Deutsch dropdown-ico

Bedienungsanleitung Nuvo NV-T2DF

25 Seiten 3.57 mb
Download

Zur Seite of 25

Summary
  • Nuvo NV-T2DF - page 1

    ...

  • Nuvo NV-T2DF - page 2

    ENGLISH Danger Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably to noise induced hearing loss but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. Government's Occupational Safety and Health Administration (OSHA) has specifie ...

  • Nuvo NV-T2DF - page 3

    GROUND CLAMPS GROUND CLAMPS ELECTRIC SERVICE ENTRANCE ELECTRIC SERVICE ENTRANCE ANTENNA DISCHARGE UNIT NEC SECTION 810-20 GROUNDING CONDUCTORS ANTENNA DISCHARGE UNIT NEC SECTION 810-20 GROUNDING CONDUCTORS GROUND CLAMPS GROUND CLAMPS POWER SERVICE GROUPING ELECTRODE SYSTEM NEC ART 250 P A RT H POWER SERVICE GROUPING ELECTRODE SYSTEM NEC ART 250 P A ...

  • Nuvo NV-T2DF - page 4

    L L OUT AUX IN R R TRIGGER ON=+12V AUDIO OUTPUT TUNER B TUNER A OUT AUDIO OUTPUT RS 232 ANTENNA INPUT IN USE ONL Y NuVo NV-T2P AS POWERED ANTENNA SYSTEM TRIGGER ON=+12V AUX IN Model NV -T2DF Dual XM Tuner NuVo Techonlogies LLC • Cincinnati Ohio USA www.nuvotechnologies.com 3033118 T R E E T K N I CM T R E E T K N I SYSTEM SYS ON EXT . MUTE SYSTEM ...

  • Nuvo NV-T2DF - page 5

    Front P anel 1. Stand-by LED: This LED (Light Emitting Diode) indicates that the T2 is plugged into an AC power source. 2. Remote Sensor: This IR (Infrared) receiver allows wireless remote control of the T2 functions. This IR input is active, even when it is used in conjunction with the direct IR input on the back panel. 3. Frequency and Band Displ ...

  • Nuvo NV-T2DF - page 6

    Back P anel 1. Antenna Input: Coax “F” connector brings in the signal input from the NuVo NV-T2P AS antenna (pg. 10). 2. Aux. Input: This stereo RCA connector is enabled through the advanced menu options (pg. 14), and allows an additional audio source to be connected and accessed through the tuner source selection. 3. Audio Output: A Stereo RCA ...

  • Nuvo NV-T2DF - page 7

    NV-T2RC3 Remote Control 1. P ower: The power button turns the selected tuner on and off . 2. Scroll Buttons: These buttons are the equivalent of turning the front panel Select knob. The top button is the equivalent of turning the knob clockwise, and the bottom button is the equivalent of counterclockwise. 3. Enter: This button is the equivalent of ...

  • Nuvo NV-T2DF - page 8

    I. Installing the NV-T2DF Dual T uner Stereo Audio Connections Each tuner has two audio output jacks. One is a stereo RCA connection, and the other is a stereo 3.5mm mini. The RCA output is an individual left and right channel connection made with a standard RCA cable. The other end is connected to the corresponding audio input on the back panel of ...

  • Nuvo NV-T2DF - page 9

    IR Pass-Thru The mini jack labeled “IR pass-thru" mini connection is used for connecting forwarded IR signals to an audio component connected to the auxiliary audio input. Using the Aux. Input The T2 is equipped with an auxiliary audio input labeled “ AUX IN. ” This will accept an audio signal from an external component. This is most use ...

  • Nuvo NV-T2DF - page 10

    Antenna Input The T2 ships with a proprietary amplified AM/FM antenna. This antenna is designed to work only with the NuV o T2 series tuners. It can be located up to 200 feet from the tuner location, and we recommend 75-ohm RG 6 coaxial cable with a standard F style connector on each end. Simply attach the cable to the connector at the bottom of th ...

  • Nuvo NV-T2DF - page 11

    II. Front P anel Menu Controls The T2 has many settings available in the menus. This allows for many specialized set up options for basic tuner operation. The menu is accessed from the front panel by pressing and holding the “MENU” button. Once in menu mode, you can scroll through the menu options by turning the “Select” knob clockwise (CW) ...

  • Nuvo NV-T2DF - page 12

    The following menu selections are not necessary for standard tuner operation, but do provide a deeper level of control for those who need it. When you scroll to “ Advanced Settings” in the menu, pressing the Select knob then accesses the following menu options: Operating Mode Concerto Source 1-6: This must be set for the appropriate NuV o Conce ...

  • Nuvo NV-T2DF - page 13

    Audio Settings These selections are intended for some stand-alone applications. They should be left at default settings for NuV o audio systems. These systems allow identical audio control on a per-zone basis. Bass EQ: Bass output can be adjusted +12 dB or down to 12 dB. The default setting is flat. This feature is useful for stand-alone use with a ...

  • Nuvo NV-T2DF - page 14

    AUX Input Disable/Enable: The T2 has an auxiliary audio input that allows access through either of the tuners to an additional audio source. T o use this you must first enable the input in the menu options. AUX Gain: The audio input from an auxiliary source can be adjusted to match the output of the T2's T uner A and T uner B. AUX Gain is sele ...

  • Nuvo NV-T2DF - page 15

    III. Stand-alone Front P anel Use of the T2 T uning a Desired Station: Pressing the Select knob cycles through the tuning modes. Step T une Mode: Each of the T2's tuners default to step tune mode. When the Select knob is turned clockwise (CW), the tuner will tune within the preset tuning standard ( see Advanced Menu Settings, Regional Setup, p ...

  • Nuvo NV-T2DF - page 16

    Actual use of these data fields is not regulated, and they may vary significantly in content between stations. If you choose not to have RDS information displayed, pressing the “Display” button will then indicate “RDS receive OFF”. In this state, Stereo indication and a signal strength indicator will replace the PSN field on the top line, a ...

  • Nuvo NV-T2DF - page 17

    IV . Using the T2 with the Concerto NuV oNet Setting Up the T uner for NuVoNet The T2 must be set for one of the Concerto source inputs 1-6. This can be done at the front panel when the tuner is first turned on, in the T2 Configurator software, or through the front panel advanced menu. The best way to utilize the T2 with NuV oNet is to set up the T ...

  • Nuvo NV-T2DF - page 18

    Operating the T2 with the Concerto Display Pad By following the previous steps you should now be able to operate the T2 from any of the Concerto Display P ads. The Concerto Display Pads have secondary tuner functions silk-screened on the bezel below the associated keys. They appear under the appropriate function buttons, fig. 23 Step T une: Basic s ...

  • Nuvo NV-T2DF - page 19

    T2 Configuration Sof tware Basic setup and operation of the T2 is easily done from the front panel, the included T2RC3 remote, or the Concerto Display P ad. The T2 package includes the T2 Configurator setup software designed to quickly move you through the T uners' setup options in a methodical fashion, and allow access to the more advanced se ...

  • Nuvo NV-T2DF - page 20

    2.2 Regional Setup 2. 3 Brightness 2.4 Aut o-On Page 20 2.2 Regional Setup: Depending on your geographic location, the tuner needs to be set for the proper tuning standard. The choices are USA and Canada, W estern Europe, Australia, and New Zealand. Countries outside these geographic locations need the advanced custom setting (see Advanced Settings ...

  • Nuvo NV-T2DF - page 21

    3.3 R ename Bank 3.4 Erase Bank 3.2 Add Bank Page 21 3.2 Add Bank: If you want to add a bank of 10 presets, the “ Add Bank “ button will bring up a window that allows you to name the bank and automatically add it to the T2's presets. 3.3 Rename Bank: This button allows you to give a bank of presets a customized name. 3.4 Erase Bank: All pr ...

  • Nuvo NV-T2DF - page 22

    4.1 C ustom Regional Setup Page 22 4.1 Custom Regional Setup: Some countries operate at a tuning standard outside the four preset regions. The Custom setting allows specific parameters. One determining factor for tuning is the “Pre-emphasis”. The two choices for this a are 50µS (microseconds) and 75µS. The custom setting also allows for speci ...

  • Nuvo NV-T2DF - page 23

    4.5 A UX Input Page 23 4.5 AUX Input: The T2 has an additional input that allows an external device to be controlled through the T2's IR pass through. When this input is enabled, the level of the signal input can be adjusted up or down to match the tuners ' signal output level. 5.0 Advanced Presets The preset tab in the advanced settings ...

  • Nuvo NV-T2DF - page 24

    Page 24 6. 1 Categories T ab 6.2 FM Freqs: This tab lists all the available frequencies within the FM band. When highlighted, the Frequency Information on the right side of the tab allows you to name and categorize each desired frequency in up to four different categories. The Category drop down menus will only display the categories you have turne ...

  • Nuvo NV-T2DF - page 25

    Page 25 7 .2 Successful Download: When the download is complete a final window will appear indicating that all the information has downloaded successfully. Actual download time will vary based on your computer's processing capabilities. 7.2 S uccessful Down load NV-T2DF Specifications FM Section AM Section Tuning Range 87.5 to 108 MHz Tuning R ...

Produzent Nuvo Kategorie Stereo System

Dokumente, die wir vom Produzenten des Geräts Nuvo NV-T2DF erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Nuvo
- Bedienungsanleitungen NV-T2DF
- Produktkarten Nuvo
- Informationsbroschüren
- oder Energieetiketten Nuvo NV-T2DF
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Nuvo NV-T2DF.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Nuvo NV-T2DF, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Nuvo NV-T2DF. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Nuvo NV-T2DF ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Nuvo NV-T2DF, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Nuvo NV-T2DF hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Nuvo NV-T2DF verständlich ist.

Eine gänzliche Bedienungsanleitung von Nuvo sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Nuvo NV-T2DF bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Nuvo NV-T2DF befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Nuvo NV-T2DF, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Nuvo NV-T2DF - die uns die ersten Schritte während der Nutzung von Nuvo NV-T2DF erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Nuvo NV-T2DF hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Nuvo NV-T2DF im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Nuvo NV-T2DF?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Nuvo NV-T2DF nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Nuvo NV-T2DF hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Captcha
Neues Bild

Kommentare (0)