Bedienungsanleitung iRobot 300

28 Seiten 3.02 mb
Download

Zur Seite of 28

Summary
  • iRobot 300 - page 1

    iRobot ® V er ro ™ O WNER’S MANUAL Model 300 ...

  • iRobot 300 - page 2

    2 iRobot V erro Owner’ s Manual Safety Notes WARNING: Y our cleaner should not be used while people are swimming in the pool. A Ground F ault Current Inter rupter (GFCI) must be installed to protect your electric outlet and prevent an y possible electric shock. The unit must be supplied through a Ground F ault Current Inter rupter outlet. The con ...

  • iRobot 300 - page 3

    www .irobot.com 3 Cautions Please read this manual completely before operating your pool cleaner . Retain the safety and operating instructions for future reference. Do not switch the pool cleaner ON if it is not fully immersed in water . Operating the cleaner out of water will cause se vere damage immediately and will result in loss of warranty . ...

  • iRobot 300 - page 4

    4 iRobot V erro Owner’ s Manual Tips Tip Clean the filter bag regularly . V erro uses the force of the water pumped through its filter bag to move properly . If the filter bag is not k ept clean, V erro will not move or clean properly . Tip Store V erro in a dr y place out of direct sunlight at a temperature between 50 and 104 degrees F ahrenh ...

  • iRobot 300 - page 5

    www .irobot.com 5 T able of Contents Anatom y ..................................................................... 6 - 7 P ar ts List .................................................................... 6 - 7 Using V er ro ................................................................. 8 How V er ro W orks ....................................... ...

  • iRobot 300 - page 6

    6 iRobot V erro Owner’ s Manual Anatom y P ar ts List 1. Cable Grommet 2. Body Assembly 3. Jet T ube Bushing 4. Jet T ube 5. F ilter Screen 6. Pump Motor 7. Axle 8. 6” Wheel 9. W asher 10. Steering Axle Housing 11. Square Foam Float 12. F ilter Bag 13. Foam Float Clip 14. Bottom Lid Assembly 15. Jet V alve P or t 16. Jet V alve Housing 17. Floa ...

  • iRobot 300 - page 7

    www .irobot.com 7 3. P ower (ON/OFF) Switch 4. Time Control Dial 5. Socket (F or Floating P ower Cord) 6. Reset Button Jet V alve Housing Assembly T ime Control Dial 15. Jet V alve P or t 15A. Jet V alve P or t Screw 16. Jet V alve Housing Rear View F ront V iew 1. Fuse Holder 2. P ower Supply cord 16 1 5 A 15 ...

  • iRobot 300 - page 8

    8 iRobot V erro Owner’ s Manual Using V er ro 2 Place V erro upside down in the pool and rock it from side to side to allow air to escape. T urn V er ro o ver and allow it to sink to the bottom of the pool so that the wheels rest on the bottom of the pool. 1 Uncoil the floating pow er cord and spread it over the surface of the water , ensuring t ...

  • iRobot 300 - page 9

    www .irobot.com 9 Using V er ro (cont...) 6 Set the time control dial to 30 seconds. See Adjusting the Time Control Dial, below . 7 T urn the Power Supply switch ON then press the reset button. The light on the P ower Supply will illuminate and V erro will star t to clean your pool. 8 After approximately two hours, V erro will stop and the Power Su ...

  • iRobot 300 - page 10

    10 iRobot V erro Owner’ s Manual Using V er ro (cont...) 12 Use the floating power cord to pull V erro to the edge of the pool, then use the handle to lift it out of the water . W ater will drain from V erro as it is lifted. CAUTION: Removing V erro by its floating pow er cord may cause severe damage to the cord requiring costly repairs. 9 W ai ...

  • iRobot 300 - page 11

    www .irobot.com 11 How V er ro W or ks iRobot V erro uses a powerful motor to dra w 80 gallons of water per minute through the filter bag. This creates strong suction at two inlet por ts under the robot that dra ws dir t and debris, such as bacteria, algae, leaves, and even coins into the filter bag where they are trapped. The pump motor also dri ...

  • iRobot 300 - page 12

    12 iRobot V erro Owner’ s Manual Adjusting the Time Control Dial The time control dial determines how long iRobot V erro tra vels in one direction before stopping and reversing direction. Adjust it so that V erro goes from the waterline on one side of the pool to the waterline on the other side at the widest point, w aiting approximately two seco ...

  • iRobot 300 - page 13

    www .irobot.com 13 Cleaning the F ilter Bag It is ver y impor tant to clean V erro’ s filter regular ly in order to k eep it running at peak efficiency . The fine filter bag can trap par ticles as small as two microns across. (For comparison, the period at the end of this sentence is more than 500 microns across.) These small par ticles can c ...

  • iRobot 300 - page 14

    14 iRobot V erro Owner’ s Manual Cleaning the F ilter Bag (cont...) 4 Remove the filter bag assembly . 5 Remove the filter bag from the suppor t bars. 6 T ur n the filter bag inside out and rinse a wa y any accumulated debris with a hose. Gently agitate and squeeze the bag while rinsing it until the water is clear . If this does not remove all ...

  • iRobot 300 - page 15

    www .irobot.com 15 Maintenance and Adjustment Rinsing V er ro iRobot recommends that you rinse V erro with a garden hose after using it. This will extend the life of the plastic and keep your robot looking good for years to come. Storage Store V erro in a dr y place out of direct sunlight at a temperature between 50 and 104 degrees F ahrenheit. The ...

  • iRobot 300 - page 16

    16 iRobot V erro Owner’ s Manual Maintenance and Adjustment (cont...) Untwisting the Floating P ower Cord V erro is designed to tra vel around your pool in a wa y that reduces any tendency for the cord to become twisted. Howe ver , if the cord tangles or kinks, and will not lie properly on the surface of the water , it may be neces- sar y to untw ...

  • iRobot 300 - page 17

    www .irobot.com 17 Maintenance and Adjustment (cont...) Cleaning the Impeller 1 Unplug the Pow er Supply . (Please keep the plug a wa y from contact with water .) Unplug the floating power cord from the P ower Supply . 2 Remove the scre ws that attach the jet valve por ts. (See Jet V alve Housing Assembly illustration on page 7.) V erro uses an im ...

  • iRobot 300 - page 18

    18 iRobot V erro Owner’ s Manual 6 Using the bent paper clip, hook the material fouling the impeller . It may be helpful to use a small flashlight to see better . 7 Replace the jet valve por t. 8 Replace the screws. ...

  • iRobot 300 - page 19

    www .irobot.com 19 Maintenance and Adjustment (cont...) Cleaning the Jet T ubes V erro uses two powerful jets of w ater like pow er washers to loosen attached dir t and debris as it moves around the pool. If the tubes that carr y these jets from the impeller to the nozzles under the robot become blocked, V erro will not be able to clean as well. If ...

  • iRobot 300 - page 20

    20 iRobot V erro Owner’ s Manual Checking the Flaps in the V acuum Intak es There is a flap just inside each vacuum intake at the bottom of the robot. These flaps must freely open and close. If they do not, remove any dir t or debris that is interfering with their operation. Cleaning the Direction Baffle V erro uses a baffle to redirect the ? ...

  • iRobot 300 - page 21

    www .irobot.com 21 T roubleshooting Problem likely Cause What to Do V erro moves slowly The filter bag needs to be cleaned Flaps in the vacuum intakes at bottom of robot are blocked Wheels or axles are not turning freely The pump impeller is fouled by dirt or debris Clean the filter bag. (p. 13) Check the flaps in the vacuum intakes. (p. 20) Che ...

  • iRobot 300 - page 22

    22 iRobot V erro Owner’ s Manual T roubleshooting (cont...) Problem Likely Cause What to Do V erro reverses direction before reaching end of pool The filter bag needs to be cleaned Time control dial is not set properly Flaps in the vacuum intakes at bottom of robot are blocked Wheels or axles are not turning freely The pump impeller is fouled by ...

  • iRobot 300 - page 23

    www .irobot.com 23 T roubleshooting (cont...) Problem Likely Cause What to Do V erro is not removing attached dir t and debris The filter bag needs to be cleaned Flaps in the vacuum intakes at bottom of robot are blocked The pump impeller is fouled by dirt or debris Jet tube is blocked Clean the filter bag. (p. 13) Check the flaps in the vacuum ...

  • iRobot 300 - page 24

    24 iRobot V erro Owner’ s Manual iRobot Customer Care Please visit our web site at www .irobot.com for suppor t tips, frequently asked questions or information about accessories and other iRobot products. We would like to hear from you. Should you still need assistance, call our customer care representative at 877.855.8593 iRobot Customer Care Ho ...

  • iRobot 300 - page 25

    ...

  • iRobot 300 - page 26

    ...

  • iRobot 300 - page 27

    ...

  • iRobot 300 - page 28

    © 2007 iRobot Corporation, 63 South A venue, Burlington, MA 01803. All rights reserved. iRobot is a registered trademark and Verro is a trademark of iRobot Corporation. Cover photo © V eer Incorporated 2002 - 2005. All rights Reser ved. T o purchase accessories: Call 800.727.9077 or visit our w ebsite at store.irobot.com *See registration card fo ...

Produzent iRobot Kategorie Swimming Pool Vacuum

Dokumente, die wir vom Produzenten des Geräts iRobot 300 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen iRobot
- Bedienungsanleitungen 300
- Produktkarten iRobot
- Informationsbroschüren
- oder Energieetiketten iRobot 300
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung iRobot 300.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen iRobot 300, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen iRobot 300. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts iRobot 300 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts iRobot 300, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von iRobot 300 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von iRobot 300 verständlich ist.

Eine gänzliche Bedienungsanleitung von iRobot sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von iRobot 300 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von iRobot 300 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich iRobot 300, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts iRobot 300 - die uns die ersten Schritte während der Nutzung von iRobot 300 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit iRobot 300 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von iRobot 300 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich iRobot 300?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit iRobot 300 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit iRobot 300 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)