Bedienungsanleitung FMI (V)B42I

20 Seiten 1.47 mb
Download

Zur Seite of 20

Summary
  • FMI (V)B42I - page 1

    For more information, visit www .fmiproducts.com SA VE THIS BOOK This book is valuable. In addition to instructing you on how to install and maintain your appliance, it also contains information that will enable you to obtain re- placement parts or accessory items when needed. Keep it with your other important papers. This replace is approved fo ...

  • FMI (V)B42I - page 2

    www .fmiproducts.com 109036-01M 2 SAFETY W ARNING: Do not install a replace insert in this box unless the manufacturer's instructions with the insert specically state this replace has been tested for use with this insert. FOR YOUR SAFETY • Do not store or use gasoline or any other ammable vapors or liquids in the vicinity of this ...

  • FMI (V)B42I - page 3

    www .fmiproducts.com 109036-01M 3 SPECIFICA TIONS 0" TO BOTTOM OUTSIDE AIR (LEFT SIDE ONL Y) TOP SP ACERS 3/4" AIR SP ACE BACK AND SIDES HEARTH EXTENSION 66" X 20" 12" EACH SIDE 1" AIRSP ACE TO COMBUSTIBLE COMBUSTIBLE WALL BOARD 0" TO MA TERIAL NO COMBUSTIBLE MA TERIA L ON FACE GAS LINE KNOCK OUT AIR KIT KNOCK OUT ...

  • FMI (V)B42I - page 4

    www .fmiproducts.com 109036-01M 4 FIREPLACE INST ALLA TION SELECTING LOCA TION T o determine safest and most efcient location for replace, you must take into consideration the following guidelines: 1. Location must allow for proper clearances (see Figures 1 and 2). 2. Consider a location where replace will not be affected by drafts, air co ...

  • FMI (V)B42I - page 5

    www .fmiproducts.com 109036-01M 5 HEARTH EXTENSION A hearth extension projecting a minimum of 20" in front of and a minimum of 12" beyond each side of replace opening is required to protect combustible oor construction in front of replace. Fabricate a hearth extension using a material which meets the following specications: a ...

  • FMI (V)B42I - page 6

    www .fmiproducts.com 109036-01M 6 FIREPLACE INST ALLA TION Continued Figure 4 - Mantel Clearances to Combustible Material Electrical Bushing Electrical Cover Plate Rocker Switch Figure 6 - Fan Switch-Electrical Bushing Electrical Housing Wire Nut (3x) (Not Supplied) Outer Wrapper of Fireplace Electrical Cover Plate and Electrical Bushing Fireplace ...

  • FMI (V)B42I - page 7

    www .fmiproducts.com 109036-01M 7 Figure 8 - Lineal Gain Hemmed End 8" Stainless Inner Pipe 12 3 / 8 " Galvanized Outer Pipe Figure 7 - Outside Air Kit Secure to Collars with Metal T ape, Screws or Straps (Min. of 1/4" x 20" in size) Air Inlet Location Must Allow For Bushes or Snow V ent Hood Required for W all Installation Air ...

  • FMI (V)B42I - page 8

    www .fmiproducts.com 109036-01M 8 VENTING INST ALLA TION Continued Figure 9 - T ypical Offset Installation Return Elbow Offset Elbow Return Elbow Offset Elbow 6' Max. 6' Max. 6' Max. 6' Max. 6' Max. 6' Max. Return Elbow Offset Elbow Offset Elbow Return Elbow A B C Offset Elbow Ceiling Support Pipe 12S-8DM Return Elbow ...

  • FMI (V)B42I - page 9

    www .fmiproducts.com 109036-01M 9 Figure 1 1 - Elbow Offset B A Screws Figure 10 - Ceiling Support Pipe 12S-8DM OFFSET RISE CHIMNEY LENGTH A B 48" 36" 24" 18" 12" 4 3 / 8 " 16 3 / 8 " ELBOW SET ONL Y 9 3 / 4 " 25 1 / 2 " 1 12 3 / 4 " 30 3 / 4 " 1 15" 34 3 / 4 " 1 18" 40" 1 1 ...

  • FMI (V)B42I - page 10

    www .fmiproducts.com 109036-01M 10 VENTING INST ALLA TION Continued Pitch Slope Opening "A" Max. Used Flashing Model No. Flat 0° 15" V6F-8DM 0-6/12 26.6° 16 1 / 8 " V6F-8DM 6/12- 12/12 45.0° 20 3 / 8 " V12F-8DM 4. Remove shingles around opening mea - sured. Cut out this section. 5 . Add next sections of pipe until end pe ...

  • FMI (V)B42I - page 11

    www .fmiproducts.com 109036-01M 11 Nail Only Outer Perimeter of Flashing Storm Collar Underlap Shingles at Bottom Overlap Shingles T op and Sides Only Figure 15 - Flashing Installation Figure 16 - Storm Collar Chimney Pipe W aterproof Caulk Storm Collar Flashing Storm Collar Installation (SC1) Place storm collar over pipe and slide down until it is ...

  • FMI (V)B42I - page 12

    www .fmiproducts.com 109036-01M 12 10' 2' Min. 10' 3' Min. 2' Min. 3' Min. Level of Flue Gas Outlet Figure 19 - 10 Foot Rule 10 FOOT RULE All ue gas outlet chimney terminations must extend a minimum of 3 feet in height above highest point where it passes through roof and must be at least 2 feet above highest point o ...

  • FMI (V)B42I - page 13

    www .fmiproducts.com 109036-01M 13 OPTIONAL GAS LINE INST ALLA TION Figure 21 - Gas Line Knockout Side Firebrick Finished Side Refractory Knockout Plug Outside of Fireplace Gas Line Conduit Insulation Gas Conduit Cover 1/2" Dowel Gas line hook up should be done by your supplier or a qualied service person. Note: Before you proceed, make sur ...

  • FMI (V)B42I - page 14

    www .fmiproducts.com 109036-01M 14 OPTIONAL GAS LINE INST ALLA TION Continued W ARNING: If the replace has been used for wood burn- ing, rebox and chimney must be cleaned of soot, creosote and ashes be a qualied chimney cleaner . Creosote will ignite if heavily heated. OPERA TION AND MAINTENANCE Figure 23 - Glass Doors Cleaning Glass Clean ...

  • FMI (V)B42I - page 15

    www .fmiproducts.com 109036-01M 15 Figure 24 - Damper Handle Location OPERA TION AND MAINTENANCE Continued DAMPER HANDLE OPERA TION Damper handle, which opens and closes damper blade, is located inside rebox at center towards back w all (see Figure 24). Pushing handle back into keyway slot will free damper blade to automatically open. T o close, ...

  • FMI (V)B42I - page 16

    www .fmiproducts.com 109036-01M 16 P ARTS WOOD BURNING FIREPLACE MODELS (V)B42, (V)B42I, (V)B42L, (V)B42LI 11 27 30 23 22 24 10 14 25 4 17 3 2 1 5 20 28 12 7 15 9 16 13 8 26 6 29 19 18 21 ...

  • FMI (V)B42I - page 17

    www .fmiproducts.com 109036-01M 17 P ARTS WOOD BURNING FIREPLACE MODELS (V)B42, (V)B42I, (V)B42L, (V)B42LI This list contains replaceable parts used in your replace. When ordering parts, see Replace- ment Parts on page 15 of this manual. KEY NO. P ART NO. DESCRIPTION QTY . 1 ** Insulation Pan • • 1 2 ** Air Separator • • 1 3 ** Firebox T ...

  • FMI (V)B42I - page 18

    www .fmiproducts.com 109036-01M 18 ROOF FLASHING 0 TO 6/12 PITCH - V6F-8DM 6/12 TO 12/12 PITCH - V12F-8DM ACCESSORIES DOUBLE W ALL PIPE 12-8DM 12-8HT 18-8DM 18-8HT 24-8DM 24-8HT 36-8DM 36-8HT 48-8DM 48-8HT ANTI-DRAFT SHIELD (Round T op T ermination Only) ADS-8DM 30° OFFSET AND RETURN 30E-8DM ADJUST ABLE HOOD Antique Brass Finish - GA6053 Black Pai ...

  • FMI (V)B42I - page 19

    www .fmiproducts.com 109036-01M 19 F AN KIT - BK3 BLOWER KIT - BK OUTSIDE AIR KIT FOR SIDE W ALL INST ALLA TION - AK4 OUTSIDE AIR KIT FOR FLOOR INST ALLA TION AK4F ACCESSORIES Continued SQUARE TOP TERMINA TION WITH LOUVERS ET -8DM, ET -8HT SQUARE TOP TERMINA TION WITH LOUVERS AND SLIP SECTION ETL-8DM, ETL-8HT MESH SQUARE TOP TERMINA TION ETO-8DM ME ...

  • FMI (V)B42I - page 20

    109036-01 Rev . M 03/1 1 2701 S. Harbor Blvd. Santa Ana, CA 92704 1-866-328-4537 www .fmipr oducts.com ...

Produzent FMI Kategorie Indoor Fireplace

Dokumente, die wir vom Produzenten des Geräts FMI (V)B42I erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen FMI
- Bedienungsanleitungen (V)B42I
- Produktkarten FMI
- Informationsbroschüren
- oder Energieetiketten FMI (V)B42I
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung FMI (V)B42I.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen FMI (V)B42I, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen FMI (V)B42I. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts FMI (V)B42I ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts FMI (V)B42I, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von FMI (V)B42I hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von FMI (V)B42I verständlich ist.

Eine gänzliche Bedienungsanleitung von FMI sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von FMI (V)B42I bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von FMI (V)B42I befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich FMI (V)B42I, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts FMI (V)B42I - die uns die ersten Schritte während der Nutzung von FMI (V)B42I erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit FMI (V)B42I hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von FMI (V)B42I im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich FMI (V)B42I?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit FMI (V)B42I nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit FMI (V)B42I hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)