Bedienungsanleitung Cobra Electronics 29 WX NW BT

22 Seiten 1.01 mb
Download

Zur Seite of 22

Summary
  • Cobra Electronics 29 WX NW BT - page 1

    H o w t o U s e Y o u r C o b r a 2 9 W X N W B T Cont ents Fea tures ..................................................................................................1 The CB Story .........................................................................................A1 FCC Regulations FCC W arnings Included Accessories Contr ols & Indicato ...

  • Cobra Electronics 29 WX NW BT - page 2

    Installation Installation Location 3 2 Mounting and Connection Mounting and C onnection Hold the radio with the mounting bracket in the exact desired location. If there is no inter- ference , remo ve the bracket and use it as a template to mark the location f or the mount- ing screws. Location Plan location of transceiv er and microphone bracket be ...

  • Cobra Electronics 29 WX NW BT - page 3

    Installation Installation 5 4 Note Before installing the CB radio , visually check the vehicle’ s battery connection to deter- mine which terminal, positive or negative , is grounded (pos- itive is the larger of the two) to the engine block (or chas- sis). A negatively grounded vehicle has its negative lead grounded to the chassis. Note Connectin ...

  • Cobra Electronics 29 WX NW BT - page 4

    Ignition Noise Interference Antennas Use of a mobile receiv er at low signal lev els is normally limited by the presence of electrical noise. The primary source of noise in automobiles is from the alternator and ignition syst em. T ypically , when signal level is adequate , the back- ground noise does not present a serious problem. Also , when extr ...

  • Cobra Electronics 29 WX NW BT - page 5

    The CB/P A button should be in the CB position. Operation 9 Operation T urning On Setting Channel Selector 8 T urning On Make sure the power cord , antenna and micro- phone are connected to their proper connectors before starting. Setting Channel Selec tor 2 S IG 1 3 5 7 9 +30dB 2 3 CAL RF SWR RF S/RF SWR CAL NB/ ANL ANL OFF CB PA MIN MAX MIN MAX O ...

  • Cobra Electronics 29 WX NW BT - page 6

    NB/ ANL A NL OFF CB PA CH19 C H9 NOR AX MIN MAX O CB WX 29 WX NW RX/TX WX WEA THER RF GAIN M 7 16 25 34 ANT T BACK SWR CAL While holding mic button adjust the SWR CAL knob so the meter needle swings to the CAL ▼ mark on the meter (located on the right). Operation Operation Calibrate For SWR (Standing W ave Ratio) 11 10 continued Note Calibration ...

  • Cobra Electronics 29 WX NW BT - page 7

    Rotate the On/O ff Volume knob clockwise the green RT/TX LED will be illuminated. Repeat the same steps two through fiv e on Channel 1 and 40. This will check SWR for all channels. The S/RF-SWR-CAL switch must be in the S/RF position to read the meter . 6 While still holding down the mic button, set the S/RF SWR CAL switch to the SWR position, to r ...

  • Cobra Electronics 29 WX NW BT - page 8

    Operation Operation Bluetooth ® 15 14 Bluetooth Calls on a Bluetooth enabled cell phone can be rout ed t hrou gh th e 29 WX NW BT speaker or externa l speaker accessor y . C H19 CH9 NOR RX/TX WX A NT T o Pair with a Cell Phone With 29 WX NW BT power On , press and hold the BT But ton for six seconds to ent er Standby mode. A tone will soun d and t ...

  • Cobra Electronics 29 WX NW BT - page 9

    When switched to ANL the Automatic Noise Limiter is activated . This helps reduc e noise created by the v ehicle ’ s elec tronics. When switched to NB/ANL position the RF Noise Blanker is also activated , providing increased noise filtration. When switched to OFF position all noise filtration will be turned off . Operation Operation 17 16 NB-ANL/ ...

  • Cobra Electronics 29 WX NW BT - page 10

    F ull clockwise rotation closes the gate allowing only very strong signals to enter . F ull counter clockwise rotation opens the “ gate ” allowing all signals in. T o achieve the Desired Squelch Setting (DSS), turn the Squelch control counterclockwise until you hear noise . Now turn the control clockwise just until the noise stops. This is the ...

  • Cobra Electronics 29 WX NW BT - page 11

    Setting Dynamike® This controls the microphone sensitivit y (outgoing audio level). T o T ransmit 21 T o T ransmit T ransmit 20 Setting Dynamike ® Caution! Be sure the antenna is properly connected to the radio before transmitting . Prolonged trans- mitting without an antenna, or a poorly matched antenna, could cause damage to the transmitter . B ...

  • Cobra Electronics 29 WX NW BT - page 12

    Operation Operation RF Meter 23 22 External Speaker RF Meter This meter swings propor tionately to the RF output (outgoing signal) while transmitting. External Speaker The external speaker jack is used for remote receiver monitoring. The S/RF-SWR-CAL switch must be in the S/RF position. 1 Note The external speaker should have 8-ohm impedance and be ...

  • Cobra Electronics 29 WX NW BT - page 13

    Operation Operation P A (Public Address) 25 24 P A (Public Addr ess) Connect an external P A speaker to the P A jack on the rear panel. Set CB/P A switch to P A position. Push and hold microphone button and speak in a normal voice . Y our voice will now transmit on the P A speaker . Adjust P A speak er volume with the Dynamik e control. Note Speake ...

  • Cobra Electronics 29 WX NW BT - page 14

    Operation Operation 27 26 W eather Information When CB/WX is on WX position W eather Receiver is ac tivated . Place CB/WX Switch in the WX position. T ur n the W eather Channel Selector (1-7) until you find the W eather Channel with the clear- est reception. S ometimes more than one channel can be received , however , the closest broadcast to you w ...

  • Cobra Electronics 29 WX NW BT - page 15

    T emporary Mobile Set-Up 29 Base Station Operation (From 120V AC House Current) T emporary Mobile Set-Up T emporary Mobile Operation F or temporar y mobile operation you may want to purchase an optional cigarette lighter adapter from your C OBRA dealer . This adapter and a mag- netic mount antenna allow you to quick ly “install” your transceive ...

  • Cobra Electronics 29 WX NW BT - page 16

    How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 31 30 The FCC gives these examples of permitted and prohibited messages for channel 9. These are only guidelines and not all-inclusive: P ermitted Example Message Y es “ T ornado sighted six miles nor th of town.” No “P ost number 10. No tornado sighted .” Y es “Out of gas on I-95 at ...

  • Cobra Electronics 29 WX NW BT - page 17

    How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 33 32 Code M eaning 10-29 Time is up for contact 10-30 Does not conform to FCC rules 10-33 Emergency traffic 10-34 Trouble at this station 10-35 C onfidential information 10-36 C orrect time is 10-37 W recker needed at 10-38 Ambulanc e needed 10-39 Message delivered 10-41 T urn to channel 10-4 ...

  • Cobra Electronics 29 WX NW BT - page 18

    29 WX NW BT Specifications Frequency Ranges 35 34 G ENERAL CHANNELS . . . . . . . . . . . . . . . . . . . . . . . . CB - 40 CH FREQUENCY RANGE CB - 26.965 T O 27.405 MHZ W X - 162.400 TO 162.550 MHZ FREQUENCY T OLERANCE . . . . . . . . . . . 0.005 % FREQUENCY CONTROL . . . . . . . . . . . . PLL (PHASE LOCK LOOP) SYNTHESIZER O PERA TING TEMPERA TURE ...

  • Cobra Electronics 29 WX NW BT - page 19

    Optional Accessories 37 36 C OBRA ELECTRONICS CORPORA TION warrants that its COBRA CB R adios, and the com po nent par ts thereof, will be free of defects in work manship and materials for period of two (2) years from the date of first consumer purchase. This war ran ty may be enforced by the first consumer pur chas er , pro vid ed that the product ...

  • Cobra Electronics 29 WX NW BT - page 20

    39 38 Optional Accessories Ordering From U.S.A. Call 773-889-3087 for pricing or visit www.cobra.com. Fo r C re di t C ar d Or de rs Call 773-889 -3087 [Press one from the main menu] 8:00 a.m. to 5:30 p.m. Central Time, Monday through Friday. Ma ke Ch ec k o r M on e y Or d er Pa ya bl e T o Cobra Electronics, Attn: Accessories Dept., 6500 West Cor ...

  • Cobra Electronics 29 WX NW BT - page 21

    SIG 1 3 5 7 9 +30dB 2 3 CAL RF S WR RF S/RF SWR C AL NB/ A NL ANL O FF CB PA CH19 CH9 N OR M IN MAX MIN MAX OFF VOL SQL C B W X 29 WX NW R X/TX WX WEATHER RF GAIN DYNA DI M 7 16 2 5 3 4 ANT T BACK SWR CAL The Citizens B and lies between the shor twav e broadcast and 10-meter Amateur radio bands, and was established by law in 1949. T he Class D two- ...

  • Cobra Electronics 29 WX NW BT - page 22

    Thank you for purchasing the Cobra 29 WX NW BT CB R adio . Properly used, this Cobra product will give you many years of reliable ser vice. Cust omer Suppor t Should you encounter any problems with the product or not understand its many features, please refer to this owner ’ s manual. If , af ter referring to the manual, you still need help, call ...

Produzent Cobra Electronics Kategorie Car Stereo System

Dokumente, die wir vom Produzenten des Geräts Cobra Electronics 29 WX NW BT erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Cobra Electronics
- Bedienungsanleitungen 29 WX NW BT
- Produktkarten Cobra Electronics
- Informationsbroschüren
- oder Energieetiketten Cobra Electronics 29 WX NW BT
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Cobra Electronics 29 WX NW BT.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Cobra Electronics 29 WX NW BT, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Cobra Electronics 29 WX NW BT. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Cobra Electronics 29 WX NW BT ansehen.

Die komplette Bedienungsanleitung des Geräts Cobra Electronics 29 WX NW BT, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Cobra Electronics 29 WX NW BT hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Cobra Electronics 29 WX NW BT verständlich ist.

Eine gänzliche Bedienungsanleitung von Cobra Electronics sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Cobra Electronics 29 WX NW BT bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Cobra Electronics 29 WX NW BT befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Cobra Electronics 29 WX NW BT, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Cobra Electronics 29 WX NW BT - die uns die ersten Schritte während der Nutzung von Cobra Electronics 29 WX NW BT erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Cobra Electronics 29 WX NW BT hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Cobra Electronics 29 WX NW BT im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Cobra Electronics 29 WX NW BT?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Cobra Electronics 29 WX NW BT nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Cobra Electronics 29 WX NW BT hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)