s Manual may result in serious bodily injury or death, or in a fi re or an explosion causing damage to property .  W ARNINGS  Do not use this appliance to cook food.  NEVER burn real logs in fi replace.  Do not burn any ...

  • Weber FLAME - page 3

    3 W ARRANTY / GENERAL INSTRUCTIONS Weber-Stephen Products Co. (W eber ® ) hereby warrants to the ORIGINAL PURCHASER of this Weber ® gas fi replace that it will be free of defects in material and workmanship from the date of purchase as follows: when assembled and operated in accordance with the printed instructions accompanying it. Weber may req ...

  • Weber FLAME - page 4

    4 CLEANING  W ARNING: T urn your Weber ® gas fi replace OFF and wait for it to cool before cleaning. For availability of replacement parts contact the Customer Service Representative in your area using the contact information on our web site. Log onto www .weber .com ® . Outside surfaces - Use a warm soapy water solution to clean, then rinse ...

  • Weber FLAME - page 5

    5 P ARTS LIST BASE - 1 BACK P ANEL - 1 RAIN SHIELD - 3 HOOD VENT SUPPORT - 4 SUPPORT BRACKET - 3 CERAMIC L OGS - 8 LA V A ROCKS HOOD VENT - 1 1/4 - 20 1/2” NUT - 16 1/4 - 20 1/2” CARRIA GE BOL T - 16 7/16” (11 MM) WRENCH - 1 HOSE - 1 ...

  • Weber FLAME - page 6

    6 EXPL ODED VIEW 1 2 3 4 5 6 7 8 9 10 11 13 14 15 16 17 26 27 12 19 22 23 24 25 18 28 29 20 21 30 ...

  • Weber FLAME - page 7

    7 EXPL ODED VIEW LIST 1. HOOD VENT 2. 1/4 - 20 X 1/2” C ARRIAGE BOL T 3. SUPPORT BRACKET 4. QUICK -DISCONNEC T HOSE 5. 1/4 - 20 X 1/2” NUT 6. HOOD VENT SUPPORT 7. RAIN SHIELD 8. REAR P ANEL 9. W ASHER 10. 1/4 - 20 X 1/2” KEPS NUT 11. GAS TRAIN ASSEMBL Y 12. WHEEL COVER 13. WHEEL 14. AXLE 15. WHEEL BRACKET 16. IGNITER BO X ASSEMBL Y 17. HUBCAP ...

  • Weber FLAME - page 8

    8 1 2 3 4 ASSEMBL Y 4 ( ) 2 ( )  Hand tighten only .  Hand tighten only . 2 ( )  Hand tighten only . Assembly: Consumer - 40 Minutes. * Professional - 30 Minutes. ...

  • Weber FLAME - page 9

    9 ASSEMBL Y 6 5 4 ( )  Hand tighten only . W arning text on panel faces outward. ...

  • Weber FLAME - page 10

    10 ASSEMBL Y 8 1 2 10  Do not obstruct ignition box. 9  Empty lava rocks onto cardboard packing. Remove small debris.  Do not empty bag of lava rocks directly into the fi replace. Doing so could cause the burner ports to clog. 7 4 ( )  Wrench tighten ALL nuts at this time. ...

  • Weber FLAME - page 11

    11 11 ASSEMBL Y  DANGER Do not operate fi replace untill ALL rain shields have been removed. Failure to do so could result in a fi re or explosion which can cause serious bodily injury or death, and damage to property . 13 12 Always attach rain shields when not in use and for storage. Place ceramic logs in fi replace.  NEVER burn real logs ...

  • Weber FLAME - page 12

    12 GAS INSTRUC TIONS Gas supply Shut off Locking shut off Inside wall Outside wall Quick disconnect 3 / 8 " Pipe nipple 1 / 2 " Pipe nipple Do Not Use This is a typical installation of a Weber ® natural gas fireplace. Local codes may require different installations. INST ALL GAS SUPPL Y General Specifi cations for Piping Note - Contact ...

  • Weber FLAME - page 13

    13 CHECK THA T THE BURNER V AL VE IS OFF V alve is shipped in the OFF position, but you should check to be sure that it is turned OFF . Check by pushing down and turning clockwise. If it does not turn, it is off. Proceed to the next step. If it does turn continue turning it clockwise until it stops, then it is off. Proceed to the next step. CONNEC ...

  • Weber FLAME - page 14

    14 GAS INSTRUC TIONS CHECK F OR GAS LEAKS (1) (5) (2) (3) (4)  DANGER Do not use an open fl ame to check for gas leaks. Be sure there are no sparks or open fl ames in the area while you check for leaks. Sparks or open fl ames will result in a fi re or explosion which can cause serious bodily injury or death and damage to property .  W ARN ...

  • Weber FLAME - page 15

    15 GAS INSTRUC TIONS Check: 1) Bulkhead fi tting-to-Regulator connection.  W ARNING: If there is a leak at connections (1), turn OFF the gas. DO NOT OPERA TE THE FIREPLACE. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www .weber .com ® . 2) Regulator-to-Quick disconnect fi tt ...

  • Weber FLAME - page 16

    16 OPERA TING INSTRUC TIONS LIGHTING Summary lighting instructions are on the control panel. 1. 2. 4. 5. 6. 3.  W ARNING: Check hose before each use of fi replace for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way , do not use the fi replace. Replace using only Weber ® authorized replacement hose. Contact th ...

  • Weber FLAME - page 17

    17 OPERA TING INSTRUC TIONS 1) Remove rain shields. 1. 2. 5. 4. 6. 3. MANU AL LIGHTING  DANGER Failure to remove rain shields while igniting the fi replace’ s burners, or not waiting 5 minutes to allow the gas to clear if the fi replace does not light, may result in an explosive fl ame-up which can cause serious bodily injury or death. 2) M ...

  • Weber FLAME - page 18

    18 TROUBLESHOO TING PROBLEM CHECK CURE Burner burns with a dark orange fl ame, in conjunction with heavy soot- ing. Inspect Spider / Insect Screen for pos- sible obstructions. (Blockage of holes.) Clean Spider / Insect Screen. (See Section “Annual Maintenance”) Burner does not light, or fl ame is low in HIGH position. Is fuel hose bent or kin ...

  • Weber FLAME - page 19

    19 MAINTENANCE WEBER ® SPIDER / INSEC T SCREEN Y our Weber ® gas fi replace, as well as any outdoor gas appliance, is a target for spiders and other insects. They can nest in the venturi section (1) of the burner tube. This blocks the normal gas fl ow , and can cause the gas to fl ow back out of the air shutter . This could result in a fi re, ...

  • Weber FLAME - page 20

    20 MAINTENANCE MAIN BURNER FLAME P A TTERN The Weber ® gas fi replace burner has been factory set for the correct air and gas mixture. A correct fl ame pattern is: • A yellow to light-orange fl ame An incorrect fl ame pattern is: • A dark orange fl ame • Smoke-producing fl ame If the fl ames appear to be darker orange throughout the b ...

Produzent Weber Kategorie Indoor Fireplace

Dokumente, die wir vom Produzenten des Geräts Weber FLAME erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Weber
- Bedienungsanleitungen FLAME
- Produktkarten Weber
- Informationsbroschüren
- oder Energieetiketten Weber FLAME
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Weber FLAME.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Weber FLAME, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Weber FLAME. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Weber FLAME ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Weber FLAME, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Weber FLAME hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Weber FLAME verständlich ist.

Eine gänzliche Bedienungsanleitung von Weber sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Weber FLAME bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Weber FLAME befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Weber FLAME, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Weber FLAME - die uns die ersten Schritte während der Nutzung von Weber FLAME erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Weber FLAME hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Weber FLAME im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Weber FLAME?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Weber FLAME nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Weber FLAME hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)